Lecture libre · compte gratuit pour contribuerSuccesseur d’Anticars (2000)

Nissan Juke

2010– · 3 générations · 21 défauts documentés · 5 marchés
Générations
Toutes les générationsI2010–2019195831II2019–28III2027
Année modèle
Juke I · 2010–2019
RappelCritiqueÉlectroniqueNA

Electrical

Sur certains véhicules, le bouton « start/stop » (marche/arrêt) pourrait se coincer dans son logement en raison d'un défaut de fabrication. Si cela se produit, des vibrations pourraient faire en sorte que les composants électriques à l'intérieur du bouton entrent en contact de façon répétée et rapide, et cela pourrait activer la procédure d'arrêt d'urgence du moteur pendant que le véhicule est en mouvement. Cela pourrait augmenter l'effort à exercer sur le volant et sur la pédale de frein, causer une perte de puissance motrice et désactiver les systèmes de retenue supplémentaires (SRS), ce qui augmenterait les risques d'accident pouvant entraîner des blessures ou des dommages matériels (ou les deux). Correction : Les concessionnaires devront inspecter et réparer le bouton « start/stop » (marche/arrêt) défectueux.

Transports Canada25 juin 20152015282Années modèle 2013–2014Voir le détail →
Juke I · 2010–2019
RappelCritiqueÉlectroniqueEU

null The fuel rail pressure sensor of some vehicles may be tightened insufficiently to the fuel rail of…

null The fuel rail pressure sensor of some vehicles may be tightened insufficiently to the fuel rail of the engine and it may loosen gradually due to heat and vibration of the engine. If left undetected and the vehicle continues to be driven in this condition, in an extreme case, fuel leakage may occur between the fuel rail pressure sensor and the fuel rail.

Safety Gate · UE5 déc. 2014A12/1975/14Années modèle 2012–2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
Juke I · 2010–2019
RappelCritiqueÉlectroniqueJP

コモンレール

エンジンの燃料供給レールに取り付けている燃料圧力センサの締付けが不充分なため、エンジンの振動等により締付けが緩むものがある。そのため、燃料圧力センサの取付け部のねじを伝って燃料が漏れるおそれがある。

MLIT · Japon23 févr. 20121128970Années modèle 2010–2011Affiché en japonais d’origine · traduction en attenteVoir le détail →
Juke I · 2010–2019
RappelModéréÉlectroniqueUK

Rear oxygen sensor may fail

If an electrical short occurs in the supply to the rear oxygen sensor the senor will fail but the driver will not see an immediate warning. A MIL warning may display after continued driving depending on driving/vehicle characteristics.

DVSA · Royaume-Uni25 juil. 2016R/2016/157Années modèle 2014–2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
Juke I · 2010–2019
RappelModéréÉlectroniqueEU

null The sensor of the rear oxygen sensor might fail and does not set a Diagnostic Trouble Code (DTC) in…

null The sensor of the rear oxygen sensor might fail and does not set a Diagnostic Trouble Code (DTC) in case of inappropriate content of the exhaust gases. In such cases, the user is not warned through the Malfunction Indicator Light (MIL) on the dashboard.

Safety Gate · UE13 juil. 2016A12/0879/16Années modèle 2014–2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
Juke I · 2010–2019
RappelModéréÉlectroniqueEU

null An incorrect calibration setting in the Engine Control Module (ECM) software may cause miscalculation…

null An incorrect calibration setting in the Engine Control Module (ECM) software may cause miscalculation of sulfur oxide (SOx) levels captured within the Lean NOx Trap (LNT) component of the exhaust’s Diesel Particulate Filter (DPF). This miscalculation could, with extended operation under certain driving conditions, affect the purge process applied to remove SOx particles from the DPF-LNT. In this condition, the capacity of the DPF-LNT may become saturated and, as a result, the nitrogen oxide (NOx) emissions from the vehicle could exceed the permitted level.

Safety Gate · UE26 févr. 2016A12/0267/16Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
Juke I · 2010–2019
RappelModéréÉlectroniqueNA

Electrical system:Ignition:Switch

Nissan North America, Inc. (Nissan) is recalling certain model year 2014 Versa Sedan vehicles manufactured July 16, 2013, to January 29, 2014, 2013-2014 Cube vehicles manufactured July 3, 2013, to October 21, 2013, and 2013-2014 Juke vehicles manufactured July 3, 2013, to October 22, 2013. When exposed to hot temperatures, the affected vehicles have an engine start/stop button that may stick inside the button housing.

NHTSA · États-Unis1 juil. 201515V418000Années modèle 2013–2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
Juke I · 2010–2019
RappelModéréÉlectroniqueJP

過給機

(1)過給気導入ダクトにおいて、過給圧センサブラケット溶着部の加工が不適切なため、当該ブラケットの溶着強度が不足したものがある。そのため、そのままの状態で使用を続けると、過給圧センサブラケットが剥離して過給圧が正しく測定されず、警告灯が点灯するおそれがあり、最悪の場合、走行中にエンストし再始動できなくなるおそれがある。

MLIT · Japon8 déc. 20111128621Années modèle 2010–2011Affiché en japonais d’origine · traduction en attenteVoir le détail →

Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).