In the engine, some units have an insufficient bearing surface area for the crankshaft timing belt guide plate because the mounting seat was machined improperly. If the vehicle continues to be used in this condition, the pulley mounting bolts may loosen and abnormal noise may occur. In the worst case, the crankshaft pulley may spin freely, or the auxiliary drive belt may come off the crankshaft pulley, causing the charge warning light to illuminate and the steering effort to increase.
Some of the resin molding in the motor section of the fuel pump for the electronic fuel injection system is defective. If use continues in this condition, the brush section may wear down, and in the worst case the fuel pump may stop operating, which could cause the engine to stop.
Some ignition control units (igniters) installed on vehicles equipped with electronically controlled fuel injection may fail due to the effects of ozone (O3) or heat generated by electrical discharge. If use continues in this condition, the control unit may stop operating, and the engine may become unable to start.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).