Free to read · free account to contributeSuccessor to Anticars (2000)

Renault Fluence

2009–2015 · 2 generations · 4 documented defects · 8 markets
Generations
SeverityAllModerate
Model year
MarketAllEUKR
Fluence I · 2009–2015
RecallModerateEngineKR

Exhaust system

Recall due to the possibility that the purge control valve may not fully close, caused by a mold quality issue at the supplier that manufactures the valve, which could affect exhaust emissions.

MOLIT · South KoreaMay 24, 20213895Model years 2014–2016Auto-translated · original: KoreanView details →
Fluence I · 2009–2015Fluence Z.E. · 2011–2013
RecallModerateEngineKR

Engine (Prime Mover)

Recall due to the possibility of engine stalling in extreme conditions, such as when the engine load becomes extremely high from use of the air conditioner, electrical device load, or friction between parts due to aging. In these cases, there is a mode in which the engine torque compensation value is insufficient for a sudden drop in engine speed (RPM), which may cause the engine to stall. <*Production dates of affected vehicles> SM3: 2012.06.19~2013.06.03 SM3: 2013.03.26~2014.04.07 SM3: 2014.02.27~2019.08.19

MOLIT · South KoreaDec 4, 20203680Model years 2012–2016Auto-translated · original: KoreanView details →
Fluence I · 2009–2015
RecallModerateEngineKR

Engine

Recall due to the possibility that a normally operating barometric pressure sensor may be misdiagnosed by the vehicle's ECU as a sensor malfunction

MOLIT · South KoreaNov 8, 20193319Model years 2015–2016Auto-translated · original: KoreanView details →
Fluence I · 2009–2015
RecallModerateEngineKR

Engine (Powertrain)

Recall due to the possibility of improper fuel correction under certain operating conditions of the canister purge valve, resulting in poor air-fuel ratio

MOLIT · South KoreaJul 10, 20172461Model years 2014–2016Auto-translated · original: KoreanView details →
Fluence I · 2009–2015Fluence Z.E. · 2011–2013
RecallModerateEngineKR

Engine (Prime Mover)

A recall due to possible soldering defects inside water temperature sensors: poor management of the solder bath used by a parts manufacturer to weld water temperature sensors allowed residue to accumulate inside the bath. As a result, the sensor that monitors the bath temperature lost sensitivity and read lower than the actual bath temperature. Because of this, the bath exceeded its upper temperature limit, creating the possibility of poor solder joints inside the water temperature sensors.

MOLIT · South KoreaJul 3, 20172459Model years 2013–2014Auto-translated · original: KoreanView details →
Fluence I · 2009–2015Fluence Z.E. · 2011–2013
RecallModerateEngineKR

Engine (Powerplant)

A manufacturing defect in which, in an extremely rare number of the affected production vehicles, the engine mount fixing bolts may break due to bolt walk-out caused by insufficient tightening torque.

MOLIT · South KoreaAug 17, 20151716Model years 2009–2015Auto-translated · original: KoreanView details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).