Free to read · free account to contributeSuccessor to Anticars (2000)

Toyota Tercel I

1978–1982 · 2 documented defects · 2 markets

This file gathers the known defects of the Toyota Tercel I, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.

Most serious reported defects

See all (2) →

Latest official recalls

See all (2) →
RecallModerateSuspensionNA

Suspension:Rear

The lower control arms, which support the rear wheels, are subject to corrosion if operated in areas where a large amount of road salt is used to aid in snow and ice removal. Consequence of defect: Continuous exposure to road salt may cause corrosion failure of the lower control arm affecting vehicle operation; this could result in loss of control and an accident.

NHTSA · United StatesMar 10, 198686V038000Model years 1980–1982View details →
RecallModerateSuspensionNA

Suspension

Vehicles located ontario, quebec and the maritime provinces. In areas of high corrosion, the rear control arm that supports the rear wheel may rust. Should the vehicle continue to be driven under severe environmental conditions the rusting will progress and the control arms could deform thereby adversely affecting vehicle operation.

Transport CanadaApr 30, 19851985051Model years 1980–1982View details →

Latest service bulletins

See all (12) →
BulletinModerateGearboxNA

Bulletin

Toyota Genuine Oil Seal Side Lip Grease is used when installing/removing the drive shaft to prevent: ? The intrusion of water, dust, etc. ? Improvement of sealing performance ? Reduction of sliding resistance

NHTSA · manufacturer bulletin10234321View details →
BulletinModerateBodyNA

Bulletin

TSB: TMNA Accessory Sales and Marketing has developed a Toyota paint protection film (PPF) decal (treated with a specially developed light adhesive) for 2021 model year Toyota vehicles. The decal comes in two sizes (2.8 in. x 8 in. and 4 in. x 8 in.) for small and large hoods and will be applied to the top of PPF for all series at TLS accessory installation facilities. The decal is intended to stay affixed to the film until delivery detail/wash. Just before customer delivery, follow the Removal Procedure in this bulletin to remove the decal and any residue left by the adhesive.

NHTSA · manufacturer bulletin10173973View details →
BulletinMinorSuspensionNA

Bulletin

TSB: During the manufacturing process, tires are mounted on the vehicle as matched sets to help reduce conditions such as pulling or drifting. If the wheels are replaced or refinished before vehicle delivery, it is important that the tires remain on the vehicle in the same location and in the same direction of rotation. Refer to the Tire Positioning Procedure in this bulletin to ensure that the original tires stay in the same location on the vehicle.

NHTSA · manufacturer bulletin10173975View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).