Free to read · free account to contributeSuccessor to Anticars (2000)

Kia Telluride

2019– · 2 generations · 10 documented defects · 3 markets
Generations

Everything about the Kia Telluride, all generations together: defects, recalls, service bulletins and discussions. Pick a generation to narrow it down.

Most serious reported defects

See all (10) →

Latest official recalls

See all (37) →
Telluride I · 2019–2026
RecallCriticalElectricalNA

Electrical

Issue: On certain vehicles, the recall repairs completed by a Kia dealer during service campaign RC207 (Transport Canada recall number 2024-323) may not have been done correctly and/or may not be effective. As a result, another repair is required. Under certain conditions, the switch for the driver- and/or passenger-front power seat motor(s) could become stuck and cause the seat motor(s) not to stop. If this happens, the motor(s) could overheat. Note: This recall replaces Transport Canada recall no. 2024-323. Vehicles that were repaired under that recall also require this repair. Safety Risk: A seat motor that overheats can create a fire risk, even while the vehicle is parked and turned off. Corrective actions: To reduce the safety risk, Kia advises that you should park your vehicle outdoors and away from other vehicles or structures until the recall repairs have been completed. Kia will notify owners by mail and advise you to take your vehicle to a dealership to install an electronic fuse for the power seats.

Transport CanadaJul 3, 20262026327Model years 2020–2024View details →
Telluride I · 2019–2026
RecallCriticalInteriorNAPark outside until repaired

Seats:Front assembly:Power adjust

Kia America, Inc. (Kia) is recalling certain 2020-2024 Telluride vehicles. The front power seat motor may overheat due to a stuck power seat slide knob or an improper recall 24V407 repair, which can result in a fire while parked or driving.

NHTSA · United StatesJul 2, 202626V430000Model years 2020–2024View details →
Telluride II · 2026–
RecallCriticalInteriorNA

Seat belts:Front

Kia America, Inc (Kia) is recalling certain 2027 Telluride and Telluride Hybrid vehicles. The driver seat belt emergency locking retractor may lock, causing the seat belt strap not to extend. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 209, "Seat Belt Assemblies."

NHTSA · United StatesJun 2, 202626V356000Model years 2027View details →

Latest service bulletins

See all (129) →
Telluride II · 2026–
BulletinMinorBodyNA

Bulletin

RELEASE NOTES: OVER-THE-AIR: SERVICE ACTION SOFTWARE UPDATE FOR RCM, UWB AND SBCM (SA652/SA653/SA658) - This Over-the-Air (OTA) software update the Roof Control Module (RCM), Ultra-Wideband (UWB) and Side Body Control Module (SBCM) logic of certain 2027 Telluride vehicles. This update is designed to improve the controller type determination logic to remedy the sunroof operation anomaly, the connection and controller logic between Digital Key and Ultra-Wideband-supported smartphone devices has been improved to reduce 12V battery consumption and the Side Body Control Module (SBCM) to reduce noise that may occur during the folding and unfolding of the outside mirrors.

NHTSA · manufacturer bulletin11037740Model years 2027View details →
Telluride I · 2019–2026
BulletinModerateElectricalNA

Bulletin

This Pitstop provides diagnostic guidance information for technicians to replace certain components for Kias further analysis and investigation in cases where customers allege vehicle stalling at low speeds on some 2025MY Telluride (ON) vehicles and where no warning light or DTC is found upon the vehicles arrival at the dealer. In addition, customers may report the warning message, Engine OFF! Shift to P or N, then start engine. For vehicles with this complaint, replace the variable force solenoid (VFS) on each cylinder bank and the manifold absolute pressure (MAP) sensor.

NHTSA · manufacturer bulletin11037370Model years 2025View details →
Telluride II · 2026–
BulletinMinorBodyNA

Bulletin

RELEASE NOTES: OVER-THE-AIR: SOFTWARE UPDATE FOR ROOF CONTROL MODULE (RCM), ULTRA-WIDEBAND (UWB) and SIDE BODY CONTROL MODULE (SBCM) - This Over-the-Air (OTA) software update is designed to update the Roof Control Module (RCM), Ultra-Wideband (UWB) and Side Body Control Module (SBCM) logic of certain 2027 Telluride vehicles. This update is designed to improve the following: - Improves the controller type determination logic to remedy the sunroof operation anomaly. - The connection and controller logic between Digital Key and Ultra Wideband-supported smartphone devices has been improved to reduce 12V battery consumption. - Improves the Side Body Control Module (SBCM) to reduce noise that may occur during the folding and unfolding of the outside mirrors.

NHTSA · manufacturer bulletin11036782Model years 2027View details →

Latest forum threads

No discussion yet.

Defects and discussions are filed under a generation: pick one above to add yours.

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).