Free to read · free account to contributeSuccessor to Anticars (2000)

Ford Probe

1988–1997 · 2 generations · 24 documented defects · 1 markets
Generations
Model year
MarketAllJPNA
Probe II (1993) · 1992–1997
RecallModerateEngineJP

Other (Fuel System)

The inner pipe fitted into the outer pipe of the fuel filler neck may have an improperly positioned weld, so that in some cases the inner pipe interferes with the seal of the fuel filler cap. If the vehicle continues to be used in this condition, the airtightness between the filler cap and the outer pipe will be compromised, and in the worst case, fuel evaporative gas may be released into the atmosphere from that area.

MLIT · JapanOct 13, 19991207600Model years 1995–1996Auto-translated · original: JapaneseView details →
Probe II (1993) · 1992–1997
RecallModerateEngineNA

Emissions

Certain vehicles may not comply with the requirements of CMVSS 1105 - Evaporative Emissions. Fuel vapour may leak from between the fuel cap and the fuel filler pipe. Correction: Filler cap will be replaced with one that incorporates an o-ring that will positively seal the suspect fuel filler pipes.

Transport CanadaJul 26, 19991999134Model years 1995–1997View details →
Probe II (1993) · 1992–1997
RecallModerateEngineNA

Engine

On certain vehicles, an external spring in the timing belt auto tensioner may break. The broken spring may get caught in the timing belt, resulting in possible engine stalling. Correction: Vehicles will be inspected and affected tensioners will be replaced.

Transport CanadaNov 16, 19981998225Model years 1997View details →
Probe II (1993) · 1992–1997
RecallModerateEngineNA

Engine and engine cooling:Engine

Vehicle description: Passenger vehicles. An external spring in the timing belt tensioner can break and get caught in the timing belt.

NHTSA · United StatesNov 3, 199898V206002Model years 1997View details →
Probe I (1989) · 1988–1992
RecallModerateEngineNA

Emissions

Compliance testing indicates that these vehicles may be releasing carbon monoxide (co) emissions which exceed the requirements of c.M.V.S.S. 1103 - exhaust emissions. Correction: Catalytic converter will be replaced on affected vehicles.

Transport CanadaFeb 27, 19951995038Model years 1990View details →
Probe I (1989) · 1988–1992
RecallModerateEngineNA

Emissions

Note: Superseded by 95038. These vehicles may not comply with c.M.V.S.S 1103 - exhaust emissions. Catalysts may be releasing emissions in excess of the standard. Correction: Exhaust system catalysts will be replaced on affected vehicles.

Transport CanadaFeb 16, 19951995027Model years 1990View details →
Probe I (1989) · 1988–1992
RecallModerateEngineNA

Emissions

Note: Vehicles with 3.0 litre engine. These vehicles may not comply with c.M.V.S.S. 1103 - exhaust emissions. Throttle position sensor may wear prematurely causing interruption of the sensor signal. Correction: Throttle position sensor will be inspected and replaced if necessary.

Transport CanadaAug 21, 19921992100Model years 1990–1991View details →
Probe I (1989) · 1988–1992
RecallModerateEngineNA

Emissions

Vehicles with 3.0l engines and automatic transmissions only. These vehicles do not comply with c.M.V.S.S 1103 - exhaust emissions. Carbon monoxide levels exceed standard. Correction: Dealers will replace the electronic engine control (eec) processor and attach two decals.

Transport CanadaOct 29, 19911991145Model years 1990View details →
Probe I (1989) · 1988–1992
RecallModerateEngineNA

Engine

Vehicles with 3 litre engines may have throttle levers that were bent during vehicle assembly. If this condition exists, there is a potential that the throttle may stick and not return fully to the idle position. This could cause possible loss of vehicle control. Correction: Vehicles will be inspected and if necessary, the intake manifold assembly will be replaced.

Transport CanadaSep 28, 19891989133Model years 1990View details →
Probe I (1989) · 1988–1992
Probe I (1989) · 1988–1992Probe II (1993) · 1992–1997
RecallMinorEngineJP

排気管

車体の中央下部にある副消音器後部の排気管接合部に溶接不良のものがあるため、そのま まの状態で使用を続けると、当該溶接部位に亀裂が発生し、そこから排気ガスが漏れると ともに、騒音が増大するおそれがある。

MLIT · JapanMar 27, 19971206330Model years 1992–1993Shown in the original Japanese · translation pendingView details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).