Veicolo: determinati veicoli passeggeri, dotati di etichette dell'airbag installate sul parasole, non sono conformi allo standard federale di sicurezza dei veicoli a motore n. 208, "Protezione dei passeggeri in caso di collisione". Questi veicoli presentano un'area per i messaggi inferiore a 30 cm, che non soddisfa i requisiti dello standard.
NHTSA · Stati Uniti6 apr 200101V109000Anni modello 2000–2001Tradotto automaticamente · originale: ingleseVedi dettagli →
Vehicle description: Passenger vehicles. Some of these vehicles exhibit a condition in which the driver side impact air bag inflator separates from the air bag module during deployment.
NHTSA · Stati Uniti13 nov 200000V371000Anni modello 2000–2001Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Some of these vehicles with the key in the "on" position, exhibit a condition in which the antilock brake system (abs) motor shorts to its case and grounds through a flexible brake fluid pipe.
NHTSA · Stati Uniti9 lug 199999V170000Anni modello 1999Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Note: Vehicles located in ontario(4) and british columbia(1). These vehicles may have an under torqued right hand front spindle nut. If this nut were to fall off, the wheel could separate from the vehicle possibly resulting in a crash without prior warning. Correction: Vehicles will be inspected and if the right hand front spindle nut is under torqued, the wheel bearing assembly and nut will be replaced.
Transport Canada4 ott 19941994151Anni modello 1994Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The right hand spindle nut was not properly tightened during assembly. This can cause premature wheel bearing failure and over time, the spindle can fracture.
NHTSA · Stati Uniti4 ott 199494V189000Anni modello 1994Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The power door lock relay on these vehicles can short internally due to water intrusion. This condition may result in a vehicle fire. Correction: Power door lock relay and any corroded terminals will be replaced. In addition, the new relay will be relocated to an area where water intrusion is less likely
Transport Canada7 set 19941994141Anni modello 1994Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The power seat or recliner wiring harness can be pinched or can chafe on the seat frame or spring support rod, wearing through the wire insulation and causing an electrical short.
NHTSA · Stati Uniti1 set 199292V124000Anni modello 1990–1991Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The fuel feed hose could leak at the coupling on the engine end of the hose assembly. This condition could allow fuel to leak into the engine compartment and possibly result in an engine compartment fire. Correction: Fuel feed hose assembly will be inspected and replaced if necessary with a new hose assembly.
Transport Canada5 dic 19881988166Anni modello 1988Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Su alcuni veicoli, un allargamento eccessivo del foro pilota nel piastrone del freno posteriore potrebbe consentire la rotazione del cilindro della ruota, con possibile perdita di liquido freni dai freni posteriori e perdita della capacità di frenata posteriore. Ciò comporterebbe maggiori spazi di arresto e un possibile incidente.
Nota: solo veicoli in Ontario e Quebec.
Transport Canada28 mag 19861986056Anni modello 1980–1984Tradotto automaticamente · originale: ingleseVedi dettagli →
The generator "bat" terminal located on the rectifier end frame may contact the carburetor fuel inlet pipe. Consequence of defect: The "bat" stud may rub through the terminal boot and contact the fuel pipe which could result in an underhood fire and cause burn injuries to the occupant.
NHTSA · Stati Uniti4 ott 198585V122000Anni modello 1986Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid. Consequence of defect: A loss of brake fluid leads to loss of rear brake action, creating the potential for an accident. Front brakes would remain operational.
NHTSA · Stati Uniti29 apr 198585V048000Anni modello 1980Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Sui veicoli con motori da 2.5 l. Il sistema di alimentazione del carburante può perdere in corrispondenza del collegamento del tubo di alimentazione del carburante per l'iniezione nel corpo farfallato, con il possibile rischio di incendio nel vano motore.
Transport Canada29 mar 19851985032Anni modello 1984Tradotto automaticamente · originale: ingleseVedi dettagli →
Il sistema di alimentazione del carburante potrebbe presentare una perdita in corrispondenza del raccordo del tubo di alimentazione del carburante all'iniettore del corpo farfallato. Conseguenza del difetto: questa perdita potrebbe causare un incendio nel vano motore, che potrebbe propagarsi all'abitacolo e causare ustioni agli occupanti.
NHTSA · Stati Uniti29 mar 198585V034000Anni modello 1984Tradotto automaticamente · originale: ingleseVedi dettagli →
The axle retaining "c" clip in the differential may dislodge and allow the axle, wheel and brake drum to separate from the vehicle when subjected to side forces. Axle separation could result in loss of vehicle control and possible crash.
Transport Canada11 gen 19851985010Anni modello 1980Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Le valvole dosatrici del freno possono rompersi e staccarsi dal cilindro principale durante la frenata. Ciò causerà una perdita di liquido dei freni e una perdita parziale dell'azione frenante.
Transport Canada7 ott 19841983084Anni modello 1983Tradotto automaticamente · originale: ingleseVedi dettagli →
The rear brake hoses were not fully seated into their fittings when the fittings were crimped onto the hose at the time of manufacture. Hose failure would cause loss of brake fluid and partial loss of braking action thereby increasing stopping distance.
Transport Canada26 gen 19831983009Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.
NHTSA · Stati Uniti8 mar 198282V021000Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Under certain conditions the hose clamps on the fuel filler pipe and fuel tank filler vent pipe could fracture. This could cause seepage of fuel at any one of the four pipe to hose connections when the fuel tank is above 3/4 full creating the possibility of fire.
Transport Canada3 mar 19821982026Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
"tx" heavy duty wheels may have been manufactured with laminated steel. The wheel disc may fracture and the wheel and tire could partially or completely separate from the vehicle.
NHTSA · Stati Uniti23 mar 198181V036000Anni modello 1981Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Alcuni veicoli per passeggeri non sono conformi ai requisiti dello standard federale di sicurezza dei veicoli a motore n. 108, "lampade, dispositivi riflettenti e attrezzature associate". Alcuni di questi veicoli non soddisfano i requisiti di illuminazione dei segnali sopraelevati.
NHTSA · Stati Uniti10 ago 200404V375000Anni modello 1999Tradotto automaticamente · originale: ingleseVedi dettagli →
Alcuni veicoli non sono conformi ai requisiti della CMVSS 101 - Location and Identification of Controls and Displays (Posizione e identificazione di comandi e display). I veicoli presentano una condizione in cui la "Spia di avvertimento olio" non si accende in condizioni di pressione dell'olio bassa o assente. Correzione: i concessionari eseguiranno il reflash del PCM del veicolo con il nuovo software di calibrazione.
Transport Canada12 apr 20012001094Anni modello 1998Tradotto automaticamente · originale: ingleseVedi dettagli →
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).