Lectura libre · cuenta gratuita para colaborarSucesor de Anticars (2000)

IsuzuIsuzu Ascender

2002–2008 · 1 generaciones · 7 averías documentadas · 1 mercados
Generaciones
Todas las generacionesAscender2002–200871250

Los boletines técnicos (TSB) son instrucciones de reparación que los fabricantes envían a sus concesionarios sobre problemas conocidos. No son llamadas a revisión de seguridad, pero a menudo confirman una avería.

Año del modelo
MercadoTodosNA
BoletínModeradoCarroceríaNA

Boletín

Isuzu diesel engines available in the above affected vehicles meet the california air resource board's (carb) optional idling emissions standard of 30 grams per hour of oxides of nitrogen (nox) with no increase in the emission of other regulated pollutants. As a result these vehicles have been approved as "certified clean idle" and are "exempt" from the engine shutdown system (ess) requiremnet pursuant ot section 1956.8 of title 13, california code of regulations. As required by the ess regulation, for "certificed clean idle" vehicles, isuzu has introduced a tamper resistance "certified clean idle" label located on the driver's side door panel. It is important that this label remain, permanently, on the vehicle to identify it as "certified clean idle." carb requires this label as evidence that, at hte time of manufacture, the engine installed met the applicable emission standards. Should the label be found missing or damged during an inspection, a citation and penalties may be issued. If the vehicle is operated in california with a damaged or missing clean idle label, isuzu recommends vehicle operators follow the 5 minute ess requirement by manually turning off the engine. Following this ess requiremnet will keep the vehicle operation compliant until a replacement label can be installed. "clean air idle" labels are printed with a serial number and registered to an individual vin. As a result, a replacemnet label will also include a new serial number which must be registered to the vehicle's vin by the manufacturer. The below information is provided to assit in acquiring, replacing and registering a replacement label.

NHTSA · boletín del fabricante10178754Años modelo 2009Mostrado en inglés original · traducción pendienteVer detalles →
BoletínModeradoCaja de cambiosNA

Boletín

This Preliminary Information communication provides information to the technician with the axel setup information from American Axle Manufacturing. Technician should be advised that the maximum pinion shim to be used or stacked behind the pinion is 0.050?, and the minimum pinion shim is 0.020? for an 8.6 axle. The range for available pinion depth shims for the 10.5? axle is 0.006? to 0.024?. When setting the backlash it should be set between 0.003? to 0.005? on a new ring and pinion for any American Axle Manufacturing application. The ring and pinion can be reused or adjusted if the mileage is less than 500 miles, if not used for towing. Technician should be advised that a ?roller coaster? or ?hourglass? pattern on the bearings may be normal up to 10,000 miles and possibly longer. With a mis-machined housing you may get a heel pattern on both sides of the gear teeth at build up can generally be corrected with backlash adjustments. When setting up an 8.6? axle with a 5 cut gear set is to use a 0.035? pinion shim and set backlash to 0.004?. When using the newer 2 cut gear set also use a 0.035? pinion shim and still set backlash to 0.004?. To set the gear pattern use backlash to adjust the pattern heel to toe. Use the pinion shim to adjust the height of the pattern. The proper drive pinion bearing pre-load is from 15 - 30 inch pounds with new bearings. The total torque to turn after the differential case is installed should increase 5 - 10 inch pounds at the pinion. A new pinion nut must be used whenever the old one is removed. The axle shaft end play specification is 0.012? per side and the radial specification is 0.002? - 0.003?. Technician should be advised that synthetic lube can be used in all new American Axle Manufacturing axle assemblies. The new pinion seal for the 8.6? axle assembly is a two piece design.

NHTSA · boletín del fabricante10112600Años modelo 2004Mostrado en inglés original · traducción pendienteVer detalles →
BoletínModeradoHabitáculoNA

Boletín

Airbag light on, passenger airbag status indicator reads off, dtc b0092. *kb

NHTSA · boletín del fabricante10022540Años modelo 2007Mostrado en inglés original · traducción pendienteVer detalles →
BoletínModeradoCaja de cambiosNA

Boletín

4l60-e automatic transmission fluid leak from oil pump or bell housing area. *kb

NHTSA · boletín del fabricante10020537Años modelo 2006Mostrado en inglés original · traducción pendienteVer detalles →
BoletínModeradoSuspensiónNA

Boletín

Revised steering wheel replacement procedure (service manual revision). *tt

NHTSA · boletín del fabricante10006663Años modelo 2003Mostrado en inglés original · traducción pendienteVer detalles →
BoletínModeradoOtroNA

Boletín

Intermittent hesitation, stumble or idle stall after soak, harsh 1-2 shift, slipping 1-2 shift followed by a harsh engagement. *tt

NHTSA · boletín del fabricante10006094Años modelo 2003Mostrado en inglés original · traducción pendienteVer detalles →
BoletínModeradoSuspensiónNA

Boletín

Procedimiento revisado para el reemplazo del volante. *tt

NHTSA · boletín del fabricante10005165Años modelo 2003Traducido automáticamente · original: inglésVer detalles →
BoletínModeradoSuspensiónNA

Boletín

Squeak noise coming from the steering column while turning the steering wheel. *tt

NHTSA · boletín del fabricante10001769Años modelo 2003Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveOtroNA

Boletín

Policies and procedures update for all commercial vehicles. This bulletin provides instructions with regard to the Isuzu Commercial Vehicle (CV) Warranty Parts Center on the topics of parts retention, parts preparation for shipping, and administration.

NHTSA · boletín del fabricante10243651Años modelo 2009Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveElectrónicaNA

Boletín

This technical bulletin provides a procedure to clear the codes and re-evaluate the XM radio channels to correct a condition of audio muting when listening to some Sirius XM channels but if they change channels they will find others that experience normal audio. This could be due to interference from transmitting sources outside of Sirius XM?s frequency range.

NHTSA · boletín del fabricante10139099Años modelo 2009Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveOtroNA

Boletín

Este boletín informativo es una revisión del 10-00-89-005B para agregar el año modelo 2014 y los códigos de mano de obra.

NHTSA · boletín del fabricante10139026Años modelo 2008Traducido automáticamente · original: inglésVer detalles →
BoletínLeveElectrónicaNA

Boletín

This technical bulletin provides a procedure to clear the codes and re-evaluate the XM radio channels to correct a condition of audio muting when listening to some Sirius XM channels but if they change channels they will find others that experience normal audio. This could be due to interference from transmitting sources outside of Sirius XM?s frequency range.

NHTSA · boletín del fabricante10135290Años modelo 2009Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveOtroNA

Boletín

Este boletín informativo ofrece información sobre el mantenimiento de los componentes situados cerca de los componentes del SIR y sobre cómo desactivar correctamente el sistema SIR para realizar reparaciones en o cerca de

NHTSA · boletín del fabricante10116912Años modelo 2009Traducido automáticamente · original: inglésVer detalles →
BoletínLeveMotorNA

Boletín

This informational bulletin provides dealership personnel with information on flexible fuel vehicles (FFVs) and the usage of E85 fuel in GM vehicles.

NHTSA · boletín del fabricante10113662Años modelo 2003Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveMotorNA

Boletín

Isuzu: 2008 ascender. It may develop a crack in the exhaust manifold which will cause increased exhaust noise. *rm

NHTSA · boletín del fabricante10041391Años modelo 2008Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveElectrónicaNA

Boletín

Izuzu: 2006 ascender. The malfunction light won't turn on when there is a fault in the air injector system. *rm

NHTSA · boletín del fabricante10039116Años modelo 2006Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveOtroNA

Boletín

Pass-thru programming only for 2008 model year. *nj

NHTSA · boletín del fabricante10022919Años modelo 2008Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveOtroNA

Boletín

Product enhancement for inventory and customer vehicles - obd system improvement. *kb

NHTSA · boletín del fabricante10022538Años modelo 2006Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveCaja de cambiosNA

Boletín

Malfunction indicator lamp (mil) on, diagnostic trouble code (dtc) p0894, harsh 1-2 shift with 4l60-e auto transmission. *kb

NHTSA · boletín del fabricante10021354Años modelo 2006Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveElectrónicaNA

Boletín

Service update for inventory and customer vehicles fuel sending unit port fracture-extended starts/sluggish acceleration/check engine light-expires with base warranty. *kb

NHTSA · boletín del fabricante10021202Años modelo 2007Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveMotorNA

Boletín

Reduced engine power mil illuminated. *kb

NHTSA · boletín del fabricante10021196Años modelo 2006Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveElectrónicaNA

Boletín

Malfunction indicator lamp illuminated with engine cooling fan system performance dtc p0483 currently set or stored in history. *kb

NHTSA · boletín del fabricante10020538Años modelo 2007Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveCaja de cambiosNA

Boletín

Product enhancement for inventory vehicles only engine/powertrain control module reprogram. *kb

NHTSA · boletín del fabricante10020535Años modelo 2007Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveCaja de cambiosNA

Boletín

Oil life monitoring system - powertrain control module (pcm) reset. *tt

NHTSA · boletín del fabricante10016591Años modelo 2004Mostrado en inglés original · traducción pendienteVer detalles →
BoletínLeveElectrónicaNA

Boletín

Onstar system inoperative onstar system status light is red radio locked in phone mode or dtc b1000. *eh

NHTSA · boletín del fabricante10014832Años modelo 2003Mostrado en inglés original · traducción pendienteVer detalles →
Anteriores →

Fuentes: NHTSA (Estados Unidos, dominio público), Transport Canada (Licencia de Gobierno Abierto – Canadá), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso y Safety Gate de la UE (Francia, Licence Ouverte 2.0), MLIT (Japón, Licencia de Datos Públicos 1.0) y MOLIT (Corea del Sur, car.go.kr).