Free to read · free account to contributeSuccessor to Anticars (2000)

Nissan Pulsar N13

1986–1990 · 0 documented defects · 5 markets

This file gathers the known defects of the Nissan Pulsar N13, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.

Most serious reported defects

No defect documented for this selection yet.

Latest official recalls

See all (4) →
RecallCriticalElectricalJP

Other (Electrical Equipment)

A manufacturing defect has been found in the radio noise suppression capacitors (condensers) installed in the ignition system wiring of the engine. If use continues in this condition, the terminals of the capacitor may short-circuit and burn out, and in the worst case, may lead to a fire.

MLIT · JapanMay 8, 19961104572Model years 1989–1990Auto-translated · original: JapaneseView details →
RecallModerateEngineNA

Emissions

These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions due to an inoperative electrical contact spring for the throttle body mixture heater. Correction: Mixture heater will be replaced with an improved type. Note: 4wd vehicles only.

Transport CanadaDec 10, 19871987136Model years 1987View details →

Latest service bulletins

See all (17) →
BulletinModerateSuspensionNA

Bulletin

DIAGNOSIS OF VEHICLE PULL (DRIFT) AND/OR STEERING WHEEL OFF-CENTER This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

NHTSA · manufacturer bulletin10243708Model years 1989–1990View details →
BulletinModerateElectricalNA

Bulletin

SILICONE-BASED LUBRICANT OR GREASE CAN DAMAGE ELECTRICAL COMPONENTS SERVICE INFORMATION Do not apply Silicone-based lubricants or grease to, or around, any interior electrical components. To avoid the risk of death or severe personal injury, do not directly spray Silicone-based lubricant or grease, or inadvertently overspray Silicone-based lubricant or grease onto any interior electrical components. These types of lubricants can be detrimental to the proper operation of electrical components.

NHTSA · manufacturer bulletin10239062Model years 1989–1990View details →
BulletinMinorElectricalNA

Bulletin

12 VOLT BATTERY TESTING FOR IN-SERVICE VEHICLES SERVICE INFORMATION The following Service Information lists NNA procedural recommendations for establishing good connections while performing 12V battery testing. These recommendations are expected to promote uniformity during the connection process, therefore reducing the number of incorrect Test with DCA and Replace results. HINT: If 12 volt batteries are allowed to discharge for a prolonged period of time, battery life may be drastically reduced. This condition may lead to premature battery replacement and customer dissatisfaction. IMPORTANT: CPX-900 is now an accepted testing tool to use along with or in place of the DSS-5000 CPX-900 operating instructions are found at: https://nissancpx900.midtronics.com/ DSS-5000 operating instructions are found at: https://nissandss5000.midtronics.com/ DCA-8000 is now a required testing tool to be used for all warranty replacement decisions. The DCA-8000 is also a more efficient charger than previously available, and will charge any available 12 volt lead acid battery safely and accurately as long as all precautions and inputs are made correctly. The DCA-8000 operating instructions are found at: https://nissandca8000.midtronics.com/

NHTSA · manufacturer bulletin10239060Model years 1989–1990View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).