Motor vehicles - bodywork (occupant protection devices)
The rear left and/or rear right seat belts may not have been manufactured correctly.
🔔 Create a free account to get email alerts about Mini Countryman (all generations)
The rear left and/or rear right seat belts may not have been manufactured correctly.
BMW of North America, LLC is recalling certain 2026 2 Series Gran Coupe, X1, X2, and Mini Countryman S ALL4 vehicles. The housing pin in the rear (left and/or right) seat belt retractors may have been damaged during production, resulting in the retractor not locking the seat belt as intended. As such, these vehicles fail to comply to Federal Motor Vehicle Safety Standard number 209, "Seat Belt Assemblies."
The front seat belt(s) may not have been manufactured correctly.
The brake system may have a poor weld seam and could fail under high brake pressure, causing the brake booster to cut out.
Het frontend is mogelijk niet goed vastgeschroefd.
BMW of North America (BMW) is recalling certain 2023-2024 X1, 2024-2025 X5, 2025 X6, 2023-2025 X7, 740i, 760i, 2024 XM, 530i, 540i, i7, 750e, X2, 2024-2025 i5, 2024 Rolls Royce Spectre, 2025 MINI Countryman S ALL4, JCW Countryman ALL4, and 2025 MINI Hardtop 2 Door (Cooper, Cooper S) vehicles. Please refer to the recall report for the complete list of models. The welds in the servomotor of the integrated brake control module may break, causing a loss of power brake assist and rear brake function. In addition, the Antilock Brake System (ABS) and Dynamic Stability Control (DSC) system may not function.
In the production process, the armrest support bracket may have been incorrectly screwed to the rear left or right door panel. In the event of an accident, the armrest bracket can become detached, damaging the thorax airbag in the deployment area. This increases the risk of injuries to the vehicle's occupants.
Des défauts dans l’enroulement des feuilles internes cellulaires dans les batteries haute tension peuvent entraîner l’apparition d’une augmentation de l’autodécharge. cela peut entraîner une surchauffe des modules de cellules haute tension, ce qui augmente le risque d’incendie.
De gordelspanner werkt mogelijk niet bij een ongeval en er is kans op vonkvorming als de gordelspanner wordt geactiveerd.
BMW of North America, LLC (BMW) is recalling certain 2021 2 Series (230i, 230i xDrive, M240i, M240i xDrive), 330e, 330e Xdrive, 4 Series Coupe (430i, 430i xDrive, M440i xDrive) M4 Coupe, M4 Competition Coupe, BMW 4 Series Convertible (430i, M440i), BMW X1 sDrive28i, xDrive28i, 2 Series Gran Coupe (228i, 228i xDrive, M235i xDrive), M2 Competition Coupe, 330i, 330i xDrive, M340i, M340i xDrive, M3, M3 Competition, 530i, 530i xDrive, 540i, 540i xDrive, MINI Hardtop 2 Door (Cooper, CooperS, JCW), X2 sDrive28i, X2 xDrive28i, X2 M35i, Z4 sDrive30i, Z4 M40i, MINI Hardtop 2 Door (Cooper SE), MINI Convertible (Cooper, Cooper S, JCW), MINI Clubman (Cooper S, Cooper S All4, JCW), MINI Countryman (Cooper, Cooper All4, Cooper S, Cooper S All4, JCW All4), Rolls Royce Ghost, MINI Countryman (Cooper S E All4), Rolls Royce Phantom, Rolls Royce Cullinan, and Toyota Supra vehicles. The passenger seat belt Automatic Locking Retractor (ALR) may deactivate early, before the webbing fully retracts. As such, these assemblies fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 208, "Occupant Crash Protection."
De HV accucellen hebben mogelijk een productiefout.
De las verbinding van de HV accucellen is mogelijk niet juist gelast.
A short circuit in the high-voltage battery could occur during initial charging due to a particle in the form of a welding bead. This may trigger a chain reaction in the battery, increasing the risk of fire.
BMW of North America, LLC (BMW) is recalling certain 2020-2021 530e, 530e xDrive, 530e iPerformance and X3 xDrive30e and MINI Cooper Countryman All4 SE, 2020 BMW i8, and 2021 330e, 330e xDrive, 745Le xDrive and X5 xDrive45e vehicles. Debris may have entered one or more of the hybrid battery cells during their production.
BMW of North America, LLC (BMW) is recalling certain 2021 330e and X5 xDrive45e, 2020-2021 X3 xDrive30e, and 2020 MINI Countryman SE ALL4 vehicles. Loose welding beads may form a conductive path between the hybrid battery cells which could lead to a short-circuit.
Issue: On certain vehicles, the steering tie rod ends may not be assembled correctly and could be missing a washer. Over time, this may cause excessive wear to the tie rod ends and cause them to break. This could result in a loss of steering control. Safety Risk: A loss of steering control could create a risk of a crash. Corrective Actions: BMW will notify owners by mail and instruct them to take their vehicle to a dealer to inspect, and if necessary, replace the tie rods and ball joints.
On certain vehicles, a crankshaft sensor error may cause the engine to stall. This would result in a loss of motive power, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the crankshaft sensor. Note: This condition would result in the illumination of the check engine warning lamp and an “engine malfunction” message appearing in the instrument cluster. Note: This is an expansion of recall 2018-373.
The high-pressure fuel pump may not be fitted with a protective plate. As a result, the high-pressure pump may be damaged during a collision.
BMW of North America, LLC (BMW) is recalling certain 2017-2019 MINI Cooper Countryman vehicles. These vehicles may be missing a crash protection plate near the high pressure fuel pump, which may result in a fuel leak in the event of a crash.
Certain vehicles, which were parked at the port of entry in Halifax during the ice storms in February 2015, may have been exposed to excessive standing water and salt for an extended period due to this isolated environmental incident. Certain MINI models could have corrosion at the starter motor power supply cable connectors, which could lead to the inability to restart the engine following an engine shutdown by the start-stop (MSA) system, increasing the risk of crash causing injury in a traffic situation. On certain BMW models, the lubrication of some internal components within the steering rack may have been exposed to excessive water or salt which could result in higher than normal steering effort or steering binding, increasing the risk of a crash causing injury and/or damage to property. In addition, electrical wires and/or connectors in all affected vehicles may have been exposed to water or salt, which could lead to increased electrical system resistance, and increase the risk of fire causing injury and/or damage to property. Correction: Owners should contact their selling Retailer regarding this recall. Affected vehicles will be inspected. Some vehicles will be taken out of service immediately and owners will be provided with temporary transportation until a new replacement vehicle is available. All other vehicles are cleared of this safety concern and may continue to be driven until a new replacement vehicle is available. Due to potential concerns about long term vehicle quality, all affected vehicles will ultimately be removed from service.
In certain conditions moisture could gain entry into the wiring connector that powers the Electronic Power Steering (EPS) and the EPS unit. This moisture can then in very rare cases penetrate the EPS through the ground pin and cause overheating of the ground connector pin which can in turn lead to fire.
The front end may not be properly bolted to the engine subframe. If one of the bolts has not been correctly tightened and comes loose, the vehicle's safety may be compromised in the event of a frontal collision. In this case, there may be an increased risk of injury. In addition, a loose bolt may pose an accident risk to following traffic.
The car's seat belts were not manufactured correctly. In the event of a collision or accident, the restraining function of the seat belts may be reduced and may not provide the necessary protection. As a result, there may be an increased risk of injury.
The hollow shaft of the brake booster was poorly welded. The weld may not be able to withstand the buildup of high brake pressure and may break. In this case, reduced braking performance requires greater force and the braking distance may increase. In addition, the ABS and DSC brake control systems are not assisted. This increases the risk of an accident.
For certain vehicles BMW Group has developed a package of measures (hardware and software) for the emission control system of the MINI R60/R61.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).