Lecture libre · compte gratuit pour contribuerSuccesseur d’Anticars (2000)

BMW M8

2019–2025 · 1 générations · 0 défauts documentés · 3 marchés
Générations
Toutes les générationsM82019–202528281

Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.

Année modèle
MarchéTousEUNAUK
BulletinModéréMoteurNA

Bulletin

Dans certaines situations de conduite, du liquide de refroidissement fuit sur les injecteurs de carburant du banc de cylindres (5-8).

NHTSA · bulletin constructeur11002676Années modèle 2019Traduit automatiquement · original : anglaisVoir le détail →
BulletinModéréMoteurNA

Bulletin

Under certain driving situations, coolant leaks onto the fuel injectors on cylinder bank (5-8).

NHTSA · bulletin constructeur11000498Années modèle 2019Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system(NVLD natural vacuum leak detection). For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5mm For: Model vehicles other that the ones listed above, or for EVAP faults related to a large leak, after confirming that the fuel filler cap is fitted properly, then, proceed to follow the corresponding test plan

NHTSA · bulletin constructeur10249015Années modèle 2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system (NVLD natural vacuum leak detection). For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5 mm.

NHTSA · bulletin constructeur10239602Années modèle 2019–2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Retour moteur

NHTSA · bulletin constructeur11020074Années modèle 2020Traduit automatiquement · original : anglaisVoir le détail →
BulletinMineurMoteurNA

Bulletin

One of the six engine oil pump mounting screws may not have been tightened with the correct torque.

NHTSA · bulletin constructeur11014421Années modèle 2024Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Delivery stop: Oil pump screw connection

NHTSA · bulletin constructeur11012079Années modèle 2024Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

The NVLD limited emission related warranty for defects in materials or workmanship has been extended to 15 years/150,000 miles as determined from the original in-service date

NHTSA · bulletin constructeur11012066Années modèle 2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

The quick disconnect coupling on the cylinder head coolant vent line could break at the cylinder head. This would lead to loss of coolant from the engine.

NHTSA · bulletin constructeur10214256Années modèle 2018Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Information updated about engine oil filter cap drain plug. When performing an engine oil service on vehicles equipped with a N63M, N63B or S63M engines; the ETK states to use "Set oil filter element" P/N 11 42 5 A33 C42 or P/N 11 42 5 A33 C43. The part numbers are not available at the moment.

NHTSA · bulletin constructeur10212785Années modèle 2019–2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

When performing an engine oil service on vehicles equipped with a S63M engine the ETK states to use "Setoil filter element" P/N 11 42 5 A33 C43. P/N 11 42 5 A33 C43 is a new part number that was recently created without current parts availability. Until further notice ONLY use "Set oil filter element" P/N 11 42 7 848 321.

NHTSA · bulletin constructeur10203332Années modèle 2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

On rare occasions during an engine oil service, the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing.

NHTSA · bulletin constructeur10200228Années modèle 2019–2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available.

NHTSA · bulletin constructeur10199292Années modèle 2019–2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available.

NHTSA · bulletin constructeur10198899Années modèle 2019–2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

REPLACE ALL THE IGNITION COILS: The ignition coils may not have been produced to specifications which could lead to irregular running of the engine. A manufacturing defect affecting the ignition coil insulation.

NHTSA · bulletin constructeur10186214Années modèle 2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

B58C AND B58M ENGINES ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing.

NHTSA · bulletin constructeur10176360Années modèle 2019–2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

CONNECTEDDRIVE/BMW ASSIST SYSTEM DIAGNOSIS INFORMATION: This Service Information Bulletin (Revision 7) replaces SI B84 02 14 dated May 2019. ConnectedDrive/BMW Assist features are partially or completely inoperative. This Service Information Bulletin: Is being published because vehicles are down for an extended period of time when researching system failures with ConnectedDrive or BMW Assist. Will assist you both in identifying the issue and providing technical support. CAUSE Not enough information is available for BMW NA engineers to assist the technician in diagnosing the root cause.

NHTSA · bulletin constructeur10174320Années modèle 2019–2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: This Service Information Bulletin (Revision 1) replaces SI B11 01 20 dated February 2020. On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing (1).

NHTSA · bulletin constructeur10172487Années modèle 2019–2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Delivery Stop on certain Model Year 2019 and 2020 BMW vehicles that were produced between July 20 2018 and November 2 2019. There is a possibility of contamination in the engine.

NHTSA · bulletin constructeur10169456Années modèle 2019Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

HIGH ENGINE SPEED IMMEDIATELY AFTER STARTING. In rare circumstances after the engine is started with the Start-Stop button the engine speed may immediately increase to a high constant RPM (approximately 3000 rpm).

NHTSA · bulletin constructeur10163031Années modèle 2019Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

SERVICE ACTION: CHECK COOLANT LEVEL. The filling procedure at the factory could have set the engine coolant level in the expansion tank to below the minimum level.

NHTSA · bulletin constructeur10160336Années modèle 2019Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

SERVICE ACTION: CHECK COOLANT LEVEL. The filling procedure at the factory could have set the engine coolant level in the expansion tank to below the minimum level.

NHTSA · bulletin constructeur10160253Années modèle 2019Affiché en anglais d’origine · traduction en attenteVoir le détail →

Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).