Everything about the Pontiac Aztek, all generations together: defects, recalls, service bulletins and discussions. Pick a generation to narrow it down.
107 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2001–2005), typically at around 69,000 miles. Reported consequences: 2 crashes, 7 fires, 2 injuries.
✓ Mecafile analysis of official data2001–2005View details →
38 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2001–2005), typically at around 117,000 miles. Most often named: frontal (29%). Reported consequences: 19 crashes, 24 injuries.
✓ Mecafile analysis of official data2001–2005View details →
NHTSA, the US road safety agency, opened a preliminary evaluation (PE04075) into this problem on 10 November 2004 for 2004 models; it was closed on 28 April 2005 without a recall.
124 owners in the United States reported problems with the fuel system of this car to NHTSA (model years 2001–2005), typically at around 78,000 miles. Most often named: storage:tank assembly (17%). Reported consequences: 2 fires.
✓ Mecafile analysis of official data2001–2005View details →
77 owners in the United States reported problems with the brakes of this car to NHTSA (model years 2001–2005), typically at around 47,000 miles. Most often named: antilock/traction control/electronic limited slip (26%). Reported consequences: 4 crashes, 2 fires, 5 injuries.
✓ Mecafile analysis of official data2001–2005View details →
On certain vehicles, variations in the manufacturing process or exposure to high ambient temperatures may lead to fracture of the fuel tank inlet check valve (icv).
NHTSA · United StatesAug 8, 200707V349000Model years 2001–2004View details →
On certain Aztek (AWD), Montana (AWD), Relay (AWD), RendezVous (AWD), RendezVous (FWD), Silhouette (AWD), Terraza (AWD), Terraza (FWD), Uplander (AWD) and Venture (AWD) vehicles equipped with independent rear suspension, when operated in extreme cold temperature and on rough roads, water and salt can intrude past the ball joint seal. The combination of theses conditions may then lead to premature wear of the ball joint. If the ball joint wear progresses to the point of separation from the lower control arm, a loss of vehicle control may occur. Correction: Dealers will replace both ball joints with new ball joints which have a revised boot and ball stud to improve the seal to the ball stud shaft.
Transport CanadaAug 15, 20062006199Model years 2001–2005View details →
On certain sport utility vehicles, contamination on ignition relay contacts can cause high resistance. This can affect signals to the powertrain control module and, could cause intermittent vehicle stalls at any time.
NHTSA · United StatesApr 20, 200505V157000Model years 2004View details →
This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.
NHTSA · manufacturer bulletin11019074Model years 2005View details →
This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.
NHTSA · manufacturer bulletin11019073Model years 2005View details →
This Preliminary Information communication provides information to the technician about the use of J-35616-64B and Mini 50 terminal test probe, replacement terminals, and terminated leads.
NHTSA · manufacturer bulletin11019072Model years 2005View details →
Latest forum threads
No discussion yet.
Defects and discussions are filed under a generation: pick one above to add yours.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).