Lettura libera · account gratuito per contribuireErede di Anticars (2000)

Audi A7 I

2010–2025 · 8 difetti documentati · 2 mercati

I bollettini tecnici (TSB) sono istruzioni di riparazione che i costruttori inviano ai concessionari su problemi noti. Non sono richiami di sicurezza, ma spesso confermano un difetto.

Anno modello
MercatoTuttiNA
BollettinoModeratoMotoreNA

Bollettino

An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be lost.

NHTSA · bollettino del costruttore10228337Anni modello 2013Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

An oil filter that is too short is installed. The oil filter must be 155 mm.

NHTSA · bollettino del costruttore10228355Anni modello 2013Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be lost.

NHTSA · bollettino del costruttore10225016Anni modello 2013Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

An oil filter that is too short is installed. The oil filter must be 155 mm.

NHTSA · bollettino del costruttore10225034Anni modello 2013Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be lost.

NHTSA · bollettino del costruttore10221989Anni modello 2013Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

An oil filter that is too short is installed. The oil filter must be 155 mm.

NHTSA · bollettino del costruttore10222007Anni modello 2013Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

This bulletin contains intructions for installing the improved rubber plug and spring to correct an oil pressure warning.

NHTSA · bollettino del costruttore10128283Anni modello 2016Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

The MIL is on due to a Fuel Rail/System Pressure Too Low DTC stored in the ECM. Drivability concerns such as hard starting/no starting are present. Fuel pump may be making a straining noise. Outside temperature is sub-freezing. This issue is related to the diesel fuel and not a technical problem with the vehicle.

NHTSA · bollettino del costruttore10119854Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

Supersedes Technical Service Bulletin Group 01 number 14-69 dated March 6, 2014. The MIL is on. No start or rough running. DTCs are stored in the ECM. When diagnosing a MIL on, no-start, or rough running concern on a common rail diesel vehicle, and no root cause is found after checking all other components and following all GFF diagnostic procedures, it may be necessary to check for metallic particles in the High Pressure Fuel Pump.

NHTSA · bollettino del costruttore10122282Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

The MIL is on. No start or rough running. DTCs are stored in the ECM. When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.

NHTSA · bollettino del costruttore10122277Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

Audi: The oil filter, for some vehicles, are too short, (should be 155 (=/-1) mm long) for installation and drain flap, in oil filter housing, can not completely close causing lost of oil pressure. Model 2013 a6, a7, s4, s5, s5 cab, q7, q5. *pe

NHTSA · bollettino del costruttore10054272Anni modello 2013Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

Campagna di assistenza Audi: vedere il pulsante di ricerca nei documenti per la lettera al proprietario. In determinate condizioni la pompa del liquido di raffreddamento può perdere.

NHTSA · bollettino del costruttore10038584Anni modello 2009Tradotto automaticamente · originale: ingleseVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.

NHTSA · bollettino del costruttore10228399Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.

NHTSA · bollettino del costruttore10225078Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

When diagnosing the condition listed above on a common rail diesel vehicle, if no root cause is found after all GFF diagnostic procedures have been performed, it may be necessary to check for metallic particles in the high pressure fuel pump using the procedure in the Service section of this bulletin.

NHTSA · bollettino del costruttore10222051Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

When diagnosing a MIL on, no-start, or rough running concern on a common rail diesel vehicle, and no root cause is found after checking all other components and following all GFF diagnostic procedures, it may be necessary to check for metallic particles in the High Pressure Fuel Pump.

NHTSA · bollettino del costruttore10216612Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change significantly over the life of the engine. Typically engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owner? s Manual for specific break-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, the ambient temperature, and road conditions. Additional factors are the amount of oil dilution from water condensation or fuel residue and the oxidation level of the oil. Under certain driving conditions internal engine pressure conditions in the 3.0 TFSI engine can negatively influence the rate of oil consumption. This condition can occur while the vehicle is operated in metro driving conditions, for example: Stop and go traffic with extended idle periods.

NHTSA · bollettino del costruttore10216639Anni modello 2012Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owner?s Manual for specific break-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, the ambient temperature, and road conditions. Additional factors are the amount of oil dilution from water condensation or fuel residue, and the oxidation level of the oil. Under certain driving conditions, internal engine pressure conditions in the 3.0 TFSI engine can negatively influence the rate of oil consumption. This can occur while the vehicle is operated in city driving conditions, for example: stop and go traffic with extended idle periods.

NHTSA · bollettino del costruttore10216647Anni modello 2012Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owner?s Manual for specific break-in procedures.

NHTSA · bollettino del costruttore10216648Anni modello 2012Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

The cooling fans may operate for up to 10 minutes after the engine is turned off. This function is mapped to specific driving patterns and vehicle operating modes (for example, DPF regeneration). This is normal operation, and no parts should be replaced.

NHTSA · bollettino del costruttore10216670Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Exhaust Gas Recirculation (EGR) Cooler

NHTSA · bollettino del costruttore10164240Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Exhaust Gas Recirculation (EGR) Cooler

NHTSA · bollettino del costruttore10164237Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Added Oil Capacity Chart at the end of the document.

NHTSA · bollettino del costruttore10153110Anni modello 2017Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Major Maintenance Section: ADDED: "(except A3 e-tron)" at the end of "Cooling system - Check coolant level, add coolant if necessary, and check protection to spec -25C"

NHTSA · bollettino del costruttore10133435Anni modello 2017Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Spark Plugs: replace at 55,000 miles (85,000 km) or 6 years, whichever occurs first. Thereafter, every 60,000 miles (90,000 km) or 6 years, whichever occurs first Added: 2.0L TFSI (Q3) For 35/75/115 Mile Spark Plug interval: Added Q3 to exclusion of Flex Fuel Engines.

NHTSA · bollettino del costruttore10130214Anni modello 2015Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Meno recenti →

Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).