In some ignition switches, too much grease was applied to certain contact points. For a vehicle used under these conditions, this can cause the grease to carbonize, and therefore an increased risk of fire.
EU Safety Gate · RappelConso · FranceDec 15, 2022a12/00507/22Model years 2001–2002Auto-translated · original: FrenchView details →
RecallCriticalInteriorNADo not drive until repaired
Mazda North American Operations (Mazda) is recalling certain 2003-2008 Mazda6, 2004-2005 MPV, 2004 RX-8, and 2006-2007 Mazdaspeed6 vehicles. These vehicles had their passenger frontal air bag inflators previously replaced under a prior recall using inflators of the same design. The inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.
NHTSA · United StatesOct 31, 201919V781000Model years 2004–2005View details →
RecallCriticalInteriorNADo not drive until repaired
Mazda North America Operations (Mazda) is recalling certain 2005-2006 Mazda MPV vehicles sold, or ever registered, in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming. On July 9, 2019 this recall was expanded to include certain 2005-2009 RX-8 vehicles that were previously recalled under 17V-011 but have not yet been repaired. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
NHTSA · United StatesJun 15, 201818V404000Model years 2005–2006View details →
RecallCriticalInteriorNADo not drive until repaired
Mazda North America Operations (Mazda) is recalling certain 2003-2008 Mazda6, 2006-2007 Mazdaspeed6 and 2004 MPV vehicles nationwide. Mazda is also recalling 2005-2006 MPV vehicles in Alabama, Arizona, Arkansas, California, Delaware, the District of Columbia, Florida, Georgia, Hawaii, Illinois, Indiana, Kansas, Kentucky, Louisiana, Maryland, Mississippi, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, South Carolina, Tennessee, Texas, Virginia, West Virginia, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands. On July 9, 2019 this recall was expanded to include certain 2004-2011 RX-8 vehicles that were previously recalled under 16V-354 but have not yet been repaired. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these passenger air bag inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
NHTSA · United StatesJun 15, 201818V402000Model years 2004–2006View details →
Note: The recall for the 2005-2008 RX-8 models has been superseded by recall <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2018038">2018038 (Mazda Recall 2018A)</a>, and the recall for the 2005-2006 MPV models has been superseded by recall <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2018578">2018578 (Mazda Recall 2618F)</a>. On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the passenger frontal airbag inflator. This could cause the airbag to deploy with more force than normal. As a result, if the vehicle were involved in a collision that warrants airbag deployment, fragments could be propelled toward vehicle occupants, and the airbag assembly could be damaged, preventing proper function. These issues could increase the risk of injury. Correction: Dealers will replace the passenger frontal airbag inflator. Additional note: Canadian climate results in the propellant degrading slowly. The recall is being conducted as a precaution to address future risk, and is expected to replace airbag inflators before their function would be affected.
Transport CanadaJan 10, 20172017011Model years 2005–2006View details →
null Over the time, the contact points inside the ignition switch may become carbonized and become conductive to electricity. As a result the ignition switch could overheat, leading to the risk of a fire.
EU Safety GateOct 6, 2016A12/1298/16Model years 1999View details →
Carbonised grease may accumulate between the contact points in the ignition switch reducing the insulation performance inside the switch. In this condition the switch may generate heat resulting in smoke and in the worst case a fire.
DVSA · United KingdomSep 30, 2016R/2016/210Model years 1999–2002View details →
Note: The recall for the 2004 RX-8 model has been superseded by <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2018038">recall 2018-038 (Mazda Recall 2018A)</a>, and the recall for the 2004 MPV model has been superseded by recall <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2018578">2018578 (Mazda Recall 2618F)</a>. On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the passenger frontal airbag. This could cause the airbag to deploy with more force than normal. As a result, if the vehicle were involved in a collision that warrants airbag deployment, fragments could be propelled toward vehicle occupants, and the airbag assembly could be damaged, preventing proper function. These issues could increase the risk of injury. Correction: Dealers will replace the airbag inflator. Additional note: Canadian climate results in the propellant degrading slowly. The recall is being conducted as a precaution to address future risk, and is expected to replace airbag inflators before their function would be affected.
Transport CanadaMay 26, 20162016259Model years 2004View details →
The ignition switch may have excessive grease applied to its internal contacts. The heat from the arc discharge generated when the switch is operated can carbonize the grease, causing it to accumulate between the movable and fixed contacts and reducing the insulation inside the switch. If use continues in this condition, the contacts may become conductive, causing the switch to overheat and emit smoke. In the worst case, this could lead to a fire.
The possibility exists that the power steering oil pump pulley retaining nut may become loose resulting if the vehicle continues to be driven in the pulley becoming detached. In the worst case due to loss of drive to the water pump the engine may seize.
DVSA · United KingdomSep 18, 2004R/2004/112Model years 2003View details →
On certain vehicles, the front passenger-side airbag was improperly wired and may not provide adequate protection in the event of a crash. Correction: Dealer will install a short wiring harness kit.
Transport CanadaFeb 19, 20042004067Model years 2004View details →
On certain vehicle, the airbag warning labels on the sun visors are English only. This does not comply with the requirements of CMVSS 208. Correction: Mazda will mail owners corrected replacement labels and installation instructions.
Transport CanadaJul 29, 20032003178Model years 2002–2003View details →
On certain mini vans and passenger vehicles, the socket holder in the fog lights is installed in the lamp casing using pressure. During operation of the fog light, the heat from the bulb can expand the socket holder. The expansion can force the socket holder rearward. After repeatedly being subject to this expansion, if the fog light is also subjected to vibration during vehicle operation, the socket holder with the bulb holder and the wiring harness may separate from the fog light casing.
NHTSA · United StatesJun 5, 200303V206000Model years 2002–2003View details →
On certain vehicles, the front fog light bulb socket was installed improperly. If the vehicle continues to operate with this condition, the bulb socket and the wiring harness may separate from the fog light housing as a result of exposure to vehicle vibration. Should this occur, the bulb socket and the harness can drop inside the bumper and in the worst case, the heat generated can cause the bumper to burn. Correction: Dealer will re-install the bulb socket properly.
Transport CanadaFeb 25, 20032003047Model years 2002–2003View details →
On certain vehicles, the diffuser may come off the inflator for the passenger air bag during deployment due to improper welding. Under these conditions, expanded gas cannot be supplied to the bag and may not deploy during a frontal crash. Correction: Dealers will replace the passenger side airbag with a correct one.
Transport CanadaAug 2, 20022002145Model years 2001View details →
Certain vehicles have fuel injectors that do not match the lower intake manifold. This condition could potentially result in a fuel leak. In the presence of an ignition source, an engine compartment fire could occur. Correction: Dealers will replace the lower intake manifold with the correct one.
Transport CanadaJul 27, 19991999138Model years 2000View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).