La conduite de carburant diesel est trop proche du faisceau de câblage, ce qui peut causer le frottement de la conduite de carburant contre les fils et l'usure. cela peut entraîner une fuite de carburant sous la voiture, créant un risque d'incendie.
Safety Gate · UE · RappelConso · Francia10 ene 2025a11/00094/24Años modelo 2014Mostrado en francés original · traducción pendienteVer detalles →
The strap of the diesel filter may brake causing the diesel filter to disconcert from its holder. Possibility of a noise in the engine compartment and in extreme cases fuel leakage.
DVSA · Reino Unido21 nov 2017R/2017/312Mostrado en inglés original · traducción pendienteVer detalles →
En los vehículos afectados, la bomba de vacío del freno puede fallar en su accionamiento. Esto puede provocar una pérdida de la asistencia del servofreno y un pedal de freno duro. También puede provocar una reducción de la potencia del motor.
DVSA · Reino Unido8 ene 2016R/2016/001Traducido automáticamente · original: inglésVer detalles →
The prop shaft to axle flange bolts may not be tightened to the correct torque. The condition could develop noise and vibration and if not corrected loss of drive.
DVSA · Reino Unido8 abr 2014R/2014/042Años modelo 2010–2013Mostrado en inglés original · traducción pendienteVer detalles →
The prop shaft to axle flange bolts may not be tightened to the correct torque. The condition could develop noise and vibration and if not corrected loss of drive.
DVSA · Reino Unido1 abr 2014R/2014/056Mostrado en inglés original · traducción pendienteVer detalles →
It is possible that the rear wheel bearing has been damaged whilst it was assembled onto the stub axle. This should be identified by excessive noise however in the worst case if not detected it could result in bearing failure and the detachment of the wheel and hub.
DVSA · Reino Unido17 ago 2011R/2011/102Años modelo 2010Mostrado en inglés original · traducción pendienteVer detalles →
It is possible that the rear wheel bearing was damaged whilst it was assembled onto the stub axle. This could result in bearing failure and the detachment of the wheel and hub.
DVSA · Reino Unido1 ago 2011R/2011/121Mostrado en inglés original · traducción pendienteVer detalles →
It is possible that the rear wheel bearing was damaged whilst it was assembled onto the stub axle. This could result in bearing failure and the detachment of the wheel and hub.
DVSA · Reino Unido1 ago 2011R/2011/122Mostrado en inglés original · traducción pendienteVer detalles →
The spare wheel carrier winch system may allow the spare wheel to be loosely installed after the customer has used the winch. In this condition the spare wheel might move during driving which may damage and eventually break the cable and guiding pin of the winch system. In this worst case the spare wheel would become detached from the vehicle.
DVSA · Reino Unido5 jul 2011R/2011/074Años modelo 2010Mostrado en inglés original · traducción pendienteVer detalles →
The spare wheel carrier winch system may allow the spare wheel to be loosely installed after the customer has used the winch. In this condition the spare wheel might move during driving which may damage and eventually break the cable and guiding pin of the winch system. In this worst case the spare wheel would become detached from the vehicle.
DVSA · Reino Unido1 jul 2011R/2011/101Mostrado en inglés original · traducción pendienteVer detalles →
null There is a risk of loss of traction, due to the loss of the fixing bolts for the connection between the longitudinal transmission and the rear axle.
Safety Gate · UE22 abr 2014A12/0614/14Años modelo 2007–2013Mostrado en inglés original · traducción pendienteVer detalles →
There is a risk that the nearside rear axle spindle may crack which in the most serious cases will lead to the spindle breaking which dependent on loading could make directional control difficult to maintain.
DVSA · Reino Unido1 nov 2010R/2010/167Años modelo 2010Mostrado en inglés original · traducción pendienteVer detalles →
Because of a manufacturing error the nearside rear stub axle could start to develop cracks at the inner radius which could eventually lead to failure of the stub axle and difficulty in maintaining directional control.
DVSA · Reino Unido1 nov 2010R/2010/191Mostrado en inglés original · traducción pendienteVer detalles →
It has been found that some of the front seat mounting brackets have not been correctly fitted to the seats. The front seat mountings could fail if the fitting brackets have been incorrectly fitted. Vehicle control could be affected.
DVSA · Reino Unido28 oct 2010R/2010/168Años modelo 2010Mostrado en inglés original · traducción pendienteVer detalles →
The seat belt positioning may be incorrect due to the front seat brackets not being to specification. This could affect the seat security and seat belt performance if an accident occurs.
DVSA · Reino Unido30 sept 2010R/2010/139Mostrado en inglés original · traducción pendienteVer detalles →
It is possible that the rear caliper handbrake lever to crack and weaken. In the worst case there is a possibility that the parking brake cables will release.
DVSA · Reino Unido30 ago 2006R/2006/123Años modelo 2005–2006Mostrado en inglés original · traducción pendienteVer detalles →
The engine may stall at idle and/or when lifting off the throttle following a period of hard acceleration.
DVSA · Reino Unido22 jul 2002R/2002/083Años modelo 2000–2001Mostrado en inglés original · traducción pendienteVer detalles →
Fuentes: NHTSA (Estados Unidos, dominio público), Transport Canada (Licencia de Gobierno Abierto – Canadá), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso y Safety Gate de la UE (Francia, Licence Ouverte 2.0), MLIT (Japón, Licencia de Datos Públicos 1.0) y MOLIT (Corea del Sur, car.go.kr).