Possible inadvertant deployment of front airbag(s).
A capacitor in the front air bag control unit may short circuit This could lead to an inadvertent deployment of the air bag(s).
🔔 Create a free account to get email alerts about Saab 900 (all generations)
A capacitor in the front air bag control unit may short circuit This could lead to an inadvertent deployment of the air bag(s).
On certain vehicles, an electrical short within the airbag electronic control unit may cause inadvertent deployment of the front airbags and seat belt pretensioners. Correction: Dealers will replace the airbag electronic control unit (ECU). Note: parts will not be available until April 2003.
Certain passenger vehicles. Static electricity can build up within the passenger-side air bag module and create significant enough charge to cause an inadvertent air bag deployment during triggering events. Most of these triggering events have occurred in cooler, dry weather and have generally included dusting or wiping of the dashboard, starting the car, or closing the door. Unexpected air bag deployment can result in occupant injury. Correction: Dealers will install a front passenger-side air bag module grounding strap
音響機器のオーディオ本体の配線基盤において、当該基盤の製造工程が不適切なため、コ ンデンサが損傷しているものがあり、そのままの状態で使用を続けると、当該コンデンサ の端子間が短絡して、スピーカーに過大な電流が流れ、最悪の場合、火災にいたるおそれ がある。
Note: 5 door vehicles. These vehicles do not comply with c.M.V.S.S. 210 - seat belt assembly anchorages. Vehicles were assembled with a non heat treated outboard attachment plate on the safety belt which could in certain circumstances deform and detach from the seat anchorage. Correction: Front seat belts will be inspected and replaced if necessary.
During static testing of belt anchorage points, the outboard attachment plate being used in the testing deformed and detached from the seat anchorage. This does not comply with fmvss no. 209, "seat belt assemblies" and no. 210, "seat belt assembly anchorages."
On certain Saab 900 convertible, the steering column shaft may have been misaligned at the time of installation. This misalignment could cause a fatigue failure in one section of the shaft, with a subsequent loss of steering control. Correction: dealers will inspect and/or replace the steering column assembly.
The steering column may have been misaligned during assembly. This could cause fatigue in the column and result in loss of steering control.
The steering column shaft was incorrectly installed in the vehicle causing the column to be out of alignment.
A reverse electrical current flow through a wire cable between the air recirculation switch and a micro switch could occur. This may cause overheating of the air circulation system fan resistor, creating the risk of fire. Correction: A wire cable will be disconnected to prevent overheating of the fan resistor.
The wiring harness may chafe against sharp edges under the dashboard and also, in the 1988 vehicles, against a carpet support. If a short circuit develops there is a risk of smoke or possibly fire inside the passenger compartment. Correction: Four rubber strips will be affixed to edges in critical locations and the main harness under the dashboard will at some locations, be covered by a plastic hose.
Fuel filter may not meet the specification concerning leakage criteria due to low temperature during the gluing process.
Wiring harness may chafe against sharp edges under the dashboard and against a support under the rear seat (1988 models only).
On certain Saab 900S and 900 turbo, the fuel hose between the pressure regulator and the injector fuel rail may rupture due to stress resulting in a fuel leak and possible fire. Correction: A new plastic fuel hose with an outer casing of rubber will be installed.
The fuel hose between the pressure regulator and the injector fuel rail may rupture due to stress.
The bolt in the upper steering column u-joint clamp may have been over torqued and may break. Consequence of defect: A broken u-joint clamp may allow the steering shaft to pull out of the joint and result in loss of steering control and possibly an accident.
The flexible fuel hose located between the injector fuel rail and the fuel pressure regulator may rupture. The hose may have been turned out of its correct position when being tightened during final vehicle assembly. A sharp bend or twist in the hose near one of its end fittings could lead to hose rupture with fuel leakage creating a possible fire hazard. 16 valve turbo vehicles.
The flexible fuel hose may have been turned out of its normal position and have a sharp bend or twist near one of its fittings. Consequence of defect: This could lead to hose rupture, fuel leakage, and possibly a fire.
The alternator to starter cable may rub against the brake fluid pipe attached to the left inner wheelhouse in the engine compart- ment. Rubbing may eventually damage the cable insulation creating a risk of short circuit and under certain conditions, a possible engine compartment fire.
The electrical cable between the starter and the alternator can rub against the brake fluid pipe attached to the left inner wheelhouse in the engine compartment. Consequence of defect: Rubbing will eventually damage the cable insulation and result in a short circuit which may cause a fire.
The alternator to starter cable may rub against the brake fluid pipe engine movement could eventually cause damage to the cable insulation through chafing, creating a risk of short circuit and under certain conditions, a possible engine compartment fire.
Road vibration and fuel tank pressure may cause the fuel pump support and fuel hose clamp to fail to retain the fuel pump in its correct position. This can result in fuel leakage.
The possibility exists that the mounting collar for the electric fuel pump, submerged in the fuel, could partially detach from the top of the tank and cause a fuel leak.
運転者席及び助手席のエアバッグにおいて、制御用モジュールのコンデンサーの耐熱性が 不足しているものがあるため、そのままの状態で使用を続けると、当該コンデンサーから 液漏れが発生することがあり、最悪の場合、回路が短絡して突然エアバッグが展開すると ともにシートベルトプリテンショナーが作動し、運転操作が妨げられるおそれがある。
On certain passenger vehicles, the air bag electronic control unit (ecu) is designed to sense and discriminate frontal impact events, command air bag and seat belt pretensioner deployments in a timely manner, and perform continuous diagnostics of the air bag system in the vehicle. Due to the possible insufficient sealing of the bottom of an electrolyte capacitor, it is possible for it to leak electrolyte within the air bag ecu. Also, in high humidity environments, the operation of the vehicle air conditioner can cause rapid cooling of the ecu, which in turn may cause the formation of condensation with the unit.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).