Lettura libera · account gratuito per contribuireErede di Anticars (2000)

Mitsubishi Eclipse IV

2005–2012 · 6 difetti documentati · 3 mercati
Anno modello
MercatoTuttiNA
RichiamoCriticoMotoreNA

Other

On certain vehicles, the bracket that is the anchor point for the left rear fuel tank mounting strap may have been improperly formed during the manufacturing process. This may have caused the metal to spilt in the area where the bolt holds the fuel strap to the underside of the vehicle. In the event the tank is full of fuel and the vehicle is involved in a serious collision the bracket could break and the tank could drop down. This situation could result in a fuel leak and the possibility of a fire. Correction: Dealers will inspect and if necessary install a reinforcement cap to the fuel tank bracket.

Transport Canada10 ott 20082008374Anni modello 2006–2007Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoCriticoMotoreNA

Fuel system, gasoline:Storage:Tank assembly

Mitsubishi is recalling 45,988 my 2005-2007 endeavor, galant, eclipse coupe, and my 2007 eclipse spyder vehicles. The bracket that is the attachment point for the left rear fuel tank mounting strap may have been improperly formed during a metal stamping process. The process may have caused the metal to have a split in the area where the bolt that holds one of the two fuel tank straps to the underside of the vehicle is located. In the event the fuel tank is full and the vehicle is subject to a severe collision, the bracket may break and allow the fuel tank to drop down, possibly causing a fuel leak.

NHTSA · Stati Uniti9 set 200808V454000Anni modello 2006–2007Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoCriticoCarrozzeriaNA

Structure:Frame and members

On certain passenger vehicles, the metal forming part of the front crossmember may have been improperly stamped resulting in the metal becoming thinner in the cross-section than specified. This could, over time, result in breakage of the crossmember.

NHTSA · Stati Uniti6 set 200606V334000Anni modello 2007Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoCriticoFreniNA

Service brakes, hydraulic

Certain passenger vehicles may have been fitted with a defective brake booster assembly.

NHTSA · Stati Uniti2 giu 200505V247000Anni modello 2006Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoFreniNA

Freni di servizio, idraulici: Antibloccaggio/controllo trazione/slittamento limitato elettronico: Unità/modulo di controllo

Mitsubishi Motors North America, Inc. (MMNA) sta richiamando alcuni veicoli Eclipse degli anni modello 2006-2009 prodotti dal 20 aprile 2005 al 13 febbraio 2009 e veicoli Eclipse Spyder 2007-2009 prodotti dal 23 dicembre 2005 al 13 febbraio 2009. A causa della corrosione all'interno dell'unità del sistema frenante antibloccaggio (ABS), una o più valvole interne potrebbero bloccarsi. In un evento frenante che utilizza l'ABS, una valvola bloccata aumenterebbe la corsa del pedale del freno e ridurrebbe la capacità di frenata.

NHTSA · Stati Uniti2 giu 201515V337000Anni modello 2006–2009Tradotto automaticamente · originale: ingleseVedi dettagli →
RichiamoModeratoFreniNA

Brakes

On certain vehicles, corrosion may occur in the ABS hydraulic unit due to a reaction between the brake fluid and the surface treatment of the internal valves. If this were to occur and the ABS hydraulic unit is activated, one or more of the valves could seize. This could result in longer brake pedal travel and increased stopping distances, which may increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will flush and clean the hydraulic unit by replacing the brake fluid with higher grade (DOT4) fluid. If module valve movement is determined to be poor, the ABS hydraulic unit will be replaced.

Transport Canada22 mag 20152015219Anni modello 2006–2009Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoCambioNA

Power train:Automatic transmission

On certain vehicles equipped with automatic transmissions, the key lock cable was improperly manufactured and may not allow the cable end to lock into the floor shifter mechanism. This can result in the interlock system to become inoperative and allow the ignition key to be removed without the gearshift mechanism being placed in the park position.

NHTSA · Stati Uniti31 ott 200606V414000Anni modello 2007Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoFreniNA

Service brakes, hydraulic:Foundation components:Master cylinder

On certain passenger vehicles, one of four seals inside the master cylinder may have been installed improperly. As a result, the master cylinder may unexpectedly by-pass hydraulic braking force pressure and allow a longer than normal pedal stroke.

NHTSA · Stati Uniti27 giu 200505V299000Anni modello 2006Mostrato in inglese originale · traduzione in attesaVedi dettagli →

Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).