Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.
Please be advised that the valve stem seals assigned to the 2.5 Skyactiv Turbo engines in GEPC are incorrect. The Diesel Valve Stem seal SH09-10-1F5A, which is for Diesel engines, is currently listed for these models in GEPC. Please ensure that the proper valve stem seals are used for the 2.5 Skyactiv Turbo engines affected by SSPD5 have the correct valve seal part number PY8W-10-1F5 installed on PYT engines to avoid any potential issues.
NHTSA · bulletin constructeur11000679Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
DO NOT use MDARS for CBCM configuration as it will cause other problems like ENGINE NO START. There is an error in MDARS program. This SA will be updated when there is more information.
NHTSA · bulletin constructeur10162023Années modèle 2019Affiché en anglais d’origine · traduction en attenteVoir le détail →
Some 2014 mazda3 vehicles may exhibit a tapping noise from the no. 3 engine mount when driving on rough roads. A new and improved engine mount must be installed to eliminate the noise.
NHTSA · bulletin constructeur10098305Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
We write to inform you that certain vehicles are affected by the concern mentioned below. Vehicles affected by this DRW will be visible, June 9, 2018. VIN lists for the DRW14 will be uploaded to MGSS on June 8, 2018. Parts and Warranty information and inspection/repair procedures are expected next week and will be uploaded as soon as possible. Certain subject Mazda3 vehicles may have a casting flaw in the front cover fastening bolt hole of the engine block.
NHTSA · bulletin constructeur10143958Années modèle 2018Affiché en anglais d’origine · traduction en attenteVoir le détail →
Mazda connect shuts down and does not reboot. Some vehicles may experience mazda connect infotainment system shutting down with a few minutes after ignition is turned on, and will not reboot. It will only reboot after ignition is turned off and then turned on again. This is caused by an internal malfunction of the connectivity master unit (cmu) hardware.
NHTSA · bulletin constructeur10076688Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
Mazda: Fuel inside high pressure fuel pump may be raised to higher temperature than usual, if stopped or idling 20 or more minutes due to using high evaporative winter fuel. Model 2012 mazda3. *pe updated 12/18/12. *pe updated 2/4/13. *pe
NHTSA · bulletin constructeur10048339Années modèle 2013Affiché en anglais d’origine · traduction en attenteVoir le détail →
Engine no crank along with immobilizer malfunction. Diagnostic trouble codes p1260 (immobilizer system problem) and b1600/b1602 (key id number cannot be read) and/or u2516 (ic-can bus off transmit error) may be stored in memory. Mazda m-tips. *tt
NHTSA · bulletin constructeur10009107Années modèle 2004Affiché en anglais d’origine · traduction en attenteVoir le détail →
Evaporative emissions cap and receiver adapters for testing the vehicles evaporative emissions system are now available. *tt
NHTSA · bulletin constructeur10006808Années modèle 2004Affiché en anglais d’origine · traduction en attenteVoir le détail →
Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).