Free to read · free account to contributeSuccessor to Anticars (2000)

Mazda Mazdaspeed3 I

2007–2009 · 2 documented defects · 1 markets

This file gathers the known defects of the Mazda Mazdaspeed3 I, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.

Owners often report problems with transmission and drivetrain on this car (41 complaints), but no one has explained the cause yet. Do you know it?Write it up
Owners often report problems with engine and cooling on this car (17 complaints), but no one has explained the cause yet. Do you know it?Write it up

Most serious reported defects

See all (2) →
m
CriticalEngineNA

Engine and cooling: problems reported by owners

17 owners in the United States reported problems with the engine and cooling of this car to NHTSA (model years 2007–2008), typically at around 12,000 miles. Most often named: engine (71%). Reported consequences: 1 fire.

✓ Mecafile analysis of official data2007–2008View details →

Latest official recalls

See all (3) →
RecallModerateBodyNA

Visibility:Windshield wiper/washer:Motor

Mazda is recalling certain model year 2008-2009 mazda3 and mazdaspeed3 vehicles manufactured from january 7, 2008, through november 28, 2008. The ground terminal of the windshield wiper motor may have been inadvertently bent during assembly. If this condition exists then over time the electrical resistance of the motor circuit may increase up to a point that the windshield wipers would not work.

NHTSA · United StatesJun 15, 201111V329000Model years 2008–2009View details →
RecallModerateEngineNA

Engine and engine cooling

On certain passenger vehicles, the no. 4 left side engine mount bolt may loosen if a sudden rapid acceleration is repeatedly performed.

NHTSA · United StatesJul 10, 200707V295000Model years 2007View details →
RecallModerateOtherNA

Equipment

On certain passenger vehicles equipped with optional accessory all weather floor mats, there is insufficient clearance between the floor mat and accelerator pedal.

NHTSA · United StatesFeb 15, 200707V052000Model years 2007View details →

Latest service bulletins

See all (4) →
BulletinMinorEngineNA

Bulletin

Mazda: Variable valve timing (vvt) noise when starting engine. When engine is first started, some vehicles may exhibit a loud ticking noise from the variable valve timing (vvt) (a). This is caused by the lock pin of the variable valve timing actuator not fully engaging or from a worn lock pin hole. *pe updated on 06/08/2011. *kb

NHTSA · manufacturer bulletin10034634Model years 2007View details →
BulletinMinorElectricalNA

Bulletin

Mazda service campaign: See document search button for owner letter. An emission recall campaigns on certain vehicles to address a malfunction indicator lamp illumination concern and a malfunction with the on board diagnostic adaptive feedback control system. The pcm will be reprogram to include the latest calibration free of charge. Include models cx-7, mazdaspeed3, mazdaspeed6, and mazda6 2.3l 2006-2007. *pe

NHTSA · manufacturer bulletin10031324Model years 2007View details →
BulletinMinorEngineNA

Bulletin

Mil illumination (dtc p2006) voluntary emission recall campaign 4807h and obd-ii compliance voluntary emission recall campaign 4907h. *nj

NHTSA · manufacturer bulletin10023192Model years 2007View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).