Lecture libre · compte gratuit pour contribuerSuccesseur d’Anticars (2000)

Audi RS7

2013– · 1 générations · 2 défauts documentés · 2 marchés
Générations
Toutes les générationsRS72013–245729

Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.

Année modèle
MarchéTousNA
BulletinModéréMoteurNA

Bulletin

Ce bulletin fournit des informations lorsqu’il y a une fuite sur le trou d’huile entre la planétaire et la boîte de transfert.

NHTSA · bulletin constructeur11034705Années modèle 2016Traduit automatiquement · original : anglaisVoir le détail →
BulletinModéréMoteurNA

Bulletin

This TSB provides information when thee is an oil leak from, or near the oil filter housing.

NHTSA · bulletin constructeur11021471Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

A small amount of dry or crusted coolant is seen on the coolant pump housing (Figure 1, Figure 2, and Figure 3). The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.

NHTSA · bulletin constructeur10216674Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

This bulletin contains repair instructions for when there is an oil leak from the rear of the vehicle and the sealing caps are missing from the pressure limiting valves.

NHTSA · bulletin constructeur10210738Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.

NHTSA · bulletin constructeur10210233Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.

NHTSA · bulletin constructeur10206879Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

There is an internal defect in the EVAP leak detection pump causing false leak detection.

NHTSA · bulletin constructeur10205901Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

This bulletin contains repair instructions for when there is an oil leak from the rear of the vehicle and the sealing caps are missing from the pressure limiting valves.

NHTSA · bulletin constructeur10200702Années modèle 2020–2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

This bulletin contains instructions for using the UV additive to find engine oil leaks.

NHTSA · bulletin constructeur10186945Années modèle 2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

A small amount of dry or crusted coolant is seen on the coolant pump housing. The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.

NHTSA · bulletin constructeur10124868Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

Supersedes Technical Service Bulletin Group 10 number 10-02 dated September 14, 2010. Prior to engine replacement, any debris lodged in transferred assemblies must be removed. If the vehicle's engine experienced a serious mechanical problem, it is possible that small pieces of metal debris resulting from the mechanical problem may have become deposited in the intake manifold, air intake hoses, exhaust manifolds, exhaust down-pipes, turbocharger, supercharger, and/or intercooler. If these pieces are not removed prior to the installation and operation of the replacement engine, the pieces may be drawn into the combustion chamber, which can cause a knocking noise and subsequent serious engine damage.

NHTSA · bulletin constructeur10121324Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

This bulleti provides information when the fuel pressure is outside of tolerance, MIL is on, DTC P310B00.

NHTSA · bulletin constructeur11026291Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · bulletin constructeur10228289Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · bulletin constructeur10224968Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

This bulletin advises to replace the EVAP LD Pump if DTC P044200 or DTC P045600 are present under specific circumstances.

NHTSA · bulletin constructeur10220368Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · bulletin constructeur10221941Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.

NHTSA · bulletin constructeur10216652Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Engine oils that meet Audi Oil Quality Standards.

NHTSA · bulletin constructeur10216682Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

The crankcase breather is only connected to the bank 2 turbocharger inlet. Blow-by gases from the crankcase breather discolor the pipe (Figure 1). This is a normal condition.

NHTSA · bulletin constructeur10216704Années modèle 2013Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.

NHTSA · bulletin constructeur10214760Années modèle 2022Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

This bulletin advises how to identify and repair instances where a vehicle may stops due to a lack of fuel while the fuel gauge shows 1/4 tank or more of fuel.

NHTSA · bulletin constructeur10214456Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Engine Intake & Exhaust Valve Springs

NHTSA · bulletin constructeur10211918Années modèle 2022Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Engine Intake & Exhaust Valve Springs

NHTSA · bulletin constructeur10211917Années modèle 2022Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.

NHTSA · bulletin constructeur10212939Années modèle 2022Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

This bulletin contains repair instructions from the exhaust system at idle speed DTCs P047600, P048C00, P04A000, or P301B00 are stored in the ECM.

NHTSA · bulletin constructeur10209104Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
Plus anciens →

Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).