Vehicle description: Passenger vehicles equpped with the "california" emissions package. An incorrect transmission oil cooler line was installed. The line contacts the anti-lock braking system module support bracket and over time, can wear and develop a leak.
NHTSA · United StatesNov 9, 199898V288000Model years 1999View details →
Vehicles that were serviced for a stall condition between august 1, 1997 and december 1, 1997 may have received and incorrect fuel tank. The incorrect tank contains an additional vent hole which provides the potential for a fuel leak. Correction: Vehicles will be inspected and fuel tank will be replaced with the correct tank if necessary.
Transport CanadaJun 4, 19981998114Model years 1996View details →
Vehicle description: Passenger vehicles previously serviced under ford service bulletin 97-17-9 from august 1997 through december 1997. These vehicles were inadvertenly equipped with an 18-gallon fuel tank rather than the 16-gallon as specified. The 18-gallon tank has a second valve location where a shipping plug should be installed.
NHTSA · United StatesMar 25, 199898V067000Model years 1996View details →
Vehicle description: Passenger vehicles equipped with ax4s automatic transaxles. The low/intermediate servo cover can separate from the transaxle while the vehicle is being driven. If this occurs, transmission fluid will leak contacting the catalytic converter.
NHTSA · United StatesJun 9, 199797V097000Model years 1997View details →
On certain Taurus SHO, the fuel pressure regulator diaphragm may rupture. Should this occur, engine damage or fuel leakage could result. Fuel leakage in the presence of an ignition source could potentially result in a fire. Correction: Vehicles will be inspected and fuel pressure regulators will be replaced where required.
Transport CanadaAug 22, 19961996124Model years 1996View details →
The fuel pressure regulator located on the fuel rail in the engine compartment has a vacuum diaphragm that was damaged during manufacture of the regulator.
NHTSA · United StatesAug 12, 199696V151000Model years 1996View details →
On certain passenger vehicles originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia, the front coil springs could fracture due to corrosion associated with salt used on the roadways during the winter. A fractured spring could move past the spring seat and contact a front tire.
NHTSA · United StatesJul 15, 200404V332000Model years 1999View details →
○ 건설교통부는 포드세일즈서비스코리아에서 수입·판매한 토러스 승용차에 제작결함이 발생하여 자발적인 리콜을 실시한다고 밝혔다.
○ 금번의 리콜사유는 악셀레이터 페달과 브레이크 페달 간격이 포드 자동차의 자체규정(사규) 보다 좁게 제작되어 브레이크 페달이나 악셀레이터 페달을 작동시 두 개의 페달을 동시에 밟을 수가 있는 결함으로서,
- 결함시정대상 자동차는 '99. 5. 3부터 '01. 9.14까지 생산되어 국내에 수입·판매된 177대로서 결함시정기간은 오는 11.18일부터 1년간 포드세일즈서비스코리아의 직영 A/S사업소 및 지정정비공장에서 무상으로 점검 수리하는 리콜을 실시한다고 밝혔다.
※ A/S센타 문의전화 (☎ 02-2216-1100)
MOLIT · South KoreaNov 18, 200261Model years 1999Shown in the original Korean · translation pendingView details →
The crimped portion of the fuel hose clamp and the fuel pump in the fuel tank is improperly positioned. If use continues in this condition, vibration during driving may cause the crimped portion to interfere with the fuel pump's electrical wiring, damaging the wiring and causing a short circuit, which may result in the engine stalling.
Vehicle description: Passenger vehicles. The seat belt retractor may have a pin shaft in the switchable elr/alr mechanism that is incorrectly formed. In some circumstances, the switching mechanism could become nonfunctional, preventing the seat belt webbing from being extracted from the retractor. It is also possible that malfunction of the mechanism could prevent the belt from being switched into the alr mode. The elr mechanism is not affected by this condition.
NHTSA · United StatesSep 20, 199999V250000Model years 1999View details →
The dash insulator retainer may not have been fully engaged. The retainer may disengage, and in some cases it could become lodged above the accelerator pedal pivot. This could prevent the engine from fully returning to idle. Correction: Vehicles will be inspected for proper installation of the dash insulator retainer and re-install if required.
Transport CanadaSep 18, 19981998182Model years 1999View details →
Vehicle description: Passenger vehicles. A dash insulator retainer clip was not fully assembled to the accelerator cable dash fitting. The clip can disengage from the accelerator cable and fall into the accelerator pedal arm pivot area.
NHTSA · United StatesSep 1, 199898V204000Model years 1999View details →
These vehicles may have a front seat belt buckle attaching stud that may have been improperly heat treated. This heat treating may have resulted in cracks developing in the stud. If the stud is cracked, there is the potential for less than the intended level of occupant restraint in the event of a vehicle crash. Correction: Seat belt buckle mounting bracket and stud assembly will be replaced on affected vehicles.
Transport CanadaAug 28, 19981998173Model years 1998–1999View details →
Vehicle description: Passenger vehicles equipped with manual seat tracks. The front seat belt buckle attaching stud may have been improperly heat treated. This heat treatment may have resulted in cracks developing in the stud.
NHTSA · United StatesAug 25, 199898V198000Model years 1998–1999View details →
These vehicles do not comply with c.M.V.S.S. 108 - lighting system and retroreflective devices. The headlight aiming instructions provided in the owner guides are not sufficiently clear. Correction: Revised owner guides will be mailed to owners.
Transport CanadaMar 26, 19981998050Model years 1997–1998View details →
Vehicle description: Passenger vehicles. The text and/or graphics for the vehicle headlamp aiming instructions provided in the owner guides are not sufficiently clear. This does not meet the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment."
NHTSA · United StatesFeb 10, 199898V028000Model years 1997–1998View details →
The gap between the grip of the parking brake lever and the brake release button at the tip of the grip is small, so when the parking brake lever is operated, the brake release button may not return, and the parking brake may fail to engage.
Note: Flexible fuel vehicles. A seal for the fuel delivery module wiring harness connector may swell in the presence of unleaded fuel and force the connector apart creating an open circuit. This would result in loss of fuel pump operation and fuel pressure. In addition, the vapour control valves, located on the fuel tank may not operate properly resulting in vapour emissions in excess of the standard. Correction: Wiring connector seal and fuel tank vapour vent valve assembly will be replaced.
Transport CanadaMar 10, 19971997047Model years 1996View details →
Some sliding shafts (pins) that form part of the linkage from the shift lever to the automatic transmission do not move smoothly. As a result, when the shift lever is operated to the Park position, the pawl may fail to engage with the parking gear, and the vehicle may not be held stationary.
The automatic transaxle park mechanism may not prevent the vehicle from rolling even if the transaxle shift lever is firmly placed in the "park" position. If the driver is unaware that the park mechanism of the transaxle has not properly engaged and leaves the vehicle unattended without setting the parking brake, the vehicle could be free to roll as if in neutral. This could result in a crash without prior warning. Correction: Park mechanism will be inspected and, if necessary, a new park pawl shaft will be installed in the transaxle.
Transport CanadaSep 20, 19961996148Model years 1996View details →
The automatic transmission park pawl shaft may not be free to rotate as intended. If the park pawl shaft does not rotate, it would prevent the park pawl from engaging the park gear when the shift lever is in the park position.
NHTSA · United StatesSep 18, 199696V176000Model years 1996View details →
The park pawl abutment bracket has a sharp edge which may cause the parking pawl to hang up and not engage the park gear. This may cause the vehicle to move even though the gear shift indicator shows that the vehicle is in park. As a result, unintended and unexpected vehicle movement could occur with the possibility of personal injury and property damage. Correction: Dealers will inspect and, if necessary, replace the park pawl abutment bracket on affected vehicles.
Transport CanadaSep 13, 19961996135Model years 1996–1997View details →
The park pawl abutment bracket has a sharp edge which can cause the parking pawl to hang up and not engage the park gear. This would allow the vehicle to move even though the gear shift indicator shows that the vehicle is in park.
NHTSA · United StatesSep 5, 199696V166000Model years 1996–1997View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).