Some engines are fitted with an additional water pump for the turbo charger. In some circumstances a crack may develop which then leads to melting of the plug connections and the housing. Further heat development may then lead to scorch damage. In exceptional cases such overheating can lead to smouldering of the water pump. If smouldering occurs an engine compartment fire and vehicle fire cannot be excluded.
DVSA · Regno Unito27 apr 2012R/2012/049Mostrato in inglese originale · traduzione in attesaVedi dettagli →
It has been identified that the lower rubber mounting on the metal bush of the rear shock absorbers may fail to meet the quality requirement. Dependant on the mileage and operating conditions the rubber mounting may come completely free from the shock absorber. If this occurs the bodywork would no longer be supported above the wheels causing it to come into contact with the wheel concerned. Should this occur the possibility exists that a critical driving condition might occur or even the risk of an accident.
DVSA · Regno Unito6 lug 2006R/2006/119Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain 325E, 325ES, 528E, 535I, 635CSI and 735I vehicles, the center high mounted brake light could add sufficient electrical load to cause the brake light switch to overheat, eventually leading to melting of the plastic internal switch parts. This could cause the switch plunger to jam in the ON or OFF position. This would render the brake light permanently ON or OFF regardless of brake pedal operation. Correction: A brake light switch with an increased current load capacity will be installed on affected vehicles.
Transport Canada27 nov 19861986134Anni modello 1986–1987Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain 533I, 633CSI and 733I, during assembly of the brake booster and master cylinder, stresses or possibly cracks in the master cylinder connecting flange may have occurred. It is possible that, during operation of the braking system, new cracks could develop and/or the existing cracks could be aggravated. This could reulst in misalignment of components and impaired brake function.
Transport Canada25 gen 19841984011Anni modello 1984Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The power brake booster may have been improperly machined causing stress and possibly cracks in the master cylinder where it is attached to the power brake booster.
NHTSA · Stati Uniti19 gen 198484V006000Anni modello 1984Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On the involved vehicles, the self locking nuts that connect the lower steering column shaft to the flexible coupling may not have been sufficiently tightened. These nuts can come loose.
NHTSA · Stati Uniti9 dic 198282V122000Anni modello 1983Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On some of the involved vehicles, the knurled nut, part of the rubber mount assembly which supports the differential, may have been cracked due to over-torquing of the final drive attaching bolt. This bolt may become loose, and continued operation may cause it to fall out.
NHTSA · Stati Uniti2 nov 198282V108000Anni modello 1982–1983Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain 528E vehicles, at very cold temperatures, when the engine is warmed up, water vapour might condense and freeze in the throttle houseing after a period of steady driving, causing ice build-up around the throttle plate. The ice may prevent the throttle plate from closing when the driver releases the accelerator pedal. Note: This recall supersedes recall V82017.
Transport Canada27 set 19821982079Anni modello 1981–1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain BMW 528E vehicles, at temperatures of -9 degrees celsius and colder and a warmed up engine, water vapour might condense and freeze in the throttle houseing after a period of steady driving, causing ice buildup around the throttle plate. The ice may prevent the throttle plate from fully closing when the driver releases the accelerator pedal.
Transport Canada2 feb 19821982017Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On the involved vehicles, under a combination of low temperature conditions and a warmed up engine, water vapor in the warm air from the crankcase housing may condense and freeze after a period of steady state driving causing ice build up around the throttle plate. The ice might prevent the throttle plate from fully closing when the driver releases the accelerator pedal, causing a slower than normal deceleration rate and an increase of the idle speed.
NHTSA · Stati Uniti28 gen 198282V010000Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).