Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.
This Preliminary Information communication provides information to the technician about vehicles that may have the engine Cover Foam not installed correctly. If the foam is deformed then replace the cover. If a burning odor was found replace the cabin filter.
NHTSA · bulletin constructeur10160999Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
This Preliminary Information communication provides information to the technician about vehicles that may have the engine Cover Foam not installed correctly. If the foam is deformed then replace the cover. If a burning odor was found replace the cabin filter.
NHTSA · bulletin constructeur10114917Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
This engineering information (EI) is requesting information from technicians to perform the check list provided and contact the engineer listed in regards to Oil Leaking from Front of Engine.
NHTSA · bulletin constructeur10211090Années modèle 2019Affiché en anglais d’origine · traduction en attenteVoir le détail →
This bulletin provides information on the TOP TIER Detergent Gasoline Licensed Brands and the TOP TIER Diesel Fuel Licensed Brands that are recommended for use in all GM vehicles and the TOP TIER FUELS website URL.
NHTSA · bulletin constructeur11007095Années modèle 2018Affiché en anglais d’origine · traduction en attenteVoir le détail →
This informational bulletin explains to the tech on how to order a new fuel injector by matching the part number on the part and ordering it from the EPC.
NHTSA · bulletin constructeur10176632Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
This informational bulletin supplies infomation for identifying non-GM (Aftermarket) engine calibrations for gasoline engines using Tech 2 or GDS 2 (U.S. and Canada).
NHTSA · bulletin constructeur10138146Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
The PI was created to advise of an engineering investigation for a concern of unable to connect toOnStar Virtual Advisor when selecting "New Destination" in the OnStar menu.
NHTSA · bulletin constructeur10137722Années modèle 2018Affiché en anglais d’origine · traduction en attenteVoir le détail →
The information in this bulletin details the proper configurations for the ignition key, fob, key tags, key rings, key ring sizes and applying a QR code sticker or barcode sticker to a key fob.
NHTSA · bulletin constructeur10134592Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
This Preliminary Information communication provides information to the technician about vehicles that have unwanted engine flairs while the vehicle is at steady state speed or while the vehicle is slowing. Dealer should communicate to the customer this behavior is a normal operating characteristic of the 5ET50/MKV drive unit.
NHTSA · bulletin constructeur10114997Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
This Preliminary Information communication provides information to the technician about vehicles that may have an odor when engine is on. Dealer can inform the customer that one way of getting there quickly is to drive in Mountain Mode or high duty cycles. This will affect lifetime fuel economy initially.
NHTSA · bulletin constructeur10114915Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
This Preliminary Information communication advises the technician that the 1.5L Engine Assembly has been placed on a parts restriction through the General Motors Product Quality Center. Dealer will need to contact the General Motors Product Quality Center for further assistance.
NHTSA · bulletin constructeur10114681Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
This informational bulletin provides information on Identifying Non-GM (Aftermarket) Engine Calibrations for Gasoline Engines Using Tech 2 or GDS 2 (U.S. and Canada)
NHTSA · bulletin constructeur10112819Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
14122 - service update. This bulletin provides a service procedure to add 60 ml (2.0 oz) of polyolester (poe) refrigerant oil to the a/c compressor on certain vehicles. These vehicles were shipped with less poe refrigerant oil in the a/c compressor than specified for long-term durability. There is no short-term effect; however if operated long-term with less than the specified poe oil level, the compressor may experience accelerated wear and premature failure.
NHTSA · bulletin constructeur10093950Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
This preliminary information communication advises the technician that the engine can now be ordered through the regular gm parts process or product quality center process. The 1.5l (rpo l3a) engine exchange program has ended.
NHTSA · bulletin constructeur10083846Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
This preliminary information communication advises the technician that engineering is working on the map update and has a tentative release date around the 4th quarter of 2016 to the 1st quarter of 2017.
NHTSA · bulletin constructeur10083584Années modèle 2013Affiché en anglais d’origine · traduction en attenteVoir le détail →
This preliminary information communication advises the technician upper oil pan and lower oil pan product quality center part restriction has ended. These parts can now be ordered through the regular general motors customer care and aftersales parts process or product quality center process for required dealers.
NHTSA · bulletin constructeur10080683Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
This preliminary information communication advises the technician that the engine can now be ordered through the regular gm parts process or product quality center process. The 1.5l (rpo l3a) engine exchange program has ended.
NHTSA · bulletin constructeur10078722Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
This preliminary information communication advises the technician that engineering is working on the map update and has a tentative release date around the 4th quarter of 2016 to the 1st quarter of 2017.
NHTSA · bulletin constructeur10078676Années modèle 2013Affiché en anglais d’origine · traduction en attenteVoir le détail →
NHTSA · bulletin constructeur10247323Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).