Lettura libera · account gratuito per contribuireErede di Anticars (2000)

Mazda 6

2002–2024 · 3 generazioni · 60 difetti documentati · 6 mercati
Generazioni

I bollettini tecnici (TSB) sono istruzioni di riparazione che i costruttori inviano ai concessionari su problemi noti. Non sono richiami di sicurezza, ma spesso confermano un difetto.

Anno modello
MercatoTuttiNA
6 III · 2012–2024
BollettinoModeratoMotoreNA

Bollettino

Please be advised that the valve stem seals assigned to the 2.5 Skyactiv Turbo engines in GEPC are incorrect. The Diesel Valve Stem seal SH09-10-1F5A, which is for Diesel engines, is currently listed for these models in GEPC. Please ensure that the proper valve stem seals are used for the 2.5 Skyactiv Turbo engines affected by SSPD5 have the correct valve seal part number PY8W-10-1F5 installed on PYT engines to avoid any potential issues.

NHTSA · bollettino del costruttore11000679Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoModeratoMotoreNA

Bollettino

Some vehicles may exhibit an engine no start in ambient temperatures below -4 degree fahrenheit (-20 degree celsius) after driving for 10 - 20 minutes and then parking the car for about one hour. This may be caused by the contact point of the main relay freezing due to moisture inside the main relay.

NHTSA · bollettino del costruttore10097813Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 I (GG1) · 2002–2008
BollettinoModeratoMotoreNA

Bollettino

Engine cranks but no start - sets diagnostic trouble code (dtc) p0335. *tt

NHTSA · bollettino del costruttore10003942Anni modello 2003Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · bollettino del costruttore11020037Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · bollettino del costruttore10254186Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · bollettino del costruttore10235702Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

Ignition does not turn off when pressing start/stop button

NHTSA · bollettino del costruttore10213409Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · bollettino del costruttore10210884Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

Maintenance monitor engine oil data reset

NHTSA · bollettino del costruttore10186926Anni modello 2017Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

If you receive a customer complain of lack of power, rough idle, engine noise with stored DTC's P0340:00, P0304:00, P3400:00, P349B:00, and/or P3498:00, perform the following.

NHTSA · bollettino del costruttore10153295Anni modello 2018Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

A tapping/rattling noise may be noticed from the valve train area. This condition usually occurs after the engine has been turned off at normal operating temperature and then not warmed up to full operating temperature during the next series of cold starts. This operating condition can occur, for example, on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.)

NHTSA · bollettino del costruttore10134943Anni modello 2018Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

When pressing the start/stop button, the ignition may not turn off on some vehicles equipped with a gate type at shifter. Although the shift lever is in p position and the engine shuts off normally, the ignition may stay on (in accessory mode). This concern may be caused by a worn switch unit. To eliminate this concern, the switch unit material has been changed to improve wear resistance. Modified switch units have been established as new service parts.

NHTSA · bollettino del costruttore10105637Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

Some vehicles may experience a rough idle with the mil on and dtc p0015 / p0524 stored in memory.P0015:00 - exhaust cmp timing over-retardedp0524:00 - engine oil pressure too lowthis is caused by a drop in engine oil pressure due to a piece of foreign object stuck on the oil pump pressure relief valve or ocv. The temporary entry of the foreign object triggers a mil illumination, but rough idle will not be produced until a later time.

NHTSA · bollettino del costruttore10098548Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

Some vehicles may experience a rough idle with the mil on and dtc p0015 / p0524 stored in memory. P0015:00 - exhaust cmp timing over-retarded p0524:00 - engine oil pressure too low this is caused by a drop in engine oil pressure due to a piece of foreign object stuck on the oil pump pressure relief valve or ocv. The temporary entry of the foreign object triggers a mil illumination, but rough idle will not be produced until a later time.

NHTSA · bollettino del costruttore10098209Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

Some customers may complain about an unusual noise coming from the engine compartment for about 20 sec-onds after a cold engine start. This noise is a normal engine operation for improved exhaust gas emissions. The noise does not indicate a malfunction.

NHTSA · bollettino del costruttore10097324Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

When pressing the start/stop button, the ignition may not turn off on some vehicles equipped with a gate-type at shifter. Although the shift lever is in p position and the engine shuts off normally, the ignition may stay on (in accessory mode).This concern may be caused by a worn switch unit. To eliminate this concern, the switch unit material has been changed to improve wear resistance. Modified switch units have been established as new service parts.

NHTSA · bollettino del costruttore10093141Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

There is an early and late style rear hub (d-codes 26-112 / 26-112z) as shown below. As stock is exhausted of the early hubs they will be placed in a c (component) supersession so that a new hub and any additional parts that may be needed are shipped at the same time. When gepc vin lock identifies an early part number, as with all c (component) supersessions, order that part number. Do not order a newer part later in the supersession chain. If you order the early part specified by the vin, a new part and any additional parts that may be needed will ship. If you order a newer part, just the newer part will ship. No additional parts that may be needed will ship.

NHTSA · bollettino del costruttore10092235Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

Mazda connect shuts down and does not reboot. Some vehicles may experience mazda connect infotainment system shutting down with a few minutes after ignition is turned on, and will not reboot. It will only reboot after ignition is turned off and then turned on again. This is caused by an internal malfunction of the connectivity master unit (cmu) hardware.

NHTSA · bollettino del costruttore10076688Anni modello 2016Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 III · 2012–2024
BollettinoLieveMotoreNA

Bollettino

Mazda: Due to drop in engine oil pressure, some vehicles experience a rough idle, caused by foreign object(s) stuck on ocv or oil pump pressure relief valve. Model 2012-2014 mazda3, mazda6, cx-5. *pe

NHTSA · bollettino del costruttore10056056Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 II (GH1/GH2) · 2007–2012
BollettinoLieveMotoreNA

Bollettino

Mazda: There is a rattle noise from the engine due to a stretched timing chain. *rm updated 4/18/2012. *kb

NHTSA · bollettino del costruttore10039251Anni modello 2007Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 II (GH1/GH2) · 2007–2012
BollettinoLieveMotoreNA

Bollettino

Mazda: Purge valve contact/hard rattle noise. Some vehicles may experience a rattle or a loud tick noise from the engine compartment during purge valve operation (the noise is loudest during 30%-60% duty cycle). This may be a hard contact noise caused by misalignment of the purge valve, rubber grommets, or attaching hoses forcing contact with the pcm, pcm bracket, metal bracket or an excessive valve tick noise. *pe

NHTSA · bollettino del costruttore10032668Anni modello 2009Mostrato in inglese originale · traduzione in attesaVedi dettagli →
6 I (GG1) · 2002–2008
BollettinoLieveMotoreNA

Bollettino

Accensione della spia MIL (DTC P2006), campagna di richiamo volontario per emissioni 4807H e campagna di richiamo volontario per emissioni per conformità OBD-II 4907H. *nj

NHTSA · bollettino del costruttore10023192Anni modello 2006Tradotto automaticamente · originale: ingleseVedi dettagli →
6 I (GG1) · 2002–2008
BollettinoLieveMotoreNA

Bollettino

Delayed throttle response during low speed acceleration. *tt

NHTSA · bollettino del costruttore10016873Anni modello 2005Mostrato in inglese originale · traduzione in attesaVedi dettagli →

Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).