Lectura libre · cuenta gratuita para colaborarSucesor de Anticars (2000)

Mazda CX-9

2006–2023 · 2 generaciones · 19 averías documentadas · 5 mercados
Generaciones

Los boletines técnicos (TSB) son instrucciones de reparación que los fabricantes envían a sus concesionarios sobre problemas conocidos. No son llamadas a revisión de seguridad, pero a menudo confirman una avería.

Año del modelo
CX-9 I · 2006–2015
BoletínModeradoHabitáculoNA

Boletín

Passenger fAirbag deactivation (PAD) indicator light illumination

NHTSA · boletín del fabricante10213417Años modelo 2007Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 I · 2006–2015
BoletínModeradoHabitáculoNA

Boletín

Mazda: Information provided regarding the indicator light illumination of the passenger airbag deactivation (pad). *pe

NHTSA · boletín del fabricante10054788Años modelo 2007Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 I · 2006–2015
BoletínModeradoHabitáculoNA

Boletín

Mazda: On some vehicles, when a power plug with improper fabrication (such as a phone charger) is inserted into either of the accessory sockets (center and/or rear), the air bag warning light may illuminate. *pe

NHTSA · boletín del fabricante10029184Años modelo 2007Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Some vehicles may exhibit an occasional rough idle accompanied with DTC P0300:00 (Random misfire) due to the following: 1. While closing the EGR valve, carbon deposit etc. pinched at the valve seat prevents the valve from closing completely. 2. The closed position of the EGR valve is learned improperly as it is not equipped with a position sensor. 3. While idling, the EGR gas improperly mixes in fresh air through the EGR valve that is not closed properly. 4. Misfire occurs. To eliminate this concern, the control software of the PCM has been modified to force the learning of the closed position of the EGR valve when a misfire is detected at idle

NHTSA · boletín del fabricante10186694Años modelo 2018Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Due to a vehicle side logic change for the vehicles listed above, the seat warming and seat ventilation systems will no longer automatically turn on when the vehicle is started using the MMS accessory. Both features will now require a manual setting every time the vehicles are restarted after being turned off. Refer to the vehicle owners manual for more details on proper seat warmer/seat ventilation operation.

NHTSA · boletín del fabricante10170940Años modelo 2019Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

2ND Row seat walk-in and recline lever usage

NHTSA · boletín del fabricante10186923Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Third row seat head restraint is not upright - Some customers may complain about one or both third row seat head restraint(s) cannot be moved to the upright position, This may caused by improper fold position of the head restraint(s) when the seat back is folded down.

NHTSA · boletín del fabricante10186914Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Second-row seat walk-in lever does not work. On some vehicles, The second-row seat back does not fold (B) or slide forward when the walk-in lever (A) is pulled up to access to the 3rd row seats. This concern may be caused by a disconnected walk-in lever cable. The design of the walk-in lever has been changed to reduce to force applied to the cable. Customer havingt this concern should have their vehicle repaired using the following repair procedure.

NHTSA · boletín del fabricante10186255Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

TAKATA recalls for Air bag

NHTSA · boletín del fabricante10185837Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Third row seat head restraint is not upright

NHTSA · boletín del fabricante10185838Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Stopper plates for air bag module connectors have been established as new service parts

NHTSA · boletín del fabricante10185817Años modelo 2017Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Excessive operating noise when sliding front power seat(s)

NHTSA · boletín del fabricante10185808Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

All models - Stopper plates for air bag module coinnectors

NHTSA · boletín del fabricante10185810Años modelo 2017Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Algunos clientes pueden quejarse de que los calefactores de asientos no se encienden al volver a arrancar el motor si estaban encendidos cuando se apagó el motor. La lógica ha cambiado respecto a los Mazda anteriores, en los que los calefactores de asientos se encendían automáticamente al volver a arrancar el motor. Es más probable que los clientes en climas fríos se quejen de esto si su vehículo está equipado con Mazda Mobile Start (MMS), ya que las instrucciones de los accesorios de MMS indican que los calefactores de asientos SE ENCENDERÁN al volver a arrancar el motor. Esta información es incorrecta para estos vehículos. NOTA: Las instrucciones del manual del propietario del vehículo son correctas.

NHTSA · boletín del fabricante10154459Años modelo 2019Traducido automáticamente · original: inglésVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Some vehicles may exhibit excessive operating noise when sliding the driver and/or passenger power seat(s) back and forth. The noise may be caused by cable vibration, which transmits power from the motor to the gears. The cable vibrates inside the cable casing due to inadequately wrapped fabric around the cable. To eliminate this concern, the power seat cable has been changed to a type that produces less friction and noise.

NHTSA · boletín del fabricante10143977Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Some vehicles may exhibit excessive operating noise when sliding the driver and/or passenger power seat(s) back and forth. The noise may be caused by cable vibration, which transmits power from the motor to the gears. The cable vibrates inside the cable casing due to inadequately wrapped fabric around the cable. To eliminate this concern, the power seat cable has been changed to a type that produces less friction and noise.

NHTSA · boletín del fabricante10129574Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Some customers may complain that the tachometer display in the Active Driving Display cannot be turned off using the MAZDA CONNECT setting menu since it has been removed by a CMU update. The concerns will be noticed after a CMU update from versions 58 to version 59. This is caused by the seat position memory control module storing the active driving display indication position, brightness level, and display information at the same time when the seat position is programmed. If the setting for the tachometer display was left ?ON? for the programmed position before the CMU update, the position memory control module still remembers the status and therefore the tachometer display remains.

NHTSA · boletín del fabricante10120368Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Some vehicles may exhibit the driver and/or passenger side seat cushion trim coming out of the side cover, causing a poor appearance concern. This is due to the seat trim edge being cut too short. To eliminate this concern, the configuration of the seat trim will be improved.

NHTSA · boletín del fabricante10091811Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

If you encounter a 2016 cx-9 signature trim level vehicle (with nappa leather interior) where the front seat trim is loose / poor appearance, refer to the attached repair procedure to fix the vehicle. This concern may occur on either the driver and/or passenger side seat.Temporary countermeasure: Adhesive was applied to back of leather trim as of may 19, 2016 mass-production.Final countermeasure: A seat cushion trim edge shape change will be incorporated around aug. 1, 2016 mass-production.

NHTSA · boletín del fabricante10091626Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Some vehicles may exhibit the driver and/or passenger side seat cushion trim coming out of the side cover, causing a poor appearance concern. This is due to the seat trim edge being cut too short. To eliminate this concern, the configuration of the seat trim will be improved.

NHTSA · boletín del fabricante10085441Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 II (2013) · 2016–2023
BoletínLeveHabitáculoNA

Boletín

Some customers may complain about one or both third row seat head restraint(s) cannot be moved to the upright position. This may be caused by improper fold position of the head restraint(s) when the seat back is folded down.

NHTSA · boletín del fabricante10085284Años modelo 2016Mostrado en inglés original · traducción pendienteVer detalles →
CX-9 I · 2006–2015
BoletínLeveHabitáculoNA

Boletín

Seat belt retainer breaks. *nj

NHTSA · boletín del fabricante10024080Años modelo 2007Mostrado en inglés original · traducción pendienteVer detalles →

Fuentes: NHTSA (Estados Unidos, dominio público), Transport Canada (Licencia de Gobierno Abierto – Canadá), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso y Safety Gate de la UE (Francia, Licence Ouverte 2.0), MLIT (Japón, Licencia de Datos Públicos 1.0) y MOLIT (Corea del Sur, car.go.kr).