In some ignition switches, too much grease was applied to certain contact points. For a vehicle used under these conditions, this can cause the grease to carbonize, and therefore an increased risk of fire.
EU Safety Gate · RappelConso · FranceDec 15, 2022a12/00507/22Model years 1989–2002Auto-translated · original: FrenchView details →
null Over the time, the contact points inside the ignition switch may become carbonized and become conductive to electricity. As a result the ignition switch could overheat, leading to the risk of a fire.
EU Safety GateOct 6, 2016A12/1298/16Model years 1986–1999View details →
Carbonised grease may accumulate between the contact points in the ignition switch reducing the insulation performance inside the switch. In this condition the switch may generate heat resulting in smoke and in the worst case a fire.
DVSA · United KingdomSep 30, 2016R/2016/210Model years 1989–2002View details →
On certain vehicles, a defect in the ignition switch could cause an electrical short to develop over time. This could result in smoke and/or fire, increasing the risk of injury and/or damage to property. Correction: Dealers will replace the ignition switch.
Transport CanadaOct 19, 20152015489Model years 1993–1998View details →
Mazda North American Operations (Mazda) is recalling certain model year 1989-1998 MPV, 1990-1995 323, 1990-1998 Protege, 1992-1993 MX-3, 1993-1995 929, 1993-1997 MX-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.
NHTSA · United StatesOct 19, 201515V674000Model years 1993–1998View details →
On certain vehicles operated in a hot, humid environment with the window open and air conditioner running, it is possible for condensation to enter the audio unit and cause a short circuit. If the short circuit occurs at a specific set of terminals, the speaker can overheat and possibly catch on fire. correction: Aluminum tape will be affixed over the audio unit to prevent water from entering.
Transport CanadaOct 21, 19981998202Model years 1998View details →
Vehicle description: If the vehicle is operated in a hot, humid environment with the window open and air conditioner running, it is possible for condensation to enter the audio unit and cause a short circuit.
NHTSA · United StatesOct 2, 199898V243000Model years 1998View details →
THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.
Transport CanadaMay 24, 19951995085Model years 1990–1991View details →
The passenger side supplemental restraint system (air bag) may have a cracked inflator body. If the vehicle is involved in a deployment level crash, the passenger side air bag may not inflate properly which could result in reduced occupant protection. In addition, the igniter plug could separate from the inflator, which could result in the release of hot gases and could ignite flammable material or potentially cause personal injury. Correction: Vehicles will be inspected and a new passenger side air bag module will be installed if necessary.
Transport CanadaFeb 21, 19951995033Model years 1995View details →
The fuel tank straps may not be properly tightened and may rub against the fuel tank. This could cause the tank's protective coating to wear through resulting in surface damage and eventual tank perforation and fuel leakage. Correction: Rubber insulator will be placed between the tank straps and the tank and the tank straps will be properly tightened. Also, a new protective coating will be applied where required. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2210j1537936
Transport CanadaDec 8, 19871987133Model years 1988View details →
In certain high salt areas, the idler arm is exposed to road salt which causes the dust seal to deteriorate resulting in idler arm pin corrosion. This causes the pin to freeze and break. Consequence of defect: A broken idler arm pin could result in loss of steering control and may cause an accident.
NHTSA · United StatesSep 4, 198585V108000Model years 1980–1982View details →
Certain vehicles do not comply with Regulation 6 - Statement of Compliance. Vehicles have an incorrect National Safety Mark (NSM). Correction: Since this non-compliance does not present a risk to vehicle safety, no further action will be taken.
Transport CanadaAug 28, 20002000176Model years 1998–2000View details →
On certain vehicles, an external spring in the timing belt auto tensioner may break. The broken spring may get caught in the timing belt, resulting in possible engine stalling. Correction: Dealers will inspect the tensioner on affected vehicles and replace if necessary.
Transport CanadaJun 14, 20002000125Model years 1998View details →
Vehicle description: Passenger vehicles. Certain reservoir tank caps on the brake master cylinder were produced with a worn out die and lack ventilation holes. As a result, the pressure in the reservoir tank can drop gradually as the brake pad or shoe wears and ambient temperature drops. Also, the pressure could reach a point that the brake caliper and drum cylinder are pulled back by the vacuum in the reservoir tank when the vehicle is parked for a long time.
NHTSA · United StatesMar 7, 200000V074000Model years 1999–2000View details →
Vehicle description: Passenger vehicles. The headlight wire that runs through the turn signal lever can fail at the point where it is soldered to the headlight switch.
NHTSA · United StatesDec 17, 199999V358000Model years 1994View details →
Certain vehicles do not comply with the requirements of CMVSS. 1103 - Exhaust Emissions. The average CO of the subject vehicles may exceed the standard due to insufficient robustness of emission control logic, and calibration of emission parts with extended usage. Correction: Dealers will install an engine intake kit, which will allow additional air to enter the engine, improving combustion efficiency and lowering the levels of carbon monoxide.
Transport CanadaNov 30, 19991999220Model years 1995View details →
Certain vehicles do not comply with the requirements of CMVSS 1105 - Evaporative Emissions. Fuel vapour may leak from between the fuel cap and the fuel filler pipe. The gap could be generated by improper dimensions between the top ends of the inner and outer pipe of the fuel filler pipe. In some cases, raw fuel would be released into the atmosphere. Correction: Dealers will install a modified fuel cap o-ring.
Transport CanadaApr 14, 19991999057Model years 1995–1997View details →
On certain vehicles, minor undercarriage impacts can result in unnecessary air bag deployment. This could result in personal injury and/or loss of vehicle control. Correction: Dealers will reprogram the sas unit to reduce the possibility of unnecessary deployments in low speed undercarriage impacts.
Transport CanadaOct 21, 19981998203Model years 1995–1997View details →
Vehicle description: Passenger vehicles equipped with the sas sensor unit. These vehicles can experience air bag deployments in minor undercarriage impacts.
NHTSA · United StatesOct 8, 199898V249000Model years 1995–1997View details →
On certain vehicles, an external spring in the timing belt auto tensioner may break. The broken spring may get caught in the timing belt, resulting in possible engine stalling. Correction: Vehicles will be inspected and affected tensioners will be replaced.
Transport CanadaSep 11, 19981998178Model years 1997View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).