This file gathers the known defects of the Toyota Kluger II, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.
Most serious reported defects
No defect documented for this selection yet.
RecallModerateInteriorJP
For replacement-repair front seat belts equipped with force limiters (※), the shaft inside the retractor mechanism may have been improperly manufactured and controlled, resulting in some units with defective shapes. Therefore, when the force limiter activates to protect occupants in a collision, the amount of belt payout may increase, which could weaken the occupant restraint force.
(※) Force limiter: A device that reduces the impact on the occupant's chest by keeping the restraining force of the seat belt at a constant level during a collision and gradually loosening the seat belt.
RecallMinorOtherJP
ハイブリッドシステムの電力変換器(DC-ACインバータ)において、モータを制御する回路上または発電機を制御する回路上の素子間にばらつきがあると、素子温度が上昇して放熱用半田の許容温度を超え、放熱用半田および素子が損傷することがある。そのため、警告表示が出て走行不能となることがある。最悪の場合、高電圧系統の電流が制御系回路に流れ、電源回路のヒューズが切れて警告表示が出ることなく走行不能となるおそれがある。
RecallCriticalOtherJP
In vehicles fitted with the washer fluid anti-freeze heater offered as a dealer option, the O-ring used to waterproof the heater control circuit unit has insufficient compression (squeeze). As a result, washer fluid may seep into the control circuit. This can cause the control circuit to melt from overheating and, in the worst case, may lead to a fire.
Latest service bulletins
No service bulletin found for this model.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).