Bulletin
Revised oil pump installation procedure. Yd
🔔 Create a free account to get email alerts about Ford Probe (all generations)
Service bulletins (TSBs) are repair instructions manufacturers send to their dealers about known problems. They are not safety recalls, but they often confirm a defect.
Revised oil pump installation procedure. Yd
Procedure for brake warning indicator stays on red in cluster. *tt
Procedure for brake exterior lights stay on (tail & high mount stop light). *tt
Improper rtv application at the front/rear lower intake manifold end seals & side gaskets may cause an oil/coolant leak. *tt
Concerns for the labor time standard in tbs 96-19-02 (steering - grunt noise during steering wheel return from full right turn) is incorrect. *tt
Information for when diagnosing concerns w/ factory installed cellular phones. *tt
Concern for vehicles exhibiting lean codes p0171 & p0174 (vacuum leak). *tt
Information to diagnose wind noise & water leaks at the lower passenger door area & 3rd door. *tt
Concerns of a/c going to defrost mode when climbing grades or accelerating are likely caused by vacuum leaks. *tt
Engine oil leak at the oil pan, front cover &/or the front & rear crankshaft oil seal. *tt
Information on correcting an oil pan gasket leak. *tt
An oil leak in the area of the engine oil filter may be caused by a damaged or mis-installed (i.E. Rolled over, pinched, sheared, nicked, etc.) oil pump body seal. *tt
For concerns of stalling, reflash pcm w/ 1996 calibration (r11 level). *tt
Information on brake rotor turning/replacing. *tt
Revised rear brake lining for both 9 inch & 10 inch applications for concerns w/ rear brake grab during the first few brake applications when the brakes are cold or in the morning after an overnight rain. *tt
Some vehicles with a p0421 code stored in the powertrain control module (pcm) may not be able to identify the calibration when reprogramming. *ak
Some vinyl covered items such as dash panels, door trim panels, consoles, etc., may exhibit a small dent, scuff, abrasion and/ or discoloration resulting from assembly, transit, dealer prep and/or customer usage. *yc
Repairs to vinyl covered surfaces. *yc
Service tips for surface defect removal without repainting. *yc
Subject regarding malfunction indicator lamp (mil) illuminated with diagnostic trouble code (dtc) p0505. *yc
Safety recall 96s48/96s99 - announcement of improved parts availability for probe motorized seat belt repair. *tw
The malfunction indicator lamp (mil) on with code p0441 stored in memory. *jd
Mil code - p0421 - do not attempt repairs. *tw
Beginning december 2, 1996 all cd4e transaxles are built with a redesigned pump body separator plate and pump body separator plate gasket. *jd
A clunk on left hand turns while accelerating. This may be caused by improper alignment of the #1 engine mount. *jd
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).