In the airbag controller, a manufacturing defect in the backup power capacitor may cause an internal short circuit. As a result, if the controller's power is cut off during a collision, all airbags and seatbelt pretensioners may fail to deploy.
In the ignition switch, the grease used at the contact area is inappropriate. As a result, the heat from arc discharge when the movable contact separates from the fixed contact can carbonize the grease. If use continues in this state, the insulating properties of the grease decline, and metal powder accumulates from wear of the movable contact, causing electrical conduction between the contacts. The resulting heat can cause the grease to emit smoke and, in the worst case, may lead to a fire.
In resin fuel tanks, the material of the fuel evaporative emission hose and the surface roughness of the pressure control valve are inappropriate, so the pressure control valve may stick on some vehicles. If the vehicle continues to be used in this state, the fuel tank becomes under negative pressure and deforms, which tilts the fuel level gauge. As a result, the fuel gauge shows more fuel than actually remains. The low fuel warning light does not illuminate, so the vehicle may run out of fuel unexpectedly and stall.
Because it was unclear who made pass/fail decisions in the final inspection process, including cases where uncommissioned inspectors (inspection assistants) made pass/fail judgments, inspections related to the safety standards for road transport vehicles may not have been conducted properly.
In four-wheel-drive vehicles, the rear wheel speed sensor's resin material may be unsuitable, causing the resin to absorb water. As a result, the electronic components inside the sensor may short-circuit, and the sensor may output an abnormal signal. This can cause the ABS warning light to illuminate and the ABS function to stop, or the speedometer to stop operating.
Due to improper manufacturing of the front suspension frame, the lower arm mounting bracket of the suspension frame may corrode from corrosion-promoting substances such as salt water. Therefore, if the vehicle continues to be used in this condition, the corrosion will progress and the lower arm mounting bracket may break, and in the worst case the lower arm could fall off, making the vehicle unable to be driven.
In four-wheel-drive vehicles, some transfer cases have an improperly designed intermediate shaft inside the transfer, so the right-side drive shaft is not fully engaged. As a result, if a large impact is applied, such as when driving over a step, the drive shaft may come out, causing abnormal noise, oil leakage, or poor acceleration. In the worst case, the vehicle may become undrivable or may move while parked.
Some vehicles have a left-side bearing fitted to the reduction gear shaft inside the automatic transmission that is improperly lubricated, causing the bearing to wear. If the vehicle continues to be driven in this condition, abnormal noise may occur and, in the worst case, the bearing may be damaged, possibly causing the vehicle to decelerate suddenly.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).