Bulletin
Inspection de fuite de liquide de refroidissement de la pompe à eau du Hemi
🔔 Créez un compte gratuit pour recevoir les alertes e-mail sur Dodge Challenger
Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.
Inspection de fuite de liquide de refroidissement de la pompe à eau du Hemi
MIL/CEL is on with Excessive Vibration / Lack or Loss of Power / Engine Misfire.
Description de la pièce : Bloc moteur complet 5.7L Description du problème : Cet ensemble bloc moteur complet 5.7L est compatible avec les applications EGR et non-EGR. Une plaque d'obturation EGR (53032739AA) doit être commandée lors de l'installation de cet ensemble bloc moteur complet sur une application non-EGR. Sauf si la plaque d'obturation EGR est transférée depuis l'ancien moteur.
Customer Satisfaction Notification T12 VECI Label The Vehicle Emission Control Information (VECI) label on about 120,000 of the above vehicles may be missing emission control information. The VECI label is often used during in-use Inspection and Maintenance (I/M) testing to verify proper emissions related components. Incorrect VECI label information could result in denial of vehicle registration for the vehicle in the state of California. A new VECI label must be installed.
Service - Joint de carter d'huile en quatre pièces Véhicules équipés Cummins UNIQUEMENT - Le joint de carter d'huile de remplacement peut être un joint en quatre pièces plutôt qu'un joint d'une seule pièce. Ceci s'applique uniquement aux moteurs Cummins 5.9L et 6.7L. Installation : 1. Nettoyer les jonctions en T du carter d'huile.~ 2. Remplir la jonction en T entre le rail du carter/boîtier d'engrenages et le rail du carter/support du joint arrière avec du mastic. Utiliser du Mopar Silicone Rubber Adhesive Sealant ou un équivalent. 3. Appliquer un cordon de 2 mm [0,063 po] de Mopar Engine Sealant RTV Silicone Rubber Adhesive sur la bride du carter d'huile.~ 4. Les quatre segments du joint doivent être assemblés pour former un joint de carter d'huile complet. 5. Poser le ou les joints de carter d'huile sur la bride du carter d'huile.~ 6. S'assurer que les jonctions des segments du joint de carter d'huile sont correctement alignées. 7. Appliquer un cordon de 2 mm [0,063 po] de Mopar Engine Sealant RTV Silicone Rubber Adhesive sur le dessus du joint de carter d'huile.~ 8. Installer le carter d'huile. En partant du centre et en progressant vers l'extérieur, serrer les boulons du carter d'huile à 28 Nm [21 pi-lb].
Replace Vehicle Emission Certification Information Label This bulletin involves replacing the Vehicle Emission Certification Information (VECI) Label.Owner may be turned away from Inspection and Maintenance (IM) station or fail IM testing because of missing emission components on VECI label. The customer may notice that some info is missing on their VECI labels.is missing. If information is shown in this area, do not replace the label.All vehicles were built with the correct emission components installed and there is no impact on emission performance or drivability.
Description de la pièce : Bloc moteur complet 5.7L Description du problème : Cet ensemble de bloc moteur complet 5.7L est compatible avec les applications avec et sans EGR. Une plaque d'obturation EGR (53032739AA) doit être commandée lors de l'installation de cet ensemble de bloc moteur complet dans une application sans EGR, sauf si la plaque d'obturation EGR est transférée depuis l'ancien moteur.
SEAL, Crankshaft Oil, Front Front crankshaft oil seal leak: For concern of front crankshaft seal leak please send an email to brenton.swank@fcagroup.com with VIN, Mileage, Photos and indicate where the leak is identified using dye such as: 1. Leak between the outer diameter of the seal to front cover? 2. Leak between the seal and damper 3. Leak through the damper bolt This will help in determining root cause and corrective action. For additional questions, please contact: Brenton Swank: Cell (248) 804-9386 or brenton.swank@fcagroup.com If no response in 15 minutes, proceed with repair.
Right Side Engine Cover Missing With Shaker Package This bulletin involves installing the right side engine cover if missing. The customer may notice the right side engine cover is missing. Only the right side engine cover was missed during vehicle assembly, the left side of the engine does not get an engine cover and is not part of this service action.
Replace Vehicle Emission Certification Information Label This bulletin involves replacing the Vehicle Emission Certification Information (VECI) Label.Owner may be turned away from Inspection and Maintenance (IM) station or fail IM testing because of missing emission components on VECI label. The customer may notice that some info is missing on their VECI labels.is missing. If information is shown in this area, do not replace the label.All vehicles were built with the correct emission components installed and there is no impact on emission performance or drivability.
"pentastar oil filter adapter before replacing this part, please call any one of the following people. Engineering is seeking information regarding this part.~ dye must be used to determine where the leak is coming from before replacing. Also please check the recently updated service bulletin number 09-008-15. ~ first: Nick morand cell (248) 410-5078 - nick.Morand@fcagroup.Com second: Bob jackson cell (248) 944-0466 - bob.Jackson@fcagroup.Com third: Joe lovell cell (734 309-6467 - joe.Lovell@fcagroup.Com if a response is not received within 15 mins, then proceed with the necessary repair."
Various vehicles are experiencing loss of oil, and possibly an oil leakage pooling in engine valley and possibly need replacing oil filter housing. Model 2014. *pe
CUSTOMER SATISFACTION NOTIFICATION NORTH AMERICA Crankshaft Damper C6C The internal crankshaft vibration damper fasteners on about 345 of the above vehicles may become loose, which can result in an engine compartment noise and damage to the front timing chain cover, which if ignored can result in engine failure.
Emission Recall 83A Sales Code Alignment
DRIER Receiver,COMPRESSOR Air Conditioning Engineering is seeking more information about AC Compressor noise issues. For the vehicle AC Compressor and Receiver Drier noise and/or no AC, call Stellantis Engineering for further instructions. Technician can contact FCA Redacted Content If there is no answer within 15 minutes, please proceed with the repair.
Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear (roller failure) on one or more cam lobes and that camshaft/lifter replacement is necessary.
Coolant Charge Air Cooler Pump Associated To Low Coolant Level or Diagnostic Trouble Codes
Loose Rear Spoiler Scat Pack Badge This bulletin involves inspecting and if necessary, replacing a separating or not adhering chrome Scat Pack badge on the rear spoiler. The customer may describe the following:The chrome letter Scat Pack badge is separating or loose, has gaps or is not adhering to the rear spoiler on the passenger side of the vehicle.
Muffler and tailpipe ? Exhaust
Tube - turbo water feed
Front Engine Cover Oil Weep This bulletin involves inspecting and replacing the right side front engine cover gasket if necessary. The customer may experience an oil weep from the right front engine cover.
Part Description: Exhaust Actuator Issue Description: Please call Jason Maltese at cell (248) 931-4179 or email him at emailjason.maltese@fcagroup.com before replacing this part. Engineering may want to visit dealers in the SE Michigan area to investigate this issue. If no answer and if you do not receive a return call within 15 minutes please continue with the normal repair.
Attention! Release Of New Engine Coolant Organic Additive Technology (OAT) Chrysler Corporation LLC. has released a new engine coolant for the 2013 model year vehicles and beyond, for all engine applications except the ones listed in the note above. This new coolant is an Organic Additive Technology (OAT) (Fig. 1). OAT coolants have a service interval of 10 years or 150,000 miles. For heavy duty truck and extreme duty cycle applications refer to the Service Information or Owner's Manual for proper maintenance schedules.
Part Description: Exhaust Actuator Issue Description: Please call Jason Maltese at cell (248) 931-4179 or email him at emailjason.maltese@fcagroup.com before replacing this part. Engineering may want to visit dealers in the SE Michigan area to investigate this issue. If no answer and if you do not receive a return call within 15 minutes please continue with the normal repair.
Before replacing this part for debris issue faults, please call the following people;~ Engineering is seeking information regarding this part.~ Bob Smith ? Cell (248) 202-9458 - Robert.M.Smith@fcagroup.com~ If a response is not received within 15 mins, then proceed with the necessary repair.~
Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).