In the driver-side airbag inflator (gas generator), moisture protection is inadequate, so the gas-generating agent may absorb moisture. Therefore, if the gas-generating agent repeatedly absorbs moisture and dries out during use, the airbag may not deploy normally when it is activated.
Interior door handles of the passenger compartment equipment may have been manufactured improperly during the pre-plating process, leaving plating solution residue between the plating layer and the resin. If the vehicle continues to be used in this condition, the residual solution may dissolve the resin and cause the plating to peel off. In the worst case, the occupant could injure a finger when operating the door handle.
In the prime mover, the installation instructions for the balancer shaft oil seal are inappropriate. If the vehicle continues to be used in this condition, the seal's retaining force may decrease, and in the worst case the seal may come out, causing engine oil to leak.
MLIT · JapanNov 14, 19962101040Model years 1994–1995Shown in the original Japanese · translation pendingView details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).