La conduite de carburant diesel est trop proche du faisceau de câblage, ce qui peut causer le frottement de la conduite de carburant contre les fils et l'usure. cela peut entraîner une fuite de carburant sous la voiture, créant un risque d'incendie.
EU Safety Gate · RappelConso · FranceJan 10, 2025a11/00094/24Model years 2014Shown in the original French · translation pendingView details →
The strap of the diesel filter may brake causing the diesel filter to disconcert from its holder. Possibility of a noise in the engine compartment and in extreme cases fuel leakage.
DVSA · United KingdomNov 21, 2017R/2017/312View details →
On affected vehicles the drive to brake vacuum pump may fail. This may cause a loss of brake servo assistance and a hard brake pedal. It may also cause a reduction in engine power.
DVSA · United KingdomJan 8, 2016R/2016/001View details →
The prop shaft to axle flange bolts may not be tightened to the correct torque. The condition could develop noise and vibration and if not corrected loss of drive.
DVSA · United KingdomApr 8, 2014R/2014/042Model years 2010–2013View details →
The prop shaft to axle flange bolts may not be tightened to the correct torque. The condition could develop noise and vibration and if not corrected loss of drive.
DVSA · United KingdomApr 1, 2014R/2014/056View details →
It is possible that the rear wheel bearing has been damaged whilst it was assembled onto the stub axle. This should be identified by excessive noise however in the worst case if not detected it could result in bearing failure and the detachment of the wheel and hub.
DVSA · United KingdomAug 17, 2011R/2011/102Model years 2010View details →
It is possible that the rear wheel bearing was damaged whilst it was assembled onto the stub axle. This could result in bearing failure and the detachment of the wheel and hub.
DVSA · United KingdomAug 1, 2011R/2011/121View details →
It is possible that the rear wheel bearing was damaged whilst it was assembled onto the stub axle. This could result in bearing failure and the detachment of the wheel and hub.
DVSA · United KingdomAug 1, 2011R/2011/122View details →
The spare wheel carrier winch system may allow the spare wheel to be loosely installed after the customer has used the winch. In this condition the spare wheel might move during driving which may damage and eventually break the cable and guiding pin of the winch system. In this worst case the spare wheel would become detached from the vehicle.
DVSA · United KingdomJul 5, 2011R/2011/074Model years 2010View details →
The spare wheel carrier winch system may allow the spare wheel to be loosely installed after the customer has used the winch. In this condition the spare wheel might move during driving which may damage and eventually break the cable and guiding pin of the winch system. In this worst case the spare wheel would become detached from the vehicle.
DVSA · United KingdomJul 1, 2011R/2011/101View details →
null There is a risk of loss of traction, due to the loss of the fixing bolts for the connection between the longitudinal transmission and the rear axle.
EU Safety GateApr 22, 2014A12/0614/14Model years 2007–2013View details →
There is a risk that the nearside rear axle spindle may crack which in the most serious cases will lead to the spindle breaking which dependent on loading could make directional control difficult to maintain.
DVSA · United KingdomNov 1, 2010R/2010/167Model years 2010View details →
Because of a manufacturing error the nearside rear stub axle could start to develop cracks at the inner radius which could eventually lead to failure of the stub axle and difficulty in maintaining directional control.
DVSA · United KingdomNov 1, 2010R/2010/191View details →
It has been found that some of the front seat mounting brackets have not been correctly fitted to the seats. The front seat mountings could fail if the fitting brackets have been incorrectly fitted. Vehicle control could be affected.
DVSA · United KingdomOct 28, 2010R/2010/168Model years 2010View details →
The seat belt positioning may be incorrect due to the front seat brackets not being to specification. This could affect the seat security and seat belt performance if an accident occurs.
DVSA · United KingdomSep 30, 2010R/2010/139View details →
It is possible that the rear caliper handbrake lever to crack and weaken. In the worst case there is a possibility that the parking brake cables will release.
DVSA · United KingdomAug 30, 2006R/2006/123Model years 2005–2006View details →
The engine may stall at idle and/or when lifting off the throttle following a period of hard acceleration.
DVSA · United KingdomJul 22, 2002R/2002/083Model years 2000–2001View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).