Free to read · free account to contributeSuccessor to Anticars (2000)

Toyota Corona III

1976–1980 · 0 documented defects · 2 markets

This file gathers the known defects of the Toyota Corona III, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.

Most serious reported defects

No defect documented for this selection yet.

Latest official recalls

See all (3) →
RecallMinorEngineNA

Recall

1980 celica, corona and pickup trucks. In incomplete emission control label may cause the ignition timing to be misadjusted. Thus vehicles do not comploy with cmvss 1101 - emission devices.

Transport CanadaFeb 27, 19811981030Model years 1980View details →
RecallModerateBodyNA

Recall

The engine alternator pulley may break while the engine is operating. This condition could result in damage to underhood components or injury to service personnel.

Transport CanadaApr 17, 19801980058Model years 1980View details →
RecallModerateElectricalNA

Electrical system:Alternator/generator/regulator

Due to a faulty press die used in manufacturing alternator pulleys, pulleys installed on certain vehicles may crack and break during vehicle operation. The battery would then be constantly drained without recharging.

NHTSA · United StatesApr 11, 198080V045000Model years 1980View details →

Latest service bulletins

See all (11) →
BulletinModerateGearboxNA

Bulletin

Toyota Genuine Oil Seal Side Lip Grease is used when installing/removing the drive shaft to prevent: ? The intrusion of water, dust, etc. ? Improvement of sealing performance ? Reduction of sliding resistance

NHTSA · manufacturer bulletin10234321View details →
BulletinMinorOtherNA

Bulletin

Safety Recall and Service Campaign - Technician Certification Requirements

NHTSA · manufacturer bulletin10173972View details →
BulletinModerateBodyNA

Bulletin

TSB: TMNA Accessory Sales and Marketing has developed a Toyota paint protection film (PPF) decal (treated with a specially developed light adhesive) for 2021 model year Toyota vehicles. The decal comes in two sizes (2.8 in. x 8 in. and 4 in. x 8 in.) for small and large hoods and will be applied to the top of PPF for all series at TLS accessory installation facilities. The decal is intended to stay affixed to the film until delivery detail/wash. Just before customer delivery, follow the Removal Procedure in this bulletin to remove the decal and any residue left by the adhesive.

NHTSA · manufacturer bulletin10173973View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).