Vauxhall Fuel Pipe
On affected vehicles there there may be loose connections between a high-pressure fuel pipe and the engine fuel rail which potentially could lead to a leak and risk of fire.
🔔 Create a free account to get email alerts about Vauxhall Nova (all generations)
On affected vehicles there there may be loose connections between a high-pressure fuel pipe and the engine fuel rail which potentially could lead to a leak and risk of fire.
On affected vehicles the passenger front airbag may not deploy properly in the event of a collision.
Possible unexpected side airbag deployment due to insufficient electrical grounding.
A roof side rail air bag may not deploy as intended
There is the possibility of water penetration into the vent hose resulting in water ingress into the vacuum pump over the wire harness and into the relay box. In the worst case a short circuit may lead to a risk of fire.
null Water can penetrate into the connector of the relay box located on the electronic vacuum pump causing a short circuit which could lead to a fire.
Water ingress to the relay on the electrical vacuum pump may cause a short. In extreme instances this may lead to fire.
The gears within the steering rack may not have been manufactured to the correct specification which may allow them to crack over a period of time. Prolonged use could cause loss of steering control.
Moisture can ingress and accumulate inside the ABS control unit. Excessive accumulation of moisture may cause a fire.
A small number of steering knuckles on hub swivels have been manufactured incorrectly. In time these knuckles might fail with the attendant loss of directional control of the vehicle.
THE MANUFACTURER HAS RECOMMENDED THAT AFFECTED VEHICLES ARE NOT DRIVEN UNTIL CHECKED BY THEIR OFFICIAL AGENTS. The steering system may not have been produced according to specification. There is a risk that the steering intermediate shaft may break while driving resulting in the loss of steering control.
There could be an unexpected loss of braking performance due to the ABS/ESP Modulator not being correctly filled with hydraulic oil at the factory.
It has been identified that due to a manufacturing deviation the base material for the telescopic tube of the intermediate steering shaft may lack the required rigidity. This may lead to breakage of the shaft which in the worst case would lead to loss of steering control.
It is possible for moisture to enter the ABS connector/control unit. This can cause the ABS system not to function correctly and in the worst case overheating which may lead to fire.
It has been identified that the above vehicles could be affected by moisture ingress at the ABS connector. The moisture can enter through the ground wiring connection which can lead to the ABS not functioning correctly overheating within the connector and in extreme cases a fire.
Child seat safety cradle with transponder may not interact as intended with front passenger smart Airbag deactivation function. Software concern with control unit.
Under certain conditions the engine wiring harness may touch the bonnet hinge. With prolonged chafing this may lead to a possible electrical short circuit and if not dealt with eventual combustion.
On affected vehicles the Lane Keep Assist tell-tale fails to illuminate if the front camera is blocked meaning no warning light appears in the instrument cluster.
Affected vehicles may have been assembled with contact or with a reduced clearance between the Gasoline Particulate Filter pipe and the pole protection cap of the 48V Belt Starter Generator. There is a possibility of contact between these components leading to water infiltration and an electrical arch which could trigger a thermal event.
Affected vehicles may have incorrect or missing tyre pressure messages displayed in the instrument cluster due to a software deviation.
Affected vehicles have been fitted with the wrong Autonomous Telematic Box. This means it cannot connect to the remoter server making it impossible to make E-Calls or use Intelligent Speed Assistance.
Vehicles may be affected by incorrect performance of the On-Board-Diagnostics related to Selective Catalytic Reduction system and/or Diesel Particle Filter. The Malfunction Indicator Light (MIL) may not illuminate in the event of a malfunction and therefore does not comply with emission regulations.
On affected vehicles the Autonomous Telematics Box (ATB) has no connectivity to the Connected Services features and therefore does not comply with regulatory requirements.
On affected vehicles the Electronic Brake System Module is not according to specification which could potentially lead to light internal leakage of brake fluid.
Affected vehicles may face an error in the Battery Monitoring Unit software.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).