Prolonged exposure to sunlight may cause the front seat belt tongue assembly plastic sleeve that retains the lock bar to deteriorate and become displaced. This could potentially result in the tongue becoming detached from the seat belt webbing making the seatbelt useless to the vehicle occupant. Correction: Owners will be advised that ford will repair seat belts experiencing this condition.
Transport CanadaSep 28, 19921992117Model years 1984–1985View details →
The plastic sleeve in the front safety belt tongue assembly which retains the lock bar can deteriorate from prolonged exposure to sunlight and become displaced, causing the tongue to detach from the safety belt webbing.
NHTSA · United StatesApr 29, 199292V063000Model years 1984–1985View details →
The forward screw which provides part of the attachment between the driver`s seat back assembly and the seat cushion frame could fracture and permit the driver's seat back to pivot rearward. Such a condition could adversely affect the driver's ability to control the vehicle and could result in a vehicle crash. Correction: New driver's seat cushion attachment screws will be installed on affected vehicles.
Transport CanadaMay 17, 19881988066Model years 1981–1983View details →
The bolts that attach the d-shaped ring for the shoulder belt are inadequately supported by the material in which they are mounted. The attachment does not comply with the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages".
NHTSA · United StatesDec 20, 198383V134000Model years 1984View details →
The upper torso restraint d-ring which attaches the shoulder belt to the b pillar, under certain test conditions, separated from its anchorage, and may not comply with cmvss 210 - belt anchorage.
Transport CanadaDec 17, 19831983114Model years 1984View details →
The housing plates on the driver seat back latch recliner assemblies were manufactured with substandard material products. This tainted steel was used to produce seatback latches for both the right and left side seat assemblies. Under certain conditions, the defective housing plates may distort, allowing the locking teeth to disengage and tear off. This permits the seatback to pivot backwards.
NHTSA · United StatesSep 8, 198181V102000Model years 1981View details →
Vehicles produced at dearborn assembly plant. Vehicles may have been equipped with driver seat back latch recliner assemblies that contain housing plates manufactured from suspect steel material. Under certain types of driver induced seat loading the recliner mechanism housing plates might distort allowing the locking teeth to disengage. This would allow the seat back to rotate rearward into a reclined position.
Transport CanadaSep 4, 19811981092Model years 1981View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).