Free to read · free account to contributeSuccessor to Anticars (2000)

Toyota Corolla AE86

1983–1987 · 3 documented defects · 2 markets

This file gathers the known defects of the Toyota Corolla AE86, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.

Most serious reported defects

See all (3) →
m
CriticalOtherNA

Defogger fires (US safety investigation)

NHTSA, the US road safety agency, opened a preliminary evaluation (PE88059) into this problem on 13 June 1988 for 1987 models; it was closed on 14 September 1988 without a recall.

✓ Mecafile analysis of official data1987View details →

Latest official recalls

See all (2) →
RecallModerateEngineNA

Vehicle speed control

Cruise control computer malfunction could occur upon shutting off the control after continuous use followed by cold ambient temperatures.

NHTSA · United StatesFeb 28, 199090V040000Model years 1984View details →
RecallModerateElectricalNA

Electrical system:Alternator/generator/regulator

Voltage regulator which controls the amount of flow in the electrical system between the battery and the alternator, may have manufacturing errors in an integrated circuit. The regulator may overcharge the battery.

NHTSA · United StatesDec 8, 198383V133000Model years 1984View details →

Latest service bulletins

See all (16) →
BulletinModerateGearboxNA

Bulletin

Toyota Genuine Oil Seal Side Lip Grease is used when installing/removing the drive shaft to prevent: ? The intrusion of water, dust, etc. ? Improvement of sealing performance ? Reduction of sliding resistance

NHTSA · manufacturer bulletin10234321View details →
BulletinModerateBodyNA

Bulletin

TSB: TMNA Accessory Sales and Marketing has developed a Toyota paint protection film (PPF) decal (treated with a specially developed light adhesive) for 2021 model year Toyota vehicles. The decal comes in two sizes (2.8 in. x 8 in. and 4 in. x 8 in.) for small and large hoods and will be applied to the top of PPF for all series at TLS accessory installation facilities. The decal is intended to stay affixed to the film until delivery detail/wash. Just before customer delivery, follow the Removal Procedure in this bulletin to remove the decal and any residue left by the adhesive.

NHTSA · manufacturer bulletin10173973View details →
BulletinMinorSuspensionNA

Bulletin

TSB: During the manufacturing process, tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. Refer to the Tire Positioning Procedure in this bulletin to ensure that the original tires stay in the same location on the vehicle.

NHTSA · manufacturer bulletin10173975View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).