Free to read · free account to contributeSuccessor to Anticars (2000)

Tesla Model X

2015–2026 · 35 documented defects · 3 markets

Service bulletins (TSBs) are repair instructions manufacturers send to their dealers about known problems. They are not safety recalls, but they often confirm a defect.

Model year
MarketAllNA
BulletinModerateInteriorNA

Bulletin

Certain Model S and Model X vehicles were equipped with driver airbags that do not meet internal quality standards.

NHTSA · manufacturer bulletin11018847Model years 2021View details →
BulletinModerateBrakesNA

Bulletin

Some Model S Palladium and Model X Palladium vehicles were built without a hydraulic control unit (HCU) wake-up line, and in rare circumstances, braking and stability control related alerts may appear on the instrument cluster and touchscreen during the vehicle power-on process. Such faults can typically be corrected and the affected functionality restored with a vehicle power cycle.

NHTSA · manufacturer bulletin10210723Model years 2021View details →
BulletinModerateBrakesNA

Bulletin

On certain Model S and Model X vehicles, the 2nd generation High Voltage (HV) harness between the Front Junction Box (FJB) and the front drive unit might become disconnected, which could prompt a driver alert to bring the vehicle to a safe stop, advise the driver of limited acceleration, or prevent the driver from operating the vehicle upon startup. This condition does not affect steering or braking.

NHTSA · manufacturer bulletin10163735Model years 2019View details →
BulletinModerateElectricalNA

Bulletin

On some Model X vehicles, one or both intrusion sensors may have been incorrectly installed and may not function properly.

NHTSA · manufacturer bulletin10143591Model years 2016View details →
BulletinModerateSuspensionNA

Bulletin

Some model x vehicles might have been built with incorrect front halfshafts. If full lock steering is applied while the suspension is fully extended, an incorrect halfshaft could overextend, damaging the dust boot or the constant velocity joint. This might lead to a knocking or grinding noise and/or a warning message on the instrument cluster.

NHTSA · manufacturer bulletin10081834Model years 2016View details →
BulletinModerateSuspensionNA

Bulletin

On some model x vehicles, the a/c condenser pipes might have been installed on the incorrect condenser ports. This might cause poor or no a/c cooling performance, slow supercharging, and/or noise from the condenser pipes touching the front suspension sway bar.

NHTSA · manufacturer bulletin10081832Model years 2016View details →
BulletinModerateOtherNA

Bulletin

Describes how to install the performance pedal set accessory.

NHTSA · manufacturer bulletin10081827Model years 2016View details →
BulletinMinorOtherNA

Bulletin

On certain Model S and Model X vehicles built before November 1, 2021, the vehicle may lack Bluetooth headphone hardware support for the rear touchscreen audio.

NHTSA · manufacturer bulletin11009775Model years 2021View details →
BulletinMinorBodyNA

Bulletin

On some Model X vehicles, the front roof applique and/or center spine applique may have been applied to the roof without the use of primer, which could cause the applique(s) to separate from the roof. This bulletin employs an improved inspection process which replaces the one for SB-20-12-005.

NHTSA · manufacturer bulletin11009772Model years 2016View details →
BulletinMinorBodyNA

Bulletin

On some Model X vehicles, the front roof applique and/or center spine applique may have been applied to the roof without the use of primer, which could cause the applique(s) to separate from the roof. This bulletin employs an improved inspection process which replaces the one for SB-20-12-005.

NHTSA · manufacturer bulletin11006907Model years 2016View details →
BulletinMinorOtherNA

Bulletin

On certain Model S and Model X vehicles built before November 1, 2021, the vehicle may lack Bluetooth headphone hardware support for the rear touchscreen audio.

NHTSA · manufacturer bulletin11001924Model years 2021View details →
BulletinMinorBodyNA

Bulletin

On some Model X vehicles, the front door(s) may require manual assistance to fully close the doors because the cinch actuator(s) may not have been manufactured to Tesla specifications. The cinch actuators assist with the closing of the front doors on the automatic door feature. The front doors can always be manually opened or closed.

NHTSA · manufacturer bulletin10240955Model years 2023View details →
BulletinMinorOtherNA

Bulletin

Certain Model X vehicles may have a split in the sheet metal on the LH and/or RH rear quarter inner panel(s). This condition, if present, is cosmetic in nature and does not impact the structural integrity, functionality, or safety of the vehicle.

NHTSA · manufacturer bulletin10232914Model years 2023View details →
BulletinMinorElectricalNA

Bulletin

On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the LH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.

NHTSA · manufacturer bulletin10212801Model years 2020View details →
BulletinMinorElectricalNA

Bulletin

On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the RH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.

NHTSA · manufacturer bulletin10212802Model years 2020View details →
BulletinMinorElectricalNA

Bulletin

On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the LH and RH side repeater cameras may lose electrical continuity over time, resulting in premature failure of the cameras.

NHTSA · manufacturer bulletin10210726Model years 2020View details →
BulletinMinorOtherNA

Bulletin

Certain Model X vehicles were shipped with key fobs that were incorrectly manufactured. These key fobs are able to pair with the vehicle, but their functionality (e.g., press-to-unlock, passive locking and unlocking, etc.) might be impaired.

NHTSA · manufacturer bulletin10210725Model years 2022View details →
BulletinMinorElectricalNA

Bulletin

On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the LH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.

NHTSA · manufacturer bulletin10208326Model years 2020View details →
BulletinMinorElectricalNA

Bulletin

On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the RH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.

NHTSA · manufacturer bulletin10208327Model years 2020View details →
BulletinMinorBodyNA

Bulletin

Certain Model X vehicles were manufactured with triple camera windshield brackets that were not properly secured to the windshield. The bracket may look uneven and/or move when manipulated. However, there is no effect on Autopilot functionality or rear view mirror stability.

NHTSA · manufacturer bulletin10194274Model years 2018View details →
BulletinMinorElectricalNA

Bulletin

Certain Model 3, Model S, and Model X vehicles were equipped with 2nd generation Universal Mobile Connector (UMC) inline units having a proximity circuit resistor that is out of specification. This resistor within the affected UMC inline unit might prevent charging, might interrupt charging while in progress, and might affect the functionality of the UMC charge handle button when disconnecting the charge handle from the vehicle charge port.

NHTSA · manufacturer bulletin10172381Model years 2019View details →
BulletinMinorBodyNA

Bulletin

Inspect Front Door Fixed Glass Seals

NHTSA · manufacturer bulletin10194343Model years 2016View details →
BulletinMinorBodyNA

Bulletin

The rear node of some Model S and Model X vehicles might have damage in the forward mounting location of the rear subframe, resulting in noise, vibration, or harshness coming from that location.

NHTSA · manufacturer bulletin10154503Model years 2018View details →
BulletinMinorBodyNA

Bulletin

Early front door latches are susceptible to water ingress, which might cause the touchscreen to show the door in the wrong position or prevent the door from opening and closing automatically. The door can still be opened with the inside handle.

NHTSA · manufacturer bulletin10154507Model years 2016View details →
Older →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).