This file gathers the known defects of the Toyota RAV4 II, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.
Owners often report problems with transmission and drivetrain on this car (811 complaints), but no one has explained the cause yet. Do you know it?Write it up
Owners often report problems with electrical system on this car (211 complaints), but no one has explained the cause yet. Do you know it?Write it up
211 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2000–2005), typically at around 97,000 miles. Reported consequences: 3 crashes, 10 fires, 1 injury.
✓ Mecafile analysis of official data2000–2005View details →
152 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2000–2005), typically at around 50,000 miles. Reported consequences: 52 crashes, 12 fires, 58 injuries.
✓ Mecafile analysis of official data2000–2005View details →
127 owners in the United States reported problems with the accelerator and cruise control of this car to NHTSA (model years 2000–2005), typically at around 84,000 miles. Reported consequences: 33 crashes, 16 injuries, 2 deaths.
✓ Mecafile analysis of official data2000–2005View details →
The subject front seat belt assemblies are service parts designed for certain Toyota and Lexus models containing a seat belt retractor with a force-limiter function using a torsion shaft which helps control the loads on the occupant applied by the shoulder belt after the seat belt retractor locks up during a crash. During production the torsion shaft may have been manufactured incorrectly and the seat belt may not operate as designed allowing the seat belt to extend further than intended after locking. This can increase the amount of forward displacement of the occupant increasing the risk of an injury in the event of a crash severe enough to activate a force-limiter.
DVSA · United KingdomJan 23, 2023R/2022/326Model years 2003–2004View details →
Les rétracteurs de ceinture de sécurité peuvent ne pas fonctionner correctement, lorsque le limiteur de force peut permettre à la ceinture de sécurité de s’étendre plus que prévu. cela peut à son tour augmenter la quantité de mouvement vers l’avant de l’occupant, augmentant le risque de blessure, en cas d’accident.
EU Safety Gate · RappelConso · FranceNov 25, 2022a12/01663/22Model years 2001–2004Shown in the original French · translation pendingView details →
Issue: This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. Note: This recall only affects the following block heater/cord part numbers: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903 Safety Risk: Engine block heater wiring that overheats or melts could create the risk of a fire. Corrective Actions: Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater.
Transport CanadaNov 24, 20212021723Model years 2001–2005View details →
Toyota Genuine Oil Seal Side Lip Grease is used when installing/removing the drive shaft to prevent: ? The intrusion of water, dust, etc. ? Improvement of sealing performance ? Reduction of sliding resistance
TSB: TMNA Accessory Sales and Marketing has developed a Toyota paint protection film (PPF) decal (treated with a specially developed light adhesive) for 2021 model year Toyota vehicles. The decal comes in two sizes (2.8 in. x 8 in. and 4 in. x 8 in.) for small and large hoods and will be applied to the top of PPF for all series at TLS accessory installation facilities. The decal is intended to stay affixed to the film until delivery detail/wash. Just before customer delivery, follow the Removal Procedure in this bulletin to remove the decal and any residue left by the adhesive.
TSB: During the manufacturing process, tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. Refer to the Tire Positioning Procedure in this bulletin to ensure that the original tires stay in the same location on the vehicle.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).