Lecture libre · compte gratuit pour contribuerSuccesseur d’Anticars (2000)

Audi A3

1996– · 7 générations · 44 défauts documentés · 6 marchés
Générations

Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.

Année modèle
MarchéTousNA
A3 S3 (8Y) · 2020–
BulletinModéréMoteurNA

Bulletin

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge. Updated criteria and engine cover part number

NHTSA · bulletin constructeur11022660Années modèle 2024Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 S3 (8Y) · 2020–
BulletinModéréMoteurNA

Bulletin

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge. Updated criteria and engine cover part number

NHTSA · bulletin constructeur11022658Années modèle 2024Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 S3 (8Y) · 2020–
BulletinModéréMoteurNA

Bulletin

This Pending Service Solution (PSS) requests that technicains create a PSS Record in instances where the engine does not start sporadically.

NHTSA · bulletin constructeur11009955Années modèle 2024Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 S3 (8Y) · 2020–
BulletinModéréMoteurNA

Bulletin

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge.

NHTSA · bulletin constructeur10247146Années modèle 2024Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 S3 (8Y) · 2020–
BulletinModéréMoteurNA

Bulletin

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge.

NHTSA · bulletin constructeur10247145Années modèle 2024Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinModéréMoteurNA

Bulletin

On-Hoist Inspection Section: Removed "Perform a coolant reservoir cap pressure test via ELSA -> Enter VIN # -> Repair manual Engine -> 4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine (Generation III) -> 19 Cooling System -> Coolant System/Coolant -> Cooling System, Checking for Leaks -> Pressure Relief Valve in Cap, Checking. Only the procedure ?Pressure Relief Valve in Cap, Checking? should be performed in the document Cooling System, Checking for Leaks

NHTSA · bulletin constructeur10120803Années modèle 2017Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinModéréMoteurNA

Bulletin

Supersedes Technical Service Bulletin Group 87 number 14-56 dated September 12, 2014. The air conditioning does not cool, or the cooling performance is very weak. The air conditioning system cools, but the compressor is noisy. The noise is characterized as a grinding or groaning noise. Either symptom may be intermittent . No DTCs are stored. The condition may be caused by a faulty N280 valve. The internal components of the valve can be obstructed and incapable of full function. This loss of refrigerant regulation from N280 can cause noise from the A/C compressor and/or affect the HVAC cooling. The Denso A/C compressor is currently being installed in production. An improved N280 valve for the Sanden A/C compressor is in development, as the installation of Sanden compressors for production will resume in the future.

NHTSA · bulletin constructeur10119951Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinModéréMoteurNA

Bulletin

Supersedes Technical Service Bulletin Group 10 number 13-10 dated September 5, 2013. Prior to engine replacement, any debris lodged in transferred assemblies must be removed. If the engine experienced a serious mechanical problem, it is possible that small pieces of metal debris resulting from the mechanical problem may have become deposited in the intake manifold, air intake hoses, exhaust manifolds, exhaust down-pipes, turbocharger, supercharger, and/or intercooler. If these metal debris pieces are not removed prior to the installation and operation of the replacement engine, they could be drawn into the combustion chamber, which can cause a knocking noise and subsequent serious engine damage.

NHTSA · bulletin constructeur10119945Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinModéréMoteurNA

Bulletin

The MIL is on due to a Fuel Rail/System Pressure Too Low DTC stored in the ECM. Drivability concerns such as hard starting/no starting are present. Fuel pump may be making a straining noise. Outside temperature is sub-freezing. This issue is related to the diesel fuel and not a technical problem with the vehicle.

NHTSA · bulletin constructeur10119854Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinModéréMoteurNA

Bulletin

This bulletin describes the service for a vehicle that intermittently does not start or the engine is not performing.

NHTSA · bulletin constructeur10094666Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinModéréMoteurNA

Bulletin

Supersedes Technical Service Bulletin Group 01 number 13-86 dated April 15, 2013. The MIL is on. There is a rough idle. DTCs are stored in the ECM. Engine may have reduced performance without significant loss of power or stalling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.

NHTSA · bulletin constructeur10122184Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinModéréMoteurNA

Bulletin

Supersedes Technical Service Bulletin Group 01 number 14-59 dated January 21, 2014. The MIL is on. DTC may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise.

NHTSA · bulletin constructeur10122183Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinModéréMoteurNA

Bulletin

Supersedes Technical Service Bulletin Group 01 number 14-55 dated January 8, 2014. The MIL is on. DTC P0087 may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise.

NHTSA · bulletin constructeur10122180Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinModéréMoteurNA

Bulletin

The MIL is on. DTC P0087 may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20 F (-7 C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No. 2 Diesel is blended by refineries to various levels of winterization (minimum useable temperature) based on month, geographical location, and the 10th percentile minimum ambient air temperature for the given region. Although rare, during sudden periods of extreme low temperatures (record lows), fuel stations may not be adequately prepared with No. 2 Diesel fuel with sufficient winterization to resist wax formation or ?gelling?.

NHTSA · bulletin constructeur10122176Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 II · 2003–2013
BulletinModéréMoteurNA

Bulletin

Audi: Mil on; no start or rough running (dtc p0087-rail fuel pressure too low). Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Rust or metallic debris found in the fuel system indicates a major component failure. *pe updated on 6/14/2011. *kb

NHTSA · bulletin constructeur10034751Années modèle 2010Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinMineurMoteurNA

Bulletin

This bulletin provides information when the engine is not runing smoothly; all gas engines.

NHTSA · bulletin constructeur11039252Années modèle 2018Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinMineurMoteurNA

Bulletin

This bulletin provides information when DTC B105A1A, B103E25 is stored in 0017; fuel tank level implausible.

NHTSA · bulletin constructeur11035829Années modèle 2018Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinMineurMoteurNA

Bulletin

This bulletin provides information when DTC B105A1A, B103E25 is stored in 0017; fuel tank level implausible.

NHTSA · bulletin constructeur11035828Années modèle 2018Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinMineurMoteurNA

Bulletin

This bulletin provides information when the DTC P218100 malfunction in cooling system is logged.

NHTSA · bulletin constructeur11002998Années modèle 2019Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinMineurMoteurNA

Bulletin

This bulletin provides information when the DTC P218100 malfunction in cooling system is logged.

NHTSA · bulletin constructeur11002929Années modèle 2019Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinMineurMoteurNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.

NHTSA · bulletin constructeur10228295Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 II · 2003–2013
BulletinMineurMoteurNA

Bulletin

Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems.

NHTSA · bulletin constructeur10228356Années modèle 2010Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinMineurMoteurNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.

NHTSA · bulletin constructeur10224974Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 II · 2003–2013
BulletinMineurMoteurNA

Bulletin

Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems.

NHTSA · bulletin constructeur10225035Années modèle 2010Affiché en anglais d’origine · traduction en attenteVoir le détail →
A3 III · 2012–2020
BulletinMineurMoteurNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.

NHTSA · bulletin constructeur10221947Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
Plus anciens →

Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).