The gas generator on the passenger side airbags may be defective
The gas generator on the passenger side airbags may be defective. Metal fragments can be released when the airbag is activated, causing injuries to the occupants.
🔔 Create a free account to get email alerts about Nissan Note I
The gas generator on the passenger side airbags may be defective. Metal fragments can be released when the airbag is activated, causing injuries to the occupants.
The subject vehicles are equipped with front passenger�airbag�inflators which could have been assembled with improperly manufactured propellant This could cause the inflator to rupture and the front passenger�airbag�to deploy abnormally in a crash. This could result in increased risk of injury to the occupant.
null In the event of deployment of the passenger airbag, the inflator could rupture causing metal fragments to be produced which could cause injury to the occupants of the vehicle.
In the event of driver�s airbag deployment the internal pressure of inflator may increase abnormally and in an extreme case cause the driver�s airbag inflator casing to rupture. In an extreme case this may cause a scattering of metal fragments.
null In the event of deployment of the driver’s airbag, the internal pressure of the inflator may increase abnormally and, in extreme cases, cause the driver’s airbag inflator casing to rupture.
The lower pinion needle bearing may have been omitted during manufacture of the steering gear due to insufficient controls in the suppliers manufacturing process. It is possible the pinion may disengage from the steering gear with loss of steering control.
null There is a possibility that the lower pinion needle bearing may have been omitted from the steering system during manufacture. If this is the case, the upper bearing would be overloaded and, if left in this condition, the pinion may disengage causing loss of steering control.
Le générateur de gaz sur les coussins gonflables côté passager peut être défectueux.
車両製作工場の完成検査において、任命されていない検査員が合否判定を行ったものがあり、安全環境性能法規(保安基準)に関する検査が適切に行われていなかった。
Bij het activeren van de passagiersairbag kan in het ontstekingsmechanisme een te hoge druk ontstaan. Hierdoor kan de behuizing van het ontstekingsmechanisme barsten.
During final vehicle inspections at the manufacturing plant, some vehicles were judged pass/fail by inspectors who had not been appointed, meaning that inspections related to safety and environmental performance regulations (Safety Standards) were not properly carried out.
Er kan corrosie optreden in het opblaasmechanisme van debestuurdersairbag. Als gevolg daarvan kan er bij activeren van de airbag een te hoge druk ontstaan.
Er kan corrosie optreden in het opblaasmechanisme van de passagiersairbag. Als gevolg daarvan kan er bij activeren van de airbag een te hoge druk ontstaan.
De mogelijkheid is aanwezig dat het onderste lager in het stuurhuis niet is gemonteerd.
De startdrukknop kan in de ingedrukte positie blijven hangen nadat de motor is gestart.
ドアミラーにおいて、鏡面部の接着力が不足しているため、使用過程における紫外線の影響等により、接着力が低下して接着面が剥離するものがある。そのため、そのままの状態で使用を続けると、最悪の場合、鏡面部が脱落して、後方の交通状況等が確認できなくなるおそれがある。
後輪ブレーキのアッパースプリング製造工程において、治具の形状が不適切なためスプリングに傷がついたものがある。そのため、そのまま使用を続けると、当該アッパースプリングが折損し、最悪の場合、ブレーキを解除しても制動力が完全に解除されないおそれがある。
It is possible that the vehicles brake fluid maybe contaminated with mineral oil. This can cause the seals within the system to swell and affect their sealing properties. This may require drivers to apply additional force to the foot brake and could increase stopping distances.
エンジン制御用電源リレーにおいて、リレーに内蔵されているダイオードの製造方法が不適切なため、導通不良となるおそれがある。そのため、そのままの状態で使用を続けると、エンジン始動不良や走行中にエンストするおそれがある。
During the inspection process of engine manufacturing, the terminal portions of the inspection electrical wiring were deformed, so some engine-side electrical wiring terminals have also been deformed. Therefore, if the vehicle continues to be used in this condition, the affected wiring may suffer poor contact, and in the worst case, the engine may stall while driving and be unable to restart.
It has been identified that a connector in the diesel particulate filter fuel system may not be correctly attached. If this is ignored fuel may leak from the connector during a particulate filter regeneration cycle.
無段変速機の前進用クラッチハブの強度が不足しているものがある。そのため、そのまま使用を続けると、当該ハブに亀裂が発生し、最悪の場合、ハブが破断して、前進できなくなるおそれがある。
A concern has been identified with the rear seat ISOFIX brackets of some E11 Note vehicles. In that the brackets may have been manufactured incorrectly with the potential that the brackets may not perform to the design intent in the case of a side impact. In addition the brackets may not conform to the required EC legislation.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).