In the airbag computer, improper capacitor manufacturing processes may cause internal short circuits. Therefore, if the vehicle continues to be used in this condition, the airbags and seat belt pretensioners may fail to deploy in a collision where they should activate.
In the front seats, the mounting bolts were not tightened properly, so some of these bolts may loosen due to vibration during driving. As a result, abnormal noise may occur from the mounting area, and if use continues as is, the bolts may fall out. In the worst case, the seat could move in a collision, and the occupant protection performance it is meant to provide may not be achieved.
In the front stabilizer, due to improper control of the manufacturing process, some units have a large amount of pre-painting chemical conversion solution remaining inside the pipe, and their strength has been reduced by hydrogen embrittlement. Therefore, if the vehicle continues to be used in this condition, the stabilizer may break due to torsional force while driving.
In the fuel pump impeller (resin impeller), improper molding conditions can result in low resin density, causing the impeller to swell and deform when exposed to fuel. As a result, the impeller may come into contact with the pump case, causing the fuel pump to malfunction and, in the worst case, potentially leading to engine stall while driving.
In the computer that controls the electric parking brake, the program used when releasing the brake is inappropriate, so the amount the brake cable returns may be insufficient. As a result, if the vehicle continues to be used in this state, the cable will eventually move outside its operating range. When the parking brake is applied, an abnormality may be detected and the warning light may illuminate. In the worst case, the parking brake may become impossible to release.
In the fuel pump impeller (resin impeller), improper molding conditions can lead to low resin density, causing the impeller to swell and deform when exposed to fuel. As a result, the impeller may come into contact with the pump case, causing the fuel pump to malfunction and, in the worst case, potentially leading to engine stalling while driving.
The rear brake self-adjuster mechanism (strut set) that automatically adjusts the clearance between the brake shoes and drum has an issue: due to improper management of the grease application equipment during parts assembly, some units have insufficient grease applied to the threaded surface of the adjuster bolt. If the vehicle continues to be used in this condition, the threaded surface may rust and seize, and the automatic adjustment mechanism may stop functioning.
In the automatic adjustment mechanism (strut set) that maintains the gap between the shoes and drum of the rear brakes, some adjuster bolts have not had grease applied to their threaded surfaces due to improper grease application during parts assembly. If such vehicles continue to be used in this condition, the threaded surfaces may rust and seize, and the automatic adjustment mechanism may stop functioning.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).