Bollettino
TT: Injector Maintenance Required message shows at approximately 6000 miles.
🔔 Crea un account gratuito per ricevere avvisi via e-mail su Lexus GS (tutte le generazioni)
I bollettini tecnici (TSB) sono istruzioni di riparazione che i costruttori inviano ai concessionari su problemi noti. Non sono richiami di sicurezza, ma spesso confermano un difetto.
TT: Injector Maintenance Required message shows at approximately 6000 miles.
TT: Injector Maintenance Required message shows at approximately 6000 miles.
Tt: Injector maintenance required message shows at approximately 6000 miles.
DL: On December 20, 2022, a settlement of claims for certain low pressure fuel pumps was approved by the federal court. The settlement includes Lexus?s agreement to provide a Customer Support Program for certain 2013-2020 model year (MY) vehicles originally equipped with low pressure fuel pumps repaired under Safety Recall 20LA01 or Special Service Campaign 21LC01. The purpose of this Customer Support Program letter is to help clarify how to administer this coverage in accordance with the settlement.
Questo serve a informare su vari aggiustamenti di prezzo che riguardano l'Olio Motore Lexus Originale e il Refrigerante a Long-Duratura, a partire dal 1° marzo 2023. Questi prodotti sono ordinati tramite il sito web Lexus Complete Maintenance Care (LCMC).
Fuel Delivery Pipe Replacement
Informazioni di riferimento incrociato su adesivi e sigillanti / Sistema ibrido del motore
Informazioni di riferimento incrociato su adesivi e sigillanti / Sistema ibrido del motore
Engine Misfire Duplication Procedure - MIL on DTC p030 and /or Intermittently Runs Rough
Engine Misfire Duplication Procedure - MIL on DTC p030 and /or Intermittently Runs Rough
Fuel Injection Active Test Remedy - 2GR-FKS and 8AR-fts
TT: The current engine active test Control the Injection Mode? is not operating as desired when controlling the direct injectors manually on 2GR-FKS engines. When direct injection is started and then stopped using the active test, current ECU logic does not turn off the direct injectors and can cause DTCs P017200, P017500 and P0160300. To avoid this condition, technicians should raise engine RPM when changing back and forth between the Direct Injection and Port Injection active tests. Use the recommended procedure below to avoid this concern while testing injection mode of FKS equipped vehicles. NOTE: If the active test is used multiple times without using this procedure to raise engine RPM, it may be necessary to reset learning values for fuel trim and Air to Fuel ratio before returning vehicle to customer.
TT: Alcuni veicoli IS250 e GS300 possono presentare una o più delle seguenti condizioni: ? MIL ?ON? DTC P0300, P0301, P0302, P0303, P0304, P0305 e/o P0306. ? Funzionamento irregolare intermittente dopo l'arresto del veicolo con il motore a temperatura di esercizio. ? Funzionamento irregolare intermittente con presenza di mancate accensioni dopo un avviamento a freddo prolungato. NOTA: le raccomandazioni contenute in questo documento si applicano a un problema di mancate accensioni intermittenti. Se un veicolo presenta una mancata accensione costante, la causa principale non è correlata ai bollettini di servizio di riferimento e per la diagnosi occorre consultare il manuale di riparazione.
TT: TMS has discovered the current engine active test ?Control the Injection Mode? is not operating as desired when controlling the direct injectors manually on 2GR-FKS or 8AR-FTS engines. When direct injection is started and then stopped using the active test, current ECU logic does not turn off the direct injectors and can cause DTCs P017200, P017500 and P0160300. In order to avoid this condition, technicians should raise engine RPM when changing from Direct Injection active test to Port Injection active test. Use the recommended procedure below to avoid this concern while testing injection mode of 2GR-FKS or 8AR-FTS equipped vehicles. NOTE: If the active test is used multiple times without using this procedure to raise engine RPM, it may be necessary to reset learning values for fuel trim and Air to Fuel ratio before returning vehicle to customer.
TSB: Some 2013 ? 2016 model year FR-S vehicles may exhibit a high pitch chirp or squeak noise from the high pressure Fuel Pump Assembly when the engine is fully warmed-up and idling. Follow the procedure in this bulletin to address this condition.
Alcuni veicoli IS250 e GS300 possono presentare una o più delle seguenti condizioni: MIL "ON" con DTC P0300, P0301, P0302, P0303, P0304, P0305 e/o P0306. Funzionamento irregolare intermittente dopo l'arresto del veicolo con il motore a temperatura di esercizio. Funzionamento irregolare intermittente con presenza di mancate accensioni dopo un avviamento a freddo prolungato.
Some IS250 and GS300 vehicles may exhibit one or more of the following conditions: MIL ?ON? DTC P0300, P0301, P0302, P0303, P0304, P0305, and/or P0306 Intermittently runs rough after coming to a stop with the engine at operating temperature Intermittently runs rough with engine misfires present after a cold soak startup
Tech Tip: Some IS250 and GS300 vehicles may exhibit one or more of the following conditions: MIL "ON" DTC P0300, P0301, P0302, P0303, P0304, P0305, and/or P0306. Intermittently runs rough after coming to a stop with the engine at operating temperature. Intermittently runs rough with engine misfires present after a cold soak startup. NOTE: The recommendations in this document apply to an intermittent misfire concern. If a vehicle exhibits a steady misfire, the root cause is not related to the referenced service bulletins and the repair manual should be referenced for diagnosis.
"tt: Tms has discovered the current engine active test control the injection mode is not operating as desired when controlling the direct injectors manually on 2gr-fks or 8ar-fts engines. When direct injection is started and then stopped using the active test, current ecu logic does not turn off the direct injectors and can cause dtcs p017200, p017500 and p0160300. In order to avoid this condition, technicians should raise engine rpm when changing from direct injection active test to port injection active test. Use the recommended procedure below to avoid this concern while testing injection mode of 2gr-fks or 8ar-fts equipped vehicles. Note: If the active test is used multiple times without using this procedure to raise engine rpm, it may be necessary to reset learning values for fuel trim and air to fuel ratio before returning vehicle to customer."
"tt: Some is250 and gs300 vehicles may exhibit one or more of the following conditions: Mil on dtc p0300, p0301, p0302, p0303, p0304, p0305, and/or p0306. Intermittently runs rough after coming to a stop with the engine at operating temperature. Intermittently runs rough with engine misfires present after a cold soak startup. Note: The recommendations in this document apply to an intermittent misfire concern. If a vehicle exhibits a steady misfire, the root cause is not related to the referenced service bulletins and the repair manual should be referenced for diagnosis."
Lexus: Is250-gs300: Engine runs rough when coming to a stop, after cold soak start up engine misfires. *lj
Lexus: Vehicle engine runs rough after coming to a stop or misfires. *pe
Lexus: Mil on dtc p030# and/or intermittently runs rough. Engine/hybrid. Engine control. Some vehicles may exhibit one or more of the following conditions. Mil on dtc p0300, p0301, p0302, p0303, p0304, p0305 and/or p0306. Runs rough after stopping with engine at operating temperature; runs rough with engine misfires after cold soak startup. *pe
Ilsac gf-4 engine oil standard. '06 lexus. *tt excluding hybrid vehicles. *tt recommendation. *tt
Repair manual correction for the engine (3uz-fe). 00245-rm112-6u1. *tt
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).