Note: Vehicles equipped with all-wheel drive manual transmission. Under cold and humid conditions, frost may form at the transmission oil level gauge (dipstick) where the breathing mechanism is incorporated. This could cause pressure to build inside the transmission case which in turn could push out the oil seal. Subsequent oil leakage could result in burning of transmission components and possible loss of control due to wheel lock-up. Correction: On vehicles with an all metal type dipstick, the oil level gauge tube will be modified and the dipstick will have a spacer added. Vehicles with a plastic dipstick will have a modified type dipstick installed.
Transport CanadaMar 29, 19941994067Model years 1989–1990View details →
When the vehicle is driven continuously under extremely cold temperatures (-22 degrees f.) and high humidity weather conditions, the transmission breathing (air) vent can be blocked due to moisture freezing at the oil level gauge. If this occurs, pressure inside the transmission case will increase and push out the rear oil seal, causing transmission oil leakage. The lack of lubrication can burn the internal components of the transmission, cause the transmission to seize and the vehicle to come to a sudden stop.
NHTSA · United StatesMar 23, 199494V052000Model years 1990–1992View details →
The electronically controlled motor pump power steering system may malfunction, causing intermittent loss of power steering assist and requiring varying degrees of increased steering effort.
NHTSA · United StatesNov 12, 199191V193000Model years 1988–1991View details →
Non-compliance with c.M.V.S.S.301-fuel system integrity. Due to insufficient spot welding adhesion,the rear bumper rail,under rear impact conditions,may break loose and move forward,damaging the fuel tank air vent hose. Thus creating the possibility of fuel leakage and the risk of vehicle fire.
Transport CanadaOct 21, 19851985114Model years 1985View details →
Excessive tolerance variation may have created a gap between the bumper bracket rail and the right front frame of the rear side member. This could result in insufficient spot welding adhesion at this location. Under rear impact conditions, bumper could break loose and damage the air vent hose. This may cause fuel to leak in access of the maximum requirement of fmvss 301. Consequence of defect: Fuel leakage caused by a rear end collision may contribute to a fire if a source of ignition is present.
NHTSA · United StatesOct 21, 198585V132000Model years 1985View details →
Note: vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland. Continuous exposure to road salt and chemicals may cause corrosion of the rear suspension inner arms which could affect the operation and control of the vehicle. Correction: Inner arms of the rear suspension will be inspected and rust proofed or replaced.
Transport CanadaMar 27, 19921992035Model years 1985–1987View details →
The electronically controlled motor pump power steering system may malfunction, resulting in intermittent loss of power assist. When power assist fails, the vehicle may be manually steered, however, since power steering assist may come back suddenly after the loss of power assist has occurred, it can conceivably lead to loss of vehicle control. Correction: Dealers will install a new modified signal controller and power controller on affected vehicles.
Transport CanadaJan 8, 19921992001Model years 1988–1990View details →
On electronically controlled automatic transmissions, the park gear disengagement mechanism, when subject to loads resulting from certain parking situations, may not release immediately into reverse gear resulting in delayed and possibly abrupt vehicle movement. This could result in possible loss of control and the risk of a vehicle crash. Correction: Transmission will be repaired with a modified parking pawl.
Transport CanadaJun 12, 19911991092Model years 1989–1990View details →
Certain vehicles do not comply with CMVSS 108 - Lighting. The resinous reflex reflectors of the front parking/side marker lamps do not meet the photometric requirements of the Standard. Correction: Front parking/side marker lamps will be replaced on affected vehicles.
Transport CanadaMar 12, 19911991043Model years 1989–1990View details →
On certain vehicles, continuous exposure to road salt and chemicals may cause corrosion of the rear suspension components, especially inner arms which could affect the operation and control of the vehicle. Correction: Rear suspension will be inspected and rust proofed or replaced. Note: Recall applies to vehicles in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland.
Transport CanadaJun 4, 19901990080Model years 1984View details →
Certain vehicles do not comply with CMVSS 1101(5)(b)(ii) - Fuel Warning Label.
Transport CanadaJul 18, 19861986080Model years 1985–1986View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).