Service bulletins (TSBs) are repair instructions manufacturers send to their dealers about known problems. They are not safety recalls, but they often confirm a defect.
TSB: The purpose of this bulletin is to provide information regarding transmission and/or park neutral position switch installation. If the manual shift lever is rotated prior to installing the park neutral position switch, the detent spring may become detached from the manual shift lever. Use the information in this bulletin when installing an automatic transmission and/or park neutral position switch assembly.
NHTSA · manufacturer bulletin10109446Model years 2006View details →
Special service campaign (ssc) - 6lb (supplemental restraint system (srs) airbag replacement). Due to improper assembly of the airbag inflator, which is incorporated into the srs airbag assembly (side airbag, curtain side airbag or driver knee airbag), some inflators were produced with an insufficient amount of the heating agents necessary for proper airbag deployment. *tt
NHTSA · manufacturer bulletin10019700Model years 2006View details →
TSB: This Service Bulletin includes procedures to replace damaged or loose front carpet floor retainer(s) without replacing the carpet assembly. Follow the Repair Procedure in this bulletin to replace the loose or damaged carpet floor retainer(s).
NHTSA · manufacturer bulletin10210374Model years 2005View details →
Warranty Enhancement Program - ZLD Phase 2,3 & 4 Part Replacement Available for all Models - Extention of Warranty Coverage for Cracked and/or Sticky/Melting Dashboards ( Inst krukment Panels) as a Result of Heat or Humidity.
NHTSA · manufacturer bulletin10205136Model years 2008View details →
Warranty Enhancement Program - ZLD Phase 2,3 & 4 Part Replacement Available for all Models - Extention of Warranty Coverage for Cracked and/or Sticky/Melting Dashboards ( Inst krukment Panels) as a Result of Heat or Humidity.
NHTSA · manufacturer bulletin10205392Model years 2008View details →
TSB: For proper calibration of the millimeter wave radar sensor, the vehicle and radar target must be on a level surface with a consistent plane. If a level surface with a consistent plane is not available, use the Floor Slope Compensation Procedure in this service bulletin in conjunction with the appropriate model and model year Repair Manual instructions when adjusting the millimeter wave radar sensor.
NHTSA · manufacturer bulletin10204556Model years 2006View details →
TT: For proper calibration of the millimeter wave radar sensor, the vehicle must be on a level surface. If a level surface is not available, this tech tip should be used in conjunction with the repair manual to set the angle of the front millimeter wave radar sensor and reflector height before performing beam axis adjustment.
NHTSA · manufacturer bulletin10173987Model years 2006View details →
TSB: Some 2006 ? 2020 model year Lexus vehicles may exhibit odors that naturally occur from the HVAC system and/or related environmental factors. Although there is no way to eliminate these odors, follow the General Procedure in this bulletin to minimize the odors experienced.
NHTSA · manufacturer bulletin10172825Model years 2006View details →
TT: Some IS250 and GS300 vehicles may exhibit one or more of the following conditions: ? MIL ?ON? DTC P0300, P0301, P0302, P0303, P0304, P0305, and/or P0306. ? Intermittently runs rough after coming to a stop with the engine at operating temperature. ? Intermittently runs rough with engine misfires present after a cold soak startup. NOTE: The recommendations in this document apply to an intermittent misfire concern. If a vehicle exhibits a steady misfire, the root cause is not related to the referenced service bulletins and the repair manual should be referenced for diagnosis.
NHTSA · manufacturer bulletin10152274Model years 2006View details →
Warranty Policy Bulletin: Lexus has received reports where some vehicles may exhibit cracked and/or sticky/melting dashboards as a result of heat or humidity. NOTE: The same voluntary Warranty Enhancement Program coverage described herein is also applicable to certain 2006-2008 MY IS 250/350 and certain 2007 MY LS 460 vehicles for cracked and/or sticky/melting front and rear interior door panels as a result of heat or humidity.
NHTSA · manufacturer bulletin10146513Model years 2008View details →
WPB: Background: Lexus has received reports where some vehicles may exhibit cracked and/or sticky/melting dashboards as a result of heat or humidity. In Mid-December, 2014 Lexus announced the reimbursement phase of this warranty enhancement program. Since this announcement, Lexus has been diligently making parts preparations for the parts replacement phase of this program. Due to the age, volume, and breadth of the covered vehicles involved in the Program, and the size and complexity of dashboard manufacturing, Lexus will be launching the part replacement portion of this Program in several phases; please refer to the table below for part replacement model phasing.
NHTSA · manufacturer bulletin10134373Model years 2008View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).