Free to read · free account to contributeSuccessor to Anticars (2000)

GMCGMC Sonoma

1981– · 3 generations · 32 documented defects · 2 markets
Generations
Model year
MarketAllNA
Sonoma II (1994) · 1993–2004
RecallCriticalBodyNA

Electrical system:Wiring:Front underhood

Vehicle description: Light duty pickup trucks and multi-purpose vehicles. An engine electrical wiring-harness clip can melt and drip onto the exhaust manifold.

NHTSA · United StatesNov 25, 199797V208001Model years 1998View details →
Sonoma II (1994) · 1993–2004
RecallCriticalBrakesNA

Service brakes, hydraulic:Foundation components:Hoses, lines/piping, and fittings

Vehicle description: Light duty pickup trucks and multi-purpose passenger vehicles. A fatigue fracture of the rear axle right-hand brake pipe can occur causing a slow brake fluid leak resulting in a soft brake pedal. If the brake pipe breaks, the driver would experience a sudden drop in the brake pedal, the instrument panel brake light would illuminate, and there would be a loss of rear brake performance.

NHTSA · United StatesNov 24, 199797V218000Model years 1998View details →
Sonoma II (1994) · 1993–2004
RecallCriticalEngineNA

Engine

On certain vehicles, the engine wiring harness clip could melt and drip onto the exhaust manifold. The clip material on the exhaust manifold could ignite and subsequently ignite other combustible components in the immediate vicinity resulting in a vehicle fire without prior warning. Correction: Electrical wiring harness will be rerouted.

Transport CanadaNov 18, 19971997201Model years 1998View details →
Sonoma I (1982) · 1981–1993
RecallCriticalEngineNA

Fuel system, gasoline:Storage:Tank assembly:Filler pipe and cap

The fuel tank filler pipes were not manufactured to specification which caused loss of fuel between the fuel tank filler pipe and the vent tube during a test. The loss of fuel was in excess of the amount permitted by fmvss no. 301, "fuel system integrity."

NHTSA · United StatesJan 26, 199494V014000Model years 1994View details →
Sonoma I (1982) · 1981–1993
RecallCriticalBodyNA

Visibility:Windshield

Use of improper primer on metal surfaces of windshield and side window openings could cause low adhesion to the metal surface and would not provide retention required by fmvss 212.

NHTSA · United StatesJun 4, 199090V107000Model years 1991View details →
Sonoma I (1982) · 1981–1993
Sonoma I (1982) · 1981–1993
RecallCriticalBrakesNA

Service brakes, hydraulic:Foundation components:Drum:Wheel cylinders

Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid. Consequence of defect: A loss of brake fluid leads to loss of rear brake action, creating the potential for an accident. Front brakes would remain operational.

NHTSA · United StatesApr 29, 198585V048000Model years 1982View details →
Sonoma II (1994) · 1993–2004
RecallModerateBodyNA

Other

Certain vehicles (not involved in recall 98-150), may experience a windshield wiper failure due to cracked solder joints on the controller circuit board. If this were to occur in a severe weather situation, driver's visibility could be reduced, which could result in a vehicle crash without prior warning. Correction: Dealer will replace defective wiper motor until 7 years or 112 000 km from date vehicle was originally placed into service or for those vehicles currently outside of this coverage, until March 31 2004.

Transport CanadaMar 17, 20032003064Model years 1997View details →
Sonoma II (1994) · 1993–2004
RecallModerateElectricalNA

Exterior lighting

Vehicle description: Light duty pickup trucks and sport utility vehicles. These vehicles fail to comply with the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment." the daytime running lights built with a candela value greater than 3,000 cannot be mounted higher than 864mm above the road surface.

NHTSA · United StatesAug 11, 200000V220000Model years 1998View details →
Sonoma II (1994) · 1993–2004
RecallModerateInteriorNA

Seat belts

Vehicle description: Passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."

NHTSA · United StatesAug 7, 200000V228003Model years 2001View details →
Sonoma II (1994) · 1993–2004
RecallModerateBrakesNA

Service brakes, hydraulic:Antilock/traction control/electronic limited slip

Vehicle description: Light duty pickup trucks equipped with 4-wheel disc brakes. Some of these vehicles have an antilock brake system (abs) motor containing an out-of-specification spring clip. This clip could allow the motor bearing to become misaligned. If misalignment occurs, eventually the abs would be non-functional.

NHTSA · United StatesFeb 28, 200000V055000Model years 2000View details →
Sonoma II (1994) · 1993–2004
RecallModerateBrakesNA

Service brakes, hydraulic:Antilock/traction control/electronic limited slip

Vehicle description: S -trucks equipped with 2 wheel drive. These vehicles may have had the right-hand antilock brake system (abs) module feed pipe and/or brake crossover pipe tube nuts tightened without seating the pipe-flared-ends enough to withstand normal assembly and vehicle inputs without partially unseating. This does not comply with requirements of fmvss no. 105, "hydraulic service brake normal, emergency, and park braking performance."

NHTSA · United StatesAug 11, 199999V220000Model years 2000View details →
Sonoma I (1982) · 1981–1993Sonoma II (1994) · 1993–2004
RecallModerateBrakesNA

Service brakes, hydraulic:Antilock/traction control/electronic limited slip

Vehicle description: Certain 4-wheel drive pickup trucks and sport utility vehicles equipped with abs (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the abs system whether the vehicle is in 2-wheel or 4-wheel drive can malfunction causing increased stopping distances during abs stops while in the two-wheel drive mode.

NHTSA · United StatesJul 19, 199999V193000Model years 1991–1996View details →
Sonoma II (1994) · 1993–2004
RecallModerateBodyNA

Visibility:Windshield wiper/washer

Vehicle description: Light duty pickup trucks and sport utility vehicles, 2 and 4-wheel drive. Solder joints near the wiring harness connector can crack causing the windshield wipers to work intermittently.

NHTSA · United StatesJul 1, 199898V150001Model years 1995–1996View details →
Sonoma II (1994) · 1993–2004
RecallModerateBrakesNA

Brakes

Certain vehicles may exhibit a fatigue fracture of the rear axle, right-hand brake pipe. Should the pipe crack a slow brake fluid leak would result causing a soft pedal and an eventual decrease in rear braking capability. Should the pipe break there would be a sudden drop in the brake pedal and a loss of rear brake performance. Correction: A brake pipe bracket will be installed on affected vehicles.

Transport CanadaNov 28, 19971997217Model years 1998View details →
Sonoma II (1994) · 1993–2004
Sonoma II (1994) · 1993–2004
RecallModerateBrakesNA

Brakes

On certain vehicles, the front brake pipe may contact the left-hand side of the engine oil pan. This contact could cause the brake pipe to wear through to the point of brake fluid loss during brake application. This could reduce braking effectiveness and increase stopping distances. Correction: Vehicles will be inspected and an additional brake pipe clip will be installed if required. If there was contact between the oil pan and the brake pipe, the brake pipe will be replaced.

Transport CanadaSep 9, 19971997154Model years 1996–1997View details →
Sonoma II (1994) · 1993–2004
RecallModerateInteriorNA

Seats And Restraints

On certain vehicles, the driver's and/or passenger's front outboard seat-belt webbing could separate during a frontal impact having at least the same dynamics as a 48 kph frontal barrier collision. If a separation occurred and there were secondary crash events or rollover, there would be no restraint of the occupant and increased injuries could occur. Correction: A protector cover will be installed over the recliner mechanism.

Transport CanadaSep 8, 19971997152Model years 1994–1997View details →
Sonoma II (1994) · 1993–2004
RecallModerateInteriorNA

Seat belts

Vehicle description: Extended cab pickup trucks equipped with 60/40 front bench seats and extended cab pickup trucks and 2-door utility vehicles equipped with manual locking recliner bucket seats. The outboard safety belt webbing on the driver's and/or passenger's seat can separate during a frontal impact.

NHTSA · United StatesJun 12, 199797V096001Model years 1994–1997View details →
Sonoma II (1994) · 1993–2004
RecallModerateEngineNA

Emissions

Certain vehicles may not comply with CMVSS 1105 - Evaporative Emissions. Fuel injectors may exhibit leakage of fuel vapour due to a stress of the plastic encapsulant. Correction: fuel injectors on affected vehicles will be inspected for involved date codes and replaced if necessary.

Transport CanadaJun 20, 19961996094Model years 1996View details →
Sonoma II (1994) · 1993–2004
RecallModerateGearboxNA

Powertrain

On certain vehicles, the transmissions may contain parts which are not machined to specification. These transmissions could seize and lock the rear wheels while the truck is being operated. This could result in loss of vehicle control and a possible crash without prior warning. Correction: Dealers will inspect the transmission main shaft output torque and of the torque does not meet the specification criteria, the transmission will be replaced.

Transport CanadaFeb 28, 19961996040Model years 1996View details →
Sonoma II (1994) · 1993–2004
RecallModerateGearboxNA

Power train:Manual transmission

Some of these trucks were built with transmissions containing parts which were not machined to gm's specifications.

NHTSA · United StatesFeb 22, 199696V035000Model years 1996View details →
Sonoma I (1982) · 1981–1993
Sonoma II (1994) · 1993–2004
RecallModerateGearboxNA

Power train:Automatic transmission

Significant wear can develop on the low and reverse clutch preventing the park pawl from engaging. This can prevent a "no park" condition to occur while the engine is running, causing unintentional movement of the vehicle without operator action. (the "no park" condition will not occur while the engine is off.)

NHTSA · United StatesMay 16, 199494V093000Model years 1993View details →
Sonoma II (1994) · 1993–2004
RecallModerateEngineNA

Fuel System

Certain vehicles do not comply with CMVSS.301- Fuel System Integrity. Fuel tank filler pipes may not be to specification. Thus when tested to CMVSS 301 the vehicle may leak fuel in excess of the Standard. Correction: Fuel filler pipes will be replaced.

Transport CanadaJan 25, 19941994013Model years 1994View details →
Older →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).