Electrical system:Wiring:Front underhood
Vehicle description: Light duty pickup trucks and multi-purpose vehicles. An engine electrical wiring-harness clip can melt and drip onto the exhaust manifold.
🔔 Crea un account gratuito per ricevere avvisi via e-mail su GMC Sonoma (tutte le generazioni)
Vehicle description: Light duty pickup trucks and multi-purpose vehicles. An engine electrical wiring-harness clip can melt and drip onto the exhaust manifold.
Vehicle description: Light duty pickup trucks and multi-purpose passenger vehicles. A fatigue fracture of the rear axle right-hand brake pipe can occur causing a slow brake fluid leak resulting in a soft brake pedal. If the brake pipe breaks, the driver would experience a sudden drop in the brake pedal, the instrument panel brake light would illuminate, and there would be a loss of rear brake performance.
On certain vehicles, the engine wiring harness clip could melt and drip onto the exhaust manifold. The clip material on the exhaust manifold could ignite and subsequently ignite other combustible components in the immediate vicinity resulting in a vehicle fire without prior warning. Correction: Electrical wiring harness will be rerouted.
The fuel tank filler pipes were not manufactured to specification which caused loss of fuel between the fuel tank filler pipe and the vent tube during a test. The loss of fuel was in excess of the amount permitted by fmvss no. 301, "fuel system integrity."
Use of improper primer on metal surfaces of windshield and side window openings could cause low adhesion to the metal surface and would not provide retention required by fmvss 212.
Inner tie rod to relay rod nuts on steering linkage may be iimproperly torqued and not crimped.
Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid. Consequence of defect: A loss of brake fluid leads to loss of rear brake action, creating the potential for an accident. Front brakes would remain operational.
Alcuni veicoli (non coinvolti nel richiamo 98-150) possono subire un guasto al tergicristallo a causa di giunti di saldatura crepati sulla scheda elettronica del controller. Se ciò dovesse verificarsi in condizioni meteorologiche avverse, la visibilità del conducente potrebbe risultare ridotta, con il conseguente rischio di un incidente stradale senza preavviso. Correzione: il concessionario sostituirà il motorino del tergicristallo difettoso fino a 7 anni o 112.000 km dalla data di prima immatricolazione del veicolo oppure, per i veicoli attualmente fuori da questa copertura, fino al 31 marzo 2004.
Vehicle description: Light duty pickup trucks and sport utility vehicles. These vehicles fail to comply with the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment." the daytime running lights built with a candela value greater than 3,000 cannot be mounted higher than 864mm above the road surface.
Vehicle description: Passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."
Vehicle description: Light duty pickup trucks equipped with 4-wheel disc brakes. Some of these vehicles have an antilock brake system (abs) motor containing an out-of-specification spring clip. This clip could allow the motor bearing to become misaligned. If misalignment occurs, eventually the abs would be non-functional.
Vehicle description: S -trucks equipped with 2 wheel drive. These vehicles may have had the right-hand antilock brake system (abs) module feed pipe and/or brake crossover pipe tube nuts tightened without seating the pipe-flared-ends enough to withstand normal assembly and vehicle inputs without partially unseating. This does not comply with requirements of fmvss no. 105, "hydraulic service brake normal, emergency, and park braking performance."
Vehicle description: Certain 4-wheel drive pickup trucks and sport utility vehicles equipped with abs (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the abs system whether the vehicle is in 2-wheel or 4-wheel drive can malfunction causing increased stopping distances during abs stops while in the two-wheel drive mode.
Vehicle description: Light duty pickup trucks and sport utility vehicles, 2 and 4-wheel drive. Solder joints near the wiring harness connector can crack causing the windshield wipers to work intermittently.
Certain vehicles may exhibit a fatigue fracture of the rear axle, right-hand brake pipe. Should the pipe crack a slow brake fluid leak would result causing a soft pedal and an eventual decrease in rear braking capability. Should the pipe break there would be a sudden drop in the brake pedal and a loss of rear brake performance. Correction: A brake pipe bracket will be installed on affected vehicles.
Vehicle description: Light duty passenger pickup trucks equipped with 4.3l engines. The front brake line can contact the left-hand side of the engine oil pan causing the brake line to wear to the point of brake fluid loss during brake application.
On certain vehicles, the front brake pipe may contact the left-hand side of the engine oil pan. This contact could cause the brake pipe to wear through to the point of brake fluid loss during brake application. This could reduce braking effectiveness and increase stopping distances. Correction: Vehicles will be inspected and an additional brake pipe clip will be installed if required. If there was contact between the oil pan and the brake pipe, the brake pipe will be replaced.
On certain vehicles, the driver's and/or passenger's front outboard seat-belt webbing could separate during a frontal impact having at least the same dynamics as a 48 kph frontal barrier collision. If a separation occurred and there were secondary crash events or rollover, there would be no restraint of the occupant and increased injuries could occur. Correction: A protector cover will be installed over the recliner mechanism.
Vehicle description: Extended cab pickup trucks equipped with 60/40 front bench seats and extended cab pickup trucks and 2-door utility vehicles equipped with manual locking recliner bucket seats. The outboard safety belt webbing on the driver's and/or passenger's seat can separate during a frontal impact.
Alcuni veicoli potrebbero non essere conformi alla norma CMVSS 1105 - Emissioni evaporative. Gli iniettori di carburante possono presentare perdite di vapori di carburante a causa di una sollecitazione dell'incapsulante in plastica. Correzione: gli iniettori di carburante sui veicoli interessati saranno ispezionati per verificare i codici data coinvolti e sostituiti se necessario.
On certain vehicles, the transmissions may contain parts which are not machined to specification. These transmissions could seize and lock the rear wheels while the truck is being operated. This could result in loss of vehicle control and a possible crash without prior warning. Correction: Dealers will inspect the transmission main shaft output torque and of the torque does not meet the specification criteria, the transmission will be replaced.
Some of these trucks were built with transmissions containing parts which were not machined to gm's specifications.
A vacuum hose can detach from the power brake booster check valve as a result of engine backfire.
Significant wear can develop on the low and reverse clutch preventing the park pawl from engaging. This can prevent a "no park" condition to occur while the engine is running, causing unintentional movement of the vehicle without operator action. (the "no park" condition will not occur while the engine is off.)
Certain vehicles do not comply with CMVSS.301- Fuel System Integrity. Fuel tank filler pipes may not be to specification. Thus when tested to CMVSS 301 the vehicle may leak fuel in excess of the Standard. Correction: Fuel filler pipes will be replaced.
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).