Everything about the Mitsubishi Mirage, all generations together: defects, recalls, service bulletins and discussions. Pick a generation to narrow it down.
67 owners in the United States reported problems with the seat belts of this car to NHTSA (model years 1993–1995), typically at around 101,000 miles. Most often named: front:retractor (18%). Reported consequences: 6 crashes, 7 injuries.
✓ Mecafile analysis of official data1993–1995View details →
65 owners in the United States reported problems with the airbags of this car to NHTSA (model years 1994–1995), typically at around 135,000 miles. Most often named: frontal (80%). Reported consequences: 51 crashes, 2 fires, 43 injuries, 3 deaths.
✓ Mecafile analysis of official data1994–1995View details →
16 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 1993–1995), typically at around 121,000 miles. Most often named: ignition (38%), ignition:switch (31%). Reported consequences: 1 fire.
✓ Mecafile analysis of official data1993–1995View details →
14 owners in the United States reported problems with the brakes of this car to NHTSA (model years 1993–1995). Most often named: foundation components:disc:pads (36%), foundation components:master cylinder (21%), foundation components (21%). Reported consequences: 5 crashes, 1 fire, 5 injuries, 2 deaths.
✓ Mecafile analysis of official data1993–1995View details →
49 owners in the United States reported problems with the seat belts of this car to NHTSA (model years 1987–1992). Most often named: front:buckle assembly (31%). Reported consequences: 3 crashes, 5 injuries.
✓ Mecafile analysis of official data1987–1992View details →
Issue: This service campaign is for certain replacement rear brake drums that were sold by Mitsubishi dealers. The brake drums may have been made with wheel stud holes that are too large. As a result, a wheel stud could spin when tightening the wheel nut. This can reduce the clamping force between the wheel and the brake drum. If this happens, the wheel may eventually come loose and could separate from the vehicle. Note: This service campaign is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: A wheel that cannot be properly tightened could increase the risk of a wheel separation. This could increase the risk of a crash. A wheel that separates could also hit another person or vehicle. Corrective Actions: Mitsubishi will contact owners that may have had these brake drums replaced at a Mitsubishi dealer. They will advise affected owners to take their vehicle to a dealer, who will replace any affected brake drum(s).
Transport CanadaJun 15, 20212021377Model years 2014–2016View details →
In the driver's seat airbag inflator (inflation device), the moisture protection is inadequate, so the gas-generating agent may absorb moisture. Therefore, if the gas-generating agent repeatedly absorbs and dries out during use, there is a risk that the airbag may not deploy properly when it is activated.
This Technical Service Bulletin reminds dealers of the required regulation that a label showing the reduction in load carrying capacity be affixed to vehicles when the total net weight of accessories exceeds an established threshold.
NHTSA · manufacturer bulletin11013872Model years 2024View details →
This Technical Service Bulletin provides service manual corrections to the harness wire diameter and circuit diagram color changes in the Roof Harness, Plug Harness and Control Harness sections of the applicable Service Manual.
NHTSA · manufacturer bulletin10246264Model years 2021View details →
Latest forum threads
No discussion yet.
Defects and discussions are filed under a generation: pick one above to add yours.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).