Lettura libera · account gratuito per contribuireErede di Anticars (2000)

Chevrolet Camaro (third generation)

1981–1992 · 24 difetti documentati · 1 mercati
Anno modello
MercatoTuttiJPNA
RichiamoCriticoMotoreJP

燃料タンク

燃料タンクの給油管接合部に溶接不良のものがあるため、燃料を一杯に給油した場合、 当該給油管接合部から燃料が漏れ、最悪の場合、火災に至るおそれがある。

MLIT · Giappone1 set 19941205330Anni modello 1990–1991Mostrato in giapponese originale · traduzione in attesaVedi dettagli →
RichiamoCriticoMotoreNA

Sistema di alimentazione

Questi veicoli potrebbero presentare crepe o "fori di spillo" nel punto di saldatura del collo di riempimento del serbatoio del carburante. Ciò potrebbe causare odore di carburante o perdite di carburante. In presenza di una fonte di accensione, la perdita di carburante dovuta a questa condizione potrebbe provocare un incendio del veicolo. Correzione: i serbatoi del carburante dei veicoli interessati saranno ispezionati per verificare la presenza di perdite e sostituiti se necessario.

Transport Canada21 apr 19941994078Anni modello 1991Tradotto automaticamente · originale: ingleseVedi dettagli →
RichiamoCriticoMotoreNA

Fuel System

Note: Vehicles equipped with 5.0 litre and 5.7 litre engines. Vehicles may have fuel return hoses which could break at either or both crimped couplings. If a coupling were to separate, fuel leakage and a possible engine compartment fire could result. Correction: A properly crimped fuel return hose will be installed on all involved vehicles.

Transport Canada11 giu 19901990084Anni modello 1990Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoCriticoMotoreNA

Fuel System

Note: Vehicles equipped with 2.8.L v6 engines. The fuel feed hoses may pull out of the crimped coupling at the engine end of the hose assembly. This could result in fuel leakage and an engine compartment fire. Correction: A redesigned fuel feed hose will be installed on all involved vehicles.

Transport Canada6 giu 19901990081Anni modello 1988–1989Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoCriticoFreniNA

Richiamo

Due to undersized grinding at the time of manufacture, the rear brake centre flex hoses could separate from the end fittings when subjected to the pull force required by cmvss 106-74. Tensile strangth test. Such a separation would result in loss of brake fluid and a partial loss of braking action. Should this happen while the vehicle is in motion, at a time when minimum stopping distances are required, a vehicle crash could occur without prior warning.

Transport Canada31 ago 19841984098Anni modello 1984Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoCriticoAbitacoloNA

Seat belts:Front:Anchorage

The involved vehicles do not conform to federal motor vehicle safety standard no. 210, "seat belt assembly anchorages". The non-compliance exists because the rear seat belt anchorages may pull through the underbody of the vehicle if enough force is applied.

NHTSA · Stati Uniti21 set 198282V089000Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoCriticoMotoreNA

Fuel system, gasoline:Storage:Tank assembly

Fuel tank ventilator valve in the fuel system may produce a loud and persistent "whistle" during venting of the tank. If the fuel filler cap is removed while this condition exists and the tank is more than 3/4 full, gasoline may be forced out of the filler neck onto bystanders.

NHTSA · Stati Uniti29 lug 198282V076000Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoCriticoMotoreNA

Fuel System

On certain Trans Am and Camaro Z28 vehicles with crossfire fuel injection engines, the fuel tank ventilator valve may produce a loud and persistant whistle during tank venting. If the fuel filler cap is removed while this condition exists and the tank is 3/4 full,gasoline may be forced out of the filler neck,creating the risk of fire.

Transport Canada22 lug 19821982061Anni modello 1982Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoAbitacoloNA

Seats:Front assembly:Recliner

The front seat upper hinge cover screws are too long, and interfere with the seat back inertia lock. This prevents the seat back from locking properly.

NHTSA · Stati Uniti3 mag 199191V074000Anni modello 1991Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoAbitacoloNA

Seats And Restraints

These vehicles may not comply with c.M.V.S.S. 209 - seat belt assemblies. - seat belt latch plates may not engage or may do so only after wiggling and/or forcing the latch plate. Correction: Vehicles will be inspected and suspect retractor side safety belt assemblies (which include latch plates) will be replaced if necessary.

Transport Canada29 apr 19911991069Anni modello 1991Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoAbitacoloNA

Seat belts:Front:Anchorage

The metal latchplates may not engage the buckle assemblies, causing a "no latch" condition. Movement of the seat occupant in this condition could cause latchplate release from the buckle.

NHTSA · Stati Uniti22 apr 199191V067000Anni modello 1991Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoFreniNA

Brakes

On certain vehicles, the parking brake system may contain a non-functional parking brake adjuster. This may result in a gradual loss of parking brake effectiveness as the rear disc pads wear. As a result, the parking brake may not hold the vehicle on a steep incline. If the vehicle is parked with the transmission in neutral or a forward gear, the vehicle may roll away and result in personal injury or property damage. Correction: A new parking brake adjuster will be installed.

Transport Canada17 apr 19911991063Anni modello 1982–1986Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoFreniNA

Parking brake:Conventional

Parking brake adjuster fails to operate and do not work after brake pad wear.

NHTSA · Stati Uniti11 apr 199191V055000Anni modello 1982–1986Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoCarrozzeriaNA

Visibility:Windshield

Poor bond adhesion between the windshield glass and the mounting, which could allow the windshield to separate from the vehicle during a collision. This fails to conform with fmvss 212.

NHTSA · Stati Uniti19 feb 199191V031000Anni modello 1991Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoAbitacoloNA

Seats And Restraints

On certain vehicles, the seat belt buckle assemblies may not latch or release due to fracture of the red push button. This would prevent a person from using his or her seat belt thereby increasing the risk of injury in the event of a sudden stop or collision. Correction: Seat belt buckles will be inspected and defective assemblies will be replaced.

Transport Canada19 giu 19901990091Anni modello 1984–1990Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoAbitacoloNA

Seat belts:Front:Buckle assembly

Plastic components of seat belt buckle assemblies do not contain an ultra violet stabilizer, and exposure to direct sunlight and elevated interior temperatures could weaken the plastic components.

NHTSA · Stati Uniti14 mag 199090V105000Anni modello 1984–1990Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoAbitacoloNA

Seat belts

Webbing on the buckle portion of the rear lap/shoulder belts may be too long.

NHTSA · Stati Uniti13 dic 198888V191000Anni modello 1989Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoAbitacoloNA

Seats And Restraints

Note: Camaro convertibles only vehicles may have been produced with rear inboard seat belts that are too long. In the event of a vehicle crash, this condition could increase the risk of injury to occupants in the rear seat positions. Correction: Both rear inboard seat belts will be replaced on involved vehicles.

Transport Canada10 nov 19881988155Anni modello 1989Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoMotoreNA

Emissions

These vehicles do not comply with c.M.V.S.S. 1105 - evaporative emissions.

Transport Canada17 ott 19881988145Anni modello 1985Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoMotoreNA

Emissions

Certain vehicles may not comply with the requirements of CMVSS 1105 - Evaporative Emissions.

Transport Canada9 mar 19881988030Anni modello 1984Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoElettronicaNA

Illuminazione esterna:Fari:Interruttore

Il commutatore dei fari a tiro-spinta può presentare contatti elettrici che consentono un circuito dei fari intermittente, causando lo sfarfallio dei fari o lo spegnimento improvviso. Conseguenza del difetto: la perdita improvvisa dei fari in condizioni meteorologiche avverse o durante la guida notturna può ridurre la visibilità del conducente, con il possibile rischio di un incidente stradale senza preavviso.

NHTSA · Stati Uniti19 set 198686V131000Anni modello 1986Tradotto automaticamente · originale: ingleseVedi dettagli →
RichiamoModeratoElettronicaNA

Lights And Instruments

On certain vehicles, the push-pull headlight switch may have been manufactured with electrical contacts which allow an intermittent headlight circuit. An intermittent circuit could cause the headlights to suddenly go out. Under severe weather or nighttime driving conditions, driver visibility could be reduced, possibly resulting in a vehicle crash.

Transport Canada6 mag 19861986051Anni modello 1986Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Meno recenti →

Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).