This file gathers the known defects of the Mazda Mazda2 III, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.
In 5.3% of the APK inspections of this car in the Netherlands this defect was found (704 out of 13,321 inspections in the past 12 months): 84.4 times as often as for cars of the same age.
✓ Mecafile analysis of official data2014–Auto-translated · original: DutchView details →
5.1% of periodic inspections of this car in Norway found a fault here that had to be repaired (37 cars in 720 inspections in 2025): 5.8 times as often as cars of the same age.
On affected vehicles improper programming of the combination meter display may cause the display to become inoperable and remain blank. This prevents the speedometer from being visible.
DVSA · United KingdomOct 1, 2025R/2025/316Model years 2023–2025View details →
The lower nut and bolt securing the shock absorber to the steering knuckle may become loose, leading to its detachment. This could result in loss of control of the vehicle or impaired steering stability, which could increase the risk of a crash.
EU Safety Gate · RappelConso · FranceDec 16, 2022a12/00509/22Model years 2013–2015Auto-translated · original: FrenchView details →
Some customers may complain about any of the following 1. Infotainment Center Display does not provide the Authorization Code (OTP) during the MyMazda App Connected Vehicle enrollment. 2. Remote function(s) inoperative.
NHTSA · manufacturer bulletin11039110Model years 2021View details →
Some vehicles may exhibit the check engine light ON with DTC P0300:00 (Random misfire detected) stored. This may be caused by a mis-detection of a misfire due to improper PCM control logic. To eliminate this concern, the PCM control logic has been modified.
NHTSA · manufacturer bulletin11012337Model years 2021View details →
Some customers may notice the charging lamp turns on while driving. Upon inspection, DTC P2502:00 PCM (Malfunction in voltage generated by generator) is stored in memory. This may be caused by resistance between the circuit board and ground. When high intensity electrical current passes through, the ground terminal position may not be sufficient enough. To eliminate this concern, the DC-DC converter control software has been modified. Additionally, the production procedure has been revised. The tightening torque for the ground terminal and circuit board was increased.
NHTSA · manufacturer bulletin11008418Model years 2021View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).