On the subject vehicles the control logic which monitors the charging control program fails to divert the electrical power away from the capacitor when a fault is detected within the capacitor circuit. This can cause a short circuit inside the DCDC converter and could cause the engine to stall or overheating of the DCDC converter itself which could cause a fire. The fault is accompanied by the �i-ELOOP� warning light being illuminated on the instrument cluster along with the �i-Stop� warning light flashing The engine may in some circumstances stall and fail to restart. In extreme cases the DCDC converter could overheat and cause a fire
DVSA · United KingdomSep 17, 2018R/2018/237Model years 2015–2017View details →
On certain mini vans and passenger vehicles, the socket holder in the fog lights is installed in the lamp casing using pressure. During operation of the fog light, the heat from the bulb can expand the socket holder. The expansion can force the socket holder rearward. After repeatedly being subject to this expansion, if the fog light is also subjected to vibration during vehicle operation, the socket holder with the bulb holder and the wiring harness may separate from the fog light casing.
NHTSA · United StatesJun 5, 200303V206000Model years 2001–2003View details →
On certain vehicles, the front fog light bulb socket was installed improperly. If the vehicle continues to operate with this condition, the bulb socket and the wiring harness may separate from the fog light housing as a result of exposure to vehicle vibration. Should this occur, the bulb socket and the harness can drop inside the bumper and in the worst case, the heat generated can cause the bumper to burn. Correction: Dealer will re-install the bulb socket properly.
Transport CanadaFeb 25, 20032003047Model years 2001–2003View details →
On affected vehicles the Traction Control System (TCS)/Dynamic Stability Control (DSC) indicator light may not illuminate when abnormal yaw rate characteristics are detected due to a software diagnostic programming error. This issue does not affect vehicle drivability or braking performance.
DVSA · United KingdomSep 1, 2025R/2025/202Model years 2023–2025View details →
Mazda North American Operations (Mazda) is recalling certain 2024-2025 Mazda MX-5 vehicles. The Traction Control System (TCS) and Dynamic Stability Control (DSC) indicator light may fail to illuminate as intended due to a software error. As such, these vehicles fail to conform to Federal Motor Vehicle Safety Standard number 126, "Electronic Stability Control Systems."
NHTSA · United StatesMay 22, 202525V336000Model years 2024–2025View details →
On affected vehicles when reversing obstructions may not be detected correctly due to inappropriate software in the parking assist unit which may increase the risk of an accident.
DVSA · United KingdomFeb 28, 2025R/2025/043Model years 2023–2024View details →
Repeated thermal expansion and shrinkage in use may cause the front fog light socket holder to become detached from the fog light case. As a consequence an exposed hot bulb may come into contact with part of the vehicle body or fittings.
DVSA · United KingdomDec 12, 2003R/2003/099View details →
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 108 - LIGHTING. WHEN THE TURN SIGNAL IS SWITCHED ON, BOTH DRL'S ARE EXTINGUISHED AND THE TURN SIGNAL IS ACTIVATED. THIS MODE OF OPERATION IS CONTRARY TO THE REQUIREMENTS OF THE STANDARD. SUBSECTION 16 AND 19(b) (iii). CORRECTION: DRL CONTROL UNIT WILL BE REPLACED WITH ONE THAT WILL ENSURE THAT THE SYSTEM'S OPERATION MEETS THE STANDARD.
Transport CanadaJan 18, 19911991014Model years 1990View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).